Statistics for quantifying aging in time transfer system delays.

Residual time delays in time transfer systems such as two-way satellite time and frequency transfer (TWSTFT), or GPS carrier phase (GPSCP) change over time. A double difference such as TWSTFT-GPSCP provides information on the changes in the relative time delays of the two systems. These changes are referred to as aging or time dispersion. A first difference statistic, RMS time interval error, TIERMS, provides the RMS time dispersion. The time deviation statistic (TDEV) or a variation on the Allan deviation (ADEV), referred to here as ADEVS, provide information on the nature of the random fluctuations in aging. This paper describes analytical and Monte Carlo techniques used to estimate the aging (time dispersion) from TDEV or ADEVS statistics, and finds that the aging can be more than a factor of four larger than TDEV or ADEVS. The use of ADEVS is recommended over TDEV since it is sensitive to time drift.

High-accuracy measurement of the blackbody radiation frequency shift of the ground-state hyperfine transition in 133Cs.

We report a high-accuracy direct measurement of the blackbody radiation shift of the 133Cs ground-state hyperfine transition. This frequency shift is one of the largest systematic frequency biases encountered in realizing the current definition of the International System of Units (SI) second. Uncertainty in the blackbody radiation frequency shift correction has led to its being the focus of intense theoretical effort by a variety of research groups. Our experimental measurement of the shift used three primary frequency standards operating at different temperatures. We achieved an uncertainty a factor of five smaller than the previous best direct measurement. These results tend to validate the claimed accuracy of the recently calculated values.

Surreptitious diuretic ingestion and pseudo-Bartter's syndrome.

A patient with profound hypokalemia satisfied the criteria for Bartter's syndrome, including hyperreninemia, aldosteronism, normal blood pressure, and hyperplasia of the juxtaglomerular apparatus. Two screening tests of urine and one of plasma for diuretic agents gave negative results. A third urinary sample gave negative results for thiazide but positive for furosemide; the fourth and fifth samples gave negative results for furosemide but positive for thiazide. Urinary prostaglandin excretion was normal. We conclude that this apparent case of Bartter's syndrome was caused by long term surreptitious diuretic ingestion and suggest this may occur more frequently than is generally appreciated.

Primary Atomic Frequency Standards at NIST.

The development of atomic frequency standards at NIST is discussed and three of the key frequency-standard technologies of the current era are described. For each of these technologies, the most recent NIST implementation of the particular type of standard is described in greater detail. The best relative standard uncertainty achieved to date for a NIST frequency standard is 1.5×10(-15). The uncertainties of the most recent NIST standards are displayed relative to the uncertainties of atomic frequency standards of several other countries.

Dependence of SAW resonator 1/f noise on device size.

Experiments were conducted with eight 450-MHz surface acoustic wave (SAW) resonators which demonstrate that a resonator's 1/f noise depends approximately inversely on the active acoustic area of the device. This observation is consistent with a proposed theory that 1/f noise in acoustic resonators is caused by localized velocity or dimensional fluctuations.

Environmental factors and hydrogen maser frequency stability.

It is necessary to have a complete understanding of the environmental sensitivities of cavity-tuned hydrogen masers to obtain optimum frequency stability and to avoid common-mode frequency fluctuations. Measurements of environmental sensitivities (temperature, relative humidity, atmospheric pressure, line voltage and magnetic field) made at the National Institute of Standards and Technology have demonstrated that the frequency stability of a cavity-tuned, active hydrogen maser is not significantly degraded if the maser is operated in a moderately controlled environment. Under these conditions, common-mode frequency fluctuations caused by the observed environmental factors also are negligible.

Precision surface-acoustic-wave (SAW) oscillators.

The evolution of SAW oscillator technology over the past 17 years is described and a review of the current state of the art for high-performance SAW oscillators is presented. This review draws heavily upon the authors' own experience and efforts, which have focused upon the development of a wide variety of SAW oscillators in response to numerous high-performance military system requirements.

1/f noise in etched groove surface acoustic wave (SAW) resonators.

Measurements of 1/f (or flicker) frequency fluctuations in SAW resonators fabricated with etched groove reflectors on single crystal quartz have shown that the observed noise levels vary inversely with device size. These measurements were made on sixteen 450 MHz resonators of four different sizes. The 1/f noise levels were also evaluated on twenty-eight other SAW resonators ranging in frequency from 401 to 915 MHz. This additional data provides valuable information on the dependence of the flicker noise levels on resonator frequency. A model based an localized, independent velocity fluctuations in the quartz is proposed which correctly fits the observed size and frequency dependence of the measured 1/f noise levels. This model suggests that the velocity fluctuations originate in small regions (much less than ~5 mum in diameter) randomly distributed throughout the quartz with an average separation of about 5 mum between independent (incoherent) sources. The magnitude of the localized fractional velocity fluctuations, Deltav/v, averaged over a 5 micron cube is on the order of 1x10 (-9).

Assessment of GPS carrier-phase stability for time-transfer applications.

We have conducted global positioning system (GPS) carrier-phase time-transfer experiments between the master clock (MC) at the U.S. Naval Observatory (USNO) in Washington, DC and the alternate master clock (AMC) at Schriever Air Force Base near Colorado Springs, Colorado. These clocks are also monitored on an hourly basis with two-way satellite time-transfer (TWSTT) measurements. We compared the performance of the GPS carrier phase and TWSTT systems over a 236-d period. Because of power problems and data outages during the carrier-phase experiment, the longest continuous time span is 96 d. The data from this period show agreement with TWSTT within +/-1 ns, apart from an overall constant time offset (caused by unknown delays in the GPS hardware at both ends). For averaging times of a day, the carrier-phase and TWSTT systems have a frequency uncertainty of 2.5 and 5.5 parts in 10(15), respectively.

Measurement of dynamic end-to-end cavity phase shifts in cesium-fountain frequency standards.

We have measured a previously unobserved systematic frequency shift in our cesium-fountain frequency standard, NIST-F1. This shift, predicted theoretically previously, mimics the well-known end-to-end phase shift in atomic beam standards when synchronous thermal transients are present. Detuning the microwave cavity several megahertz from resonance reduces this effect to the deltaf/f = 1o(-16) level.

Extremely low-phase-noise SAW resonators and oscillators: design and performance.

The authors describe prototype low-noise SAW (surface acoustic wave) resonator oscillators which have demonstrated state-of-the-art phase-noise performance not only at their fundamental operating frequencies in the 400- to 600-MHz range but also after 16x frequency multiplication to X-band as well. SAW resonator designs with overmoded cavities, very wide apertures, and dual apertures, as well as modified fabrication techniques, have been used to realize an overall reduction in an oscillator's phase-noise spectrum, i.e. white phiM, flicker FM, and random-walk FM. The S resonators can typically handle incident RF power in excess of +20 dBm, a key requirement to achieving an extremely low oscillator-phase-noise floor. A novel burn-in procedure at relatively high incident-RF-power levels (>27 dBm) was used to reduce both the flicker FM and random-walk FM phase-noise levels. Using these various techniques, a 5- to 15-dB improvement in the overall phase-noise spectrum for several prototype oscillators was demonstrated.

Spin-1/2 optical lattice clock.

We experimentally investigate an optical clock based on ;{171}Yb (I = 1/2) atoms confined in an optical lattice. We have evaluated all known frequency shifts to the clock transition, including a density-dependent collision shift, with a fractional uncertainty of 3.4 x 10;{-16}, limited principally by uncertainty in the blackbody radiation Stark shift. We measured the absolute clock transition frequency relative to the NIST-F1 Cs fountain clock and find the frequency to be 518 295 836 590 865.2(0.7) Hz.

Testing local position invariance with four cesium-fountain primary frequency standards and four NIST hydrogen masers.

We report the most sensitive tests to date of the assumption of local position invariance (LPI) underlying general relativity, based on a 7 yr comparison of cesium and hydrogen atomic clocks (frequency standards). The latest results place an upper limit that is over 20 times smaller than the previous most sensitive tests; this is consistent with the null shift predicted by LPI. The result is based on precise comparisons of frequencies of four hydrogen masers maintained by NIST, with four independent Cs fountain clocks--one at NIST and three in Europe--as the Sun's gravitational potential at Earth's surface varies due to Earth's orbital eccentricity.

Precision atomic spectroscopy for improved limits on variation of the fine structure constant and local position invariance.

We report tests of local position invariance and the variation of fundamental constants from measurements of the frequency ratio of the 282-nm 199Hg+ optical clock transition to the ground state hyperfine splitting in 133Cs. Analysis of the frequency ratio of the two clocks, extending over 6 yr at NIST, is used to place a limit on its fractional variation of <5.8x10(-6) per change in normalized solar gravitational potential. The same frequency ratio is also used to obtain 20-fold improvement over previous limits on the fractional variation of the fine structure constant of |alpha/alpha|<1.3x10(-16) yr-1, assuming invariance of other fundamental constants. Comparisons of our results with those previously reported for the absolute optical frequency measurements in H and 171Yb+ vs other 133Cs standards yield a coupled constraint of -1.5x10(-15)

Single-atom optical clock with high accuracy.

For the past 50 years, atomic standards based on the frequency of the cesium ground-state hyperfine transition have been the most accurate time pieces in the world. We now report a comparison between the cesium fountain standard NIST-F1, which has been evaluated with an inaccuracy of about 4 x 10(-16), and an optical frequency standard based on an ultraviolet transition in a single, laser-cooled mercury ion for which the fractional systematic frequency uncertainty was below 7.2 x 10(-17). The absolute frequency of the transition was measured versus cesium to be 1,064,721,609,899,144.94 (97) Hz, with a statistically limited total fractional uncertainty of 9.1 x 10(-16) the most accurate absolute measurement of an optical frequency to date.

Multiple-scattering effects on infrared scattering measurements used to characterize droplet size and volume fraction distributions in diesel sprays.

We quantify the maximum error due to multiple-scattering effects for an infrared scattering droplet izing technique. Errors in Sauter mean diameters (SMDs) and liquid volume fractions were estimated lased on experimentally determined polarization properties of the scattered light. Light that is multiply scattered from spherical particles becomes randomly polarized, whereas singly scattered light from a spherical particle contains no cross-polarization scattering component. Therefore measurement of the cross-polarization component (in this case parallel) of the scattering signal is a measure of the multiply scattered light. A ratio of parallel to perpendicular polarized scattered light was experimentally determined and used to calculate an error due to multiple scattering. The infrared scattering measurements and polarization measurements used to quantify the multiple-scattering errors were applied to a typical diesel spray that was injected into three different background conditions: a room ambient condition; a room-temperature, high-pressure condition; and a combusting condition. Droplet SMD, liquid volume fraction, and multiple-scattering errors were determined for a number of locations within the spray; results indicate that the combusting case is negligibly affected by multiple scattering. However, the room ambient case exhibited notable errors due to multiple scattering near the centerline of the spray, and the high-pressure case demonstrated susceptibility to multiple scattering throughout all regions investigated. It is important to note, however, that multiple-scattering errors in many cases translate into relatively small effects on the reported droplet sizes.

Testing the stability of fundamental constants with the 199Hg+ single-ion optical clock.

Over a two-year duration, we have compared the frequency of the 199Hg+ 5d(10)6s (2)S(1/2)(F=0)<-->5d(9)6s(2) (2)D(5/2)(F=2) electric-quadrupole transition at 282 nm with the frequency of the ground-state hyperfine splitting in neutral 133Cs. These measurements show that any fractional time variation of the ratio nu(Cs)/nu(Hg) between the two frequencies is smaller than +/-7 x 10(-15) yr(-1) (1sigma uncertainty). According to recent atomic structure calculations, this sets an upper limit to a possible fractional time variation of g(Cs)(m(e)/m(p))alpha(6.0) at the same level.