RESUMEN
The superconducting transition temperature (TC) in a FeSe monolayer on SrTiO3 is enhanced up to 100 K (refs ,,,). High TC is also found in bulk iron chalcogenides with similar electronic structure to that of monolayer FeSe, which suggests that higher TC may be achieved through electron doping, pushing the Fermi surface (FS) topology towards leaving only electron pockets. Such an observation, however, has been limited to chalcogenides, and is in contrast to the iron pnictides, for which the maximum TC is achieved with both hole and electron pockets forming considerable FS nesting instability. Here, we report angle-resolved photoemission characterization revealing a monotonic increase of TC from 24 to 41.5 K upon surface doping on optimally doped Ba(Fe1-xCox)2As2. The doping changes the overall FS topology towards that of chalcogenides through a rigid downward band shift. Our findings suggest that higher electron doping and concomitant changes in FS topology are favourable conditions for the superconductivity, not only for iron chalcogenides, but also for iron pnictides.
RESUMEN
The nematic phase in iron based superconductors (IBSs) has attracted attention with a notion that it may provide important clue to the superconductivity. A series of angle-resolved photoemission spectroscopy (ARPES) studies were performed to understand the origin of the nematic phase. However, there is lack of ARPES study on LaFeAsO nematic phase. Here, we report the results of ARPES studies of the nematic phase in LaFeAsO. Degeneracy breaking between the [Formula: see text] and [Formula: see text] hole bands near the [Formula: see text] and M point is observed in the nematic phase. Different temperature dependent band splitting behaviors are observed at the [Formula: see text] and M points. The energy of the band splitting near the M point decreases as the temperature decreases while it has little temperature dependence near the [Formula: see text] point. The nematic nature of the band shift near the M point is confirmed through a detwin experiment using a piezo device. Since a momentum dependent splitting behavior has been observed in other iron based superconductors, our observation confirms that the behavior is a universal one among iron based superconductors.
RESUMEN
Each plane of layered ReS2 and ReSe2 materials has 1D chain structure, from which intriguing properties such as 1D character of the exciton states and linearly polarized photoluminescence originate. However, systematic studies on the 1D character of charge carriers have not been done yet. Here, we report on systematic and comparative studies on the energy-momentum dispersion relationships of layered transition metal dichalcogenides ReS2 and ReSe2 by angle resolved photoemission. We found that the valence band maximum or the minimum energy for holes is located at the high symmetric Z-point for both materials. However, the out-of-plane ([Formula: see text]) dispersion for ReSe2 (20 meV) is found to be much smaller than that of ReS2 (150 meV). We observe that the effective mass of the hole carriers along the direction perpendicular to the chain is about 4 times larger than that along the chain direction for both ReS2 and ReSe2. Remarkably, the experimentally measured hole effective mass is about twice heavier than that from first principles calculation for ReS2 although the in-plane anisotropy values from the experiment and calculations are comparable. These observation indicate that bulk ReS2 and ReSe2 are unique semiconducting transition metal dichalcogenides having strong one-dimensional characters.
RESUMEN
Direct band-gap semiconductors play the central role in optoelectronics. In this regard, monolayer (ML) MX2 (M = Mo, W; X = S, Se) has drawn increasing attention due to its novel optoelectronic properties stemming from the direct band-gap and valley degeneracy. Unfortunately, the more practically usable bulk and multilayer MX2 have indirect-gaps. It is thus highly desired to turn bulk and multilayer MX2 into direct band-gap semiconductors by controlling external parameters. Here, we report angle-resolved photoemission spectroscopy (ARPES) results from Rb dosed MoSe2 that suggest possibility for electric field induced indirect to direct band-gap transition in bulk MoSe2. The Rb concentration dependent data show detailed evolution of the band-gap, approaching a direct band-gap state. As ionized Rb layer on the surface provides a strong electric field perpendicular to the surface within a few surface layers of MoSe2, our data suggest that direct band-gap in MoSe2 can be achieved if a strong electric field is applied, which is a step towards optoelectronic application of bulk materials.