A molecularly imprinted photoelectrochemical sensor based on an rGO/MoSSe heterojunction for the detection of chlortetracycline.

A reduced graphene oxide/molybdenum selenosulfide (rGO/MoSSe) heterojunction was synthesized, and a molecularly imprinted photoelectrochemical sensor for the detection of chlortetracycline was prepared. MoSSe was grown in situ on rGO by a hydrothermal method to form an rGO/MoSSe heterojunction, which acts as the sensitive film of the sensor. Since rGO can promote electron transfer and effectively inhibit electron-hole recombination, it effectively reduces the recombination probability of electrons and holes and improves the photoelectric efficiency, thus enhancing the detection sensitivity of the PEC sensor. The rGO/MoSSe was immobilized on an FTO electrode, and molecularly imprinted polymers (MIPs) were prepared by electropolymerization on the rGO/MoSSe-modified FTO electrode with chlortetracycline as the template molecule and o-phenylenediamine as the functional monomer, so as to construct a molecularly imprinted photoelectrochemical (MIP-PEC) sensor. The determination of chlortetracycline was realized by the strategy of a "gate-controlled effect", and the detection range of the chlortetracycline concentration was 5.0 × 10-13-5 × 10-9 mol L-1 with a detection limit of 1.57 × 10-13 mol L-1. The sensor has been applied to the determination of chlortetracycline in animal-derived food samples.

Detection of L-cysteine in urine samples based on CdS/TiO2-modified extended-gate field-effect transistor photoelectrochemical sensor.

A novel extended-gate field-effect transistor (FET) photoelectrochemical (EGFET PEC) sensor was designed for highly sensitive detection of L-cysteine (L-Cys). TiO2 was initially modified on the ITO electrode by the sol-gel dip-coating method and calcined to produce TiO2/ITO. Then, CdS was synthesized on the TiO2 surface by hydrothermal method to obtain the CdS-TiO2 heterojunction material. CdS/TiO2/ITO was connected to the gate of the FET to obtain an EGFET PEC sensor. Under the irradiation of a xenon lamp simulating visible light, the CdS/TiO2 heterojunction composite absorbs light energy to produce photogenerated electron-hole pairs, which have strong photocatalytic oxidation activity and oxidize L-Cys covalently identified by Cd(II) through CdS covalent. These pairs generate a photovoltage that controls the current between the source and the drain to detect L-Cys. Under the optimized experimental conditions, the optical drain current (ID) of the sensor exhibited a good linear relationship with the logarithm of L-Cys in the range of 5.0 × 10-9-1.0 × 10-6 mol/L, and the detection limit was 1.3 × 10-9 mol/L (S/N = 3), which is lower than the values reported by other detection methods. Results showed that the CdS/TiO2/ITO EGFET PEC sensor revealed high sensitivity and good selectivity. The sensor has been used to determine L-Cys in urine samples.

Ti3C2@UiO-TCPP Schottky junction photoelectrochemical sensor for detecting alkaline phosphatase through the steric hindrance effect of phosphopeptide.

Alkaline phosphatase (ALP) is a major biomarker for clinical diagnosis, but detection methods of ALP are limited in sensitivity and selectivity. In this paper, a novel method for ALP determination is proposed. A photoelectrochemical (PEC) sensor was prepared by growing UiO-tetratopic tetrakis (4-carbox-yphenyl) porphyrin (TCPP) in situ between layered Ti3C2 through a one-pot hydrothermal method. The obtained Schottky heterojunction photoelectric material Ti3C2@UiO-TCPP not only has a large light absorption range but also greatly improves the efficiency of photogenerated electron hole separation and thereby enhances sensitivity for PEC detection. The phosphate group on the phosphorylated polypeptide was utilized to form a Zr-O-P bond with the zirconium ion on UiO-66, and then photocurrent decreases due to the steric hindrance effect of phosphorylated polypeptides, that is, the hindrance of electron transfer between the photoelectric material and a solution. The specific interaction between ALP and phosphorylated polypeptides shears the bond between phosphate and zirconium ion on UiO-66 in the peptides then weakens the hindrance effect and increases the photocurrent, thus realizing ALP detection. The linear range of ALP is 0.03-10,000 U·L-1, and the detection limit is 0.012 U·L-1. The method is highly sensitive and selective, and has been applied in detection of ALP in serum samples.