One-Stop Strategy for Obtaining Controllable Sensitivity and Feasible Self-Patterning in Silver Nanowires/Elastomer Nanocomposite-Based Stretchable Ultrathin Strain Sensors.

In this study, selective photo-oxidation (SPO) is proposed as a simple, fast, and scalable one-stop strategy that enables simultaneous self-patterning and sensitivity adjustment of ultrathin stretchable strain sensors. The SPO of an elastic substrate through irradiation time-controlled ultraviolet treatment in a confined region enables precise tuning of both the surface energy and the elastic modulus. SPO induces the hydrophilization of the substrate, thereby allowing the self-patterning of silver nanowires (AgNWs). In addition, it promotes the formation of nonpermanent microcracks of AgNWs/elastomer nanocomposites under the action of strain by increasing the elastic modulus. This effect improves sensor sensitivity by suppressing the charge transport pathway. Consequently, AgNWs are directly patterned with a width of 100 µm or less on the elastic substrate, and AgNWs/elastomer-based ultrathin and stretchable strain sensors with controlled sensitivity work reliably in various operating frequencies and cyclic stretching. Sensitivity-controlled strain sensors successfully detect both small and large movements of the human hand.

Prediction of the mechanical response of cardiac alternans by using an electromechanical model of human ventricular myocytes.

PURPOSE: Although the quantitative analysis of electromechanical alternans is important, previous studies have focused on electrical alternans, and there is a lack quantitative analysis of mechanical alternans at the subcellular level according to various basic cycle lengths (BCLs). Therefore, we used the excitation-contraction (E-C) coupling model of human ventricular cells to quantitatively analyze the mechanical alternans of ventricular cells according to various BCLs. METHODS: To implement E-C coupling, we used calcium transient data, which is the output data of electrical simulation using the electrophysiological model of human ventricular myocytes, as the input data of mechanical simulation using the contractile myofilament dynamics model. Moreover, we applied various loads on ventricular cells for implementation of isotonic and isometric contraction. RESULTS: As the BCL was reduced from 1000 to 200 ms at 30 ms increments, mechanical alternans, as well as electrical alternans, were observed. At this time, the myocardial diastolic tension increased, and the contractile ATP consumption rate remained greater than zero even in the resting state. Furthermore, the time of peak tension, equivalent cell length, and contractile ATP consumption rate were all reduced. There are two tendencies that endocardial, mid-myocardial, and epicardial cells have the maximum amplitude of tension and the peak systolic tension begins to appear at a high rate under the isometric condition at a particular BCL. CONCLUSIONS: We observed mechanical alternans of ventricular myocytes as well as electrical alternans, and identified unstable conditions associated with mechanical alternans. We also determined the amount of BCL given to each ventricular cell to generate stable and high tension state in the case of isometric contraction.

Involvement of SIRT1 in hypoxic down-regulation of c-Myc and ß-catenin and hypoxic preconditioning effect of polyphenols.

SIRT1 has been found to function as a Class III deacetylase that affects the acetylation status of histones and other important cellular nonhistone proteins involved in various cellular pathways including stress responses and apoptosis. In this study, we investigated the role of SIRT1 signaling in the hypoxic down-regulations of c-Myc and ß-catenin and hypoxic preconditioning effect of the red wine polyphenols such as piceatannol, myricetin, quercetin and resveratrol. We found that the expression of SIRT1 was significantly increased in hypoxia-exposed or hypoxic preconditioned HepG2 cells, which was closely associated with the up-regulation of HIF-1α and down-regulation of c-Myc and ß-catenin expression via deacetylation of these proteins. In addition, blockade of SIRT1 activation using siRNA or amurensin G, a new potent SIRT1 inhibitor, abolished hypoxia-induced HIF-1α expression but increased c-Myc and ß-catenin expression. SIRT1 was also found to stabilize HIF-1α protein and destabilize c-Myc, ß-catenin and PHD2 under hypoxia. We also found that myricetin, quercetin, piceatannol and resveratrol up-regulated HIF-1α and down-regulated c-Myc, PHD2 and ß-catenin expressions via SIRT1 activation, in a manner that mimics hypoxic preconditioning. This study provides new insights of the molecular mechanisms of hypoxic preconditioning and suggests that polyphenolic SIRT1 activators could be used to mimic hypoxic/ischemic preconditioning.

Numerical Design of Carrier Transporting Layer in Top-Gate InGaZnO Thin-Film Transistors for Controlling Potential Energy.

Top-gate amorphous indium gallium zinc oxide (IGZO) thin-film transistors (TFTs) are designed with numerical analysis to control their electron potential energy. Design simulations show the effects of structural design on the electrical characteristics of these TFTs. In particular, the thicknesses of the channel (tch) and conducting (tc) layers, which play vital roles in TFT electrical performance, are varied from 1 to 50 nm to investigate the effect of thicknesses on the electron potential energies of the channel region and the electrode-semiconductor interfaces. The potential energies are precisely optimized for efficient charge transport, injection, and extraction, thus enhancing the electrical performance of these devices. It is also demonstrated that tch mainly affects mobility and threshold voltage, while tc mainly affects on-current. An acceptable threshold voltage of 0.55 V and high mobility of 14.7 cm²V-1s-1 are obtained with a tch of 30 nm and tc of 10 nm. Controllability of the electron potential energies and electrical performance of IGZO TFTs by means of structural design will contribute to realization of next-generation displays that have large areas and high resolutions.

Effect of High-Speed Blade Coating on Electrical Characteristics in Polymer Based Transistors.

We explore the effect of high-speed blade coating on electrical characteristics of conjugated polymer-based thin-film transistors (TFTs). As the blade-coating speed increased, the thickness of the polymer thin-film was naturally increased while the surface roughness was found to be unchanged. Polymer TFTs show two remarkable tendencies on the magnitude of field-effect mobility with increasing blade-coating speed. As the blade-coating speed increased up to 2 mm/s, the fieldeffect mobility increased to 4.72 cm²V-1s-1. However, when the coating speed reached 6 mm/s beyond 2 mm/s, the field-effect mobility rather decreased to 3.18 cm²V-1s-1. The threshold voltage was positively shifted from 2.09 to 8.29 V with respect to increase in blade-coating speed.