RESUMEN
The characterisation of hydrochars derived from Sargassum biomass collected along the Mexican Caribbean coast reveals their favourable morphology and chemical composition for incorporating metal ions, including Cd(II) and Pb(II). Among the synthesized materials, HCS-3, produced at 180 °C with a 2 h residence time, exhibited superior yield, specific area, carbon content, and capacity for removing Cd(II) and Pb(II). Adsorption equilibrium studies demonstrate the presence of adsorption processes during Cd(II) and Pb(II) retention on HCS-3, with adsorption capacities slightly exceeding 140 and 340 mg gâ»1, respectively. Notably, HCS-3 shows a greater affinity for Pb(II) over Cd(II) when both elements are present concurrently. The physicochemical analysis through FTIR spectroscopy, functional group analysis, point of zero charge determination, SEM/EDS, and other techniques evidenced that HCS-3 possesses favourable characteristics to serve as a heavy metal adsorbent. These findings underscore the efficacy of hydrochars from Sargassum biomass in removing heavy metals, suggesting their potential as superior adsorbents compared to traditional or novel materials, and advising its possible versatility for other pollutants. Utilizing these hydrochars could mitigate the economic and environmental impact of Sargassum biomass by repurposing it for valuable applications.
RESUMEN
This study investigated the application of adsorption with activated carbons (ACs) and photodegradation to reduce the concentration of triclosan (TCS) in aqueous solutions. Concerning adsorption, ACs (Darco, Norit, and F400) were characterised and batch experiments were performed to elucidate the effect of pH on equilibrium. The results showed that at pH = 7, the maximum adsorption capacity of TCS onto the ACs was 18.5 mg g-1 for Darco, 16.0 mg g-1 for Norit, and 15.5 mg g-1 for F400. The diffusional kinetic model allowed an adequate interpretation of the experimental data. The effective diffusivity varied and increased with the amount of TCS adsorbed, from 1.06 to 1.68 × 10-8 cm2 s-1. In the case of photodegradation, it was possible to ensure that the triclosan molecule was sensitive to UV light of 254 nm because the removal was over 80 % using UV light. The removal of TCS increased in the presence of sulfate radicals. It was possible to identify 2,4-dichlorophenol as one of the photolytic degradation products of triclosan, which does not represent an environmental hazard at low concentrations of triclosan in water. These results confirm that the use of AC Darco, Norit, and F400 and that photodegradation processes with UV light and persulfate radicals are effective in removing TCS from water, reaching concentration levels that do not constitute a risk to human health or environmental hazard. Both methods effectively eliminate pollutants with relatively easy techniques to implement.
Asunto(s)
Triclosán , Contaminantes Químicos del Agua , Humanos , Triclosán/química , Carbón Orgánico/química , Adsorción , Fotólisis , Agua , Contaminantes Químicos del Agua/análisisRESUMEN
The presence of Emerging Pollutants (EPs) on the beaches of Acapulco, Mexico, is evaluated for the first time. Samples were taken from the discharge of the wastewater treatment plant at Olvidada beach, and at three beaches that receive contributions from different streams that cross through the city in Santa Lucia Bay (SLB). Using solid phase extraction and gas chromatography/mass spectrometry, 77 EPs were identified. A semiquantitative evaluation of their concentrations were made using the relative areas of the chromatographic peaks, showing that the contamination of the beaches of SLB is mainly due to the pollutants going into the streams of the micro-basins. A statistical factor analysis of all the EPs allowed differentiation of the sampling points, reducing the number of variables, which benefits future analytical determinations in the study area. Due to the toxicological characteristics of the compounds found, their presence on public-use beaches represents a risk to human health.
Asunto(s)
Contaminantes Ambientales , Contaminantes Químicos del Agua , Humanos , México , Contaminantes Ambientales/análisis , Monitoreo del Ambiente/métodos , Playas , Ciudades , Contaminantes Químicos del Agua/análisisRESUMEN
Sargassum algae has become a major environmental issue due to its abundance in the Pacific Ocean with hundreds of tons reaching the beaches of the Mexican Caribbean every year. This generates large quantities of decomposing organic matter that have a negative impact on the region's economy and ecosystems. Sargassum valorization has turned out to be a fundamental aspect to mitigate its environmental impact. This study proposes the use and application of untreated Sargassum biomass for the decontamination of waters polluted with lead (Pb) and cadmium (Cd) through single and binary adsorption tests. Physicochemical and textural properties examined by SEM, XRD, and FT-IR elucidated that Sargassum biomass is viable to be used as a potential environmental benign adsorbent, exhibiting Cd(II) and Pb(II) adsorption capacities as high as 240 mg g-1 and 350 mg g-1, respectively, outperforming conventionally used adsorbents. This is attributed to its morphology, favorable surface charge distribution, and the presence of -OH and -COH groups. A strong affinity between the biomass and metal pollutants was evidenced by a thermodynamics study, showing a spontaneous and endothermic process. This work sets a practical route for the utilization of the Sargassum biomass, demonstrating its applicability as a potential material for heavy-metal-polluted water remediation, making a substantial contribution to a circular economy system.