Graphene-Carbon-Metal Composite Film for a Flexible Heat Sink.

The heat generated from electronic devices such as light emitting diodes (LEDs), batteries, and highly integrated transistors is one of the major causes obstructing the improvement of their performance and reliability. Herein, we report a comprehensive method to dissipate the generated heat to a vast area by using the new type of graphene-carbon-metal composite film as a heat sink. The unique porous graphene-carbon-metal composite film that consists of an electrospun carbon nanofiber with arc-graphene (Arc-G) fillers and an electrochemically deposited copper (Cu) layer showed not only high electrical and thermal conductivity but also high mechanical stability. Accordingly, superior thermal management of LED devices to that of conventional Cu plates and excellent resistance stability during the repeated 10 000 bending cycles has been achieved. The heat dissipation of LEDs has been enhanced by the high heat conduction in the composite film, heat convection in the air flow, and thermal radiation at low temperature in the porous carbon structure. This result reveals that the graphene-carbon-metal composite film is one of the most promising materials for a heat sink of electronic devices in modern electronics.

Direct observation of morphological evolution of a catalyst during carbon nanotube forest growth: new insights into growth and growth termination.

In this study, we develop a new methodology for transmission electron microscopy (TEM) analysis that enables us to directly investigate the interface between carbon nanotube (CNT) arrays and the catalyst and support layers for CNT forest growth without any damage induced by a post-growth TEM sample preparation. Using this methodology, we perform in situ and ex situ TEM investigations on the evolution of the morphology of the catalyst particles and observe the catalyst particles to climb up through CNT arrays during CNT forest growth. We speculate that the lifted catalysts significantly affect the growth and growth termination of CNT forests along with Ostwald ripening and sub-surface diffusion. Thus, we propose a modified growth termination model which better explains various phenomena related to the growth and growth termination of CNT forests.

Strengthened PAN-based carbon fibers obtained by slow heating rate carbonization.

Large efforts have been made over the last 40 years to increase the mechanical strength of polyacrylonitrile (PAN)-based carbon fibers (CFs) using a variety of chemical or physical protocols. In this paper, we report a new method to increase CFs mechanical strength using a slow heating rate during the carbonization process. This new approach increases both the carbon sp(3) bonding and the number of nitrogen atoms with quaternary bonding in the hexagonal carbon network. Theoretical calculations support a crosslinking model promoted by the interstitial carbon atoms located in the graphitic interlayer spaces. The improvement in mechanical performance by a controlled crosslinking between the carbon hexagonal layers of the PAN based CFs is a new concept that can contribute further in the tailoring of CFs performance based on the understanding of their microstructure down to the atomic scale.

Crystalline structure analysis of cellulose treated with sodium hydroxide and carbon dioxide by means of X-ray diffraction and FTIR spectroscopy.

Crystalline structures of cellulose (named as Cell 1), NaOH-treated cellulose (Cell 2), and subsequent CO2-treated cellulose (Cell 2-C) were analyzed by wide-angle X-ray diffraction and FTIR spectroscopy. Transformation from cellulose I to cellulose II was observed by X-ray diffraction for Cell 2 treated with 15-20 wt% NaOH. Subsequent treatment with CO2 also transformed the Cell 2-C treated with 5-10 wt% NaOH. Many of the FTIR bands including 2901, 1431, 1282, 1236, 1202, 1165, 1032, and 897 cm(-1) were shifted to higher wave number (by 2-13 cm(-1)). However, the bands at 3352, 1373, and 983 cm(-1) were shifted to lower wave number (by 3-95 cm(-1)). In contrast to the bands at 1337, 1114, and 1058 cm(-1), the absorbances measured at 1263, 993, 897, and 668 cm(-1) were increased. The FTIR spectra of hydrogen-bonded OH stretching vibrations at around 3352 cm(-1) were resolved into three bands for cellulose I and four bands for cellulose II, assuming that all the vibration modes follow Gaussian distribution. The bands of 1 (3518 cm(-1)), 2 (3349 cm(-1)), and 3 (3195 cm(-1)) were related to the sum of valence vibration of an H-bonded OH group and an intramolecular hydrogen bond of 2-OH ...O-6, intramolecular hydrogen bond of 3-OH...O-5 and the intermolecular hydrogen bond of 6-O...HO-3', respectively. Compared with the bands of cellulose I, a new band of 4 (3115 cm(-1)) related to intermolecular hydrogen bond of 2-OH...O-2' and/or intermolecular hydrogen bond of 6-OH...O-2' in cellulose II appeared. The crystallinity index (CI) was obtained by X-ray diffraction [CI(XD)] and FTIR spectroscopy [CI(IR)]. Including absorbance ratios such as A1431,1419/A897,894 and A1263/A1202,1200, the CI(IR) was evaluated by the absorbance ratios using all the characteristic absorbances of cellulose. The CI(XD) was calculated by the method of Jayme and Knolle. In addition, X-ray diffraction curves, with and without amorphous halo correction, were resolved into portions of cellulose I and cellulose II lattice. From the ratio of the peak area, that is, peak area of cellulose I (or cellulose II)/total peak area, CI(XD) were divided into CI(XD-CI) for cellulose I and CI(XD-CII) for cellulose II. The correlation between CI(XD-CI) (or CI(XD-CII)) and CI(IR) was evaluated, and the bands at 2901 (2802), 1373 (1376), 897 (894), 1263, 668 cm(-1) were good for the internal standard (or denominator) of CI(IR), which increased the correlation coefficient. Both fraction of the absorbances showing peak shift were assigned as the alternate components of CI(IR). The crystallite size was decreased to constant value for Cell 2 treated at >or= 15 wt% NaOH. The crystallite size of Cell 2-C (cellulose II) was smaller than that of Cell 2 (cellulose I) treated at 5-10 wt% NaOH. But the crystallite size of Cell 2-C (cellulose II) was larger than that of Cell 2 (cellulose II) treated at 15-20 wt% NaOH.

Growth kinetics of white graphene (h-BN) on a planarised Ni foil surface.

The morphology of the surface and the grain orientation of metal catalysts have been considered to be two important factors for the growth of white graphene (h-BN) by chemical vapour deposition (CVD). We report a correlation between the growth rate of h-BN and the orientation of the nickel grains. The surface of the nickel (Ni) foil was first polished by electrochemical polishing (ECP) and subsequently annealed in hydrogen at atmospheric pressure to suppress the effect of the surface morphology. Atmospheric annealing with hydrogen reduced the nucleation sites of h-BN, which induced a large crystal size mainly grown from the grain boundary with few other nucleation sites in the Ni foil. A higher growth rate was observed from the Ni grains that had the {110} or {100} orientation due to their higher surface energy.

Protein-bound polysaccharide from Phellinus linteus induces G2/M phase arrest and apoptosis in SW480 human colon cancer cells.

The cytotoxic mechanism of protein-bound polysaccharide isolated from Phellinus linteus (PL, Mesima) has been investigated. PL inhibited the proliferation and colony formation of SW480 human colon cancer cells. Flow cytometry analysis showed that PL increased the populations of both apoptotic sub-G1 and G2/M phase. The result obtained from TUNEL assay corroborated apoptosis which was shown in flow cytometry. Western blot analysis suggested that PL-induced apoptosis and growth inhibition were associated with decrease in Bcl-2, increase of the release of cytochrome c, and reduced expression of cyclin B1. These results suggest that PL has a direct antitumor effect through apoptosis and cell cycle blockade in certain cancer cells.

Chemical method for improving both the electrical conductivity and mechanical properties of carbon nanotube yarn via intramolecular cross-dehydrogenative coupling.

Chemical post-treatment of the carbon nanotube fiber (CNTF) was carried out via intramolecular cross-dehydrogenative coupling (ICDC) with FeCl3 at room temperature. The Raman intensity ratio of the G band to the D band (IG/ID ratio) of CNT fiber increased from 2.3 to 4.6 after ICDC reaction. From the XPS measurements, the AC═C/AC-C ratio of the CNT fiber increased from 3.6 to 4.8. It is of keen interest that both the electrical conductivity and tensile strength of CNT yarn improved to 3.5 × 10(3) S/cm and 420 MPa, which is 180 and 200% higher than that of neat CNT yarn.

[Serum gamma-glutamyltransferase levels and the risks of impaired fasting glucose in healthy men: a 2-year follow-up].

OBJECTIVES: An increase in the serum gamma-glutamyltransferase (GGT) concentration has been regarded as a marker of alcohol drinking or liver disease. Some reports, however, have suggested that the serum GGT may be a sensitive and early biomarker for the development of prediabetes and diabetes. In this study we investigated whether serum GGT is a reliable predictor of the incident impaired fasting glucose (IFG), including diabetes. METHODS: We performed a prospective study for two years (2002-2004). We analyzed the periodic health examination data from a total of 4,711 men. The examinations were done in the years 2002 and 2004. The analyzed data included a self-questionnaire, a physical examination and the laboratory results. Both IFG and diabetes were defined as a serum fasting glucose concentration of more than 100 mg/dL and 126 mg/dL, respectively. RESULTS: A total of 738 cases (15.7%) of incident IFG and 13 cases (0.3%) of diabetes occurred. The mean serum GGT concentrations were quite different between the normal (38.0 IU) and incident IFG groups (50.3 IU), and the incident diabetes group (66.0 IU) (p <0.001). After multivariable adjustment, the relative risks for incident IFG or diabetes across the baseline GGT categories (<10th, 10th-20th, 30th-40th, 50th-60th, 70th-80th and >90th percentile) were 1.0, 1.172 (0.769-1.785), 1.107 (0.725-1.689), 1.444 (0.934-2.232), 2.061 (1.401-3.031) and 2.545 (1.784-3.631) (p-value for trend: <0.001). The risks significantly increased with increasing levels of GGT for 2 years; when comparing the increased groups (<10%, .10-20%, >20%) versus the decreased over 20% group of GGT, the risks for IFG or diabetes were 1.334 (1.002-1.776), 1.613 (1.183-2.199) and 1.399 (1.092-1.794). CONCLUSIONS: Our findings suggest that serum GGT concentrations within its normal range may be an early predictor of the development of IFG and diabetes. As serum GGT is a relatively inexpensive test and a reliable marker, it might have important implications in public health promotion.