RESUMEN
A non-dissolving pretreatment consisting in the direct contact of cellulose and the ionic liquid tetra(n-butyl)phosphonium acetate, or its fluid mixtures with other phosphonium ionic liquids or with molecular liquids such as ethanol or DMSO, causes a reduction in the crystallinity of the popular microcrystalline cellulose-type Avicel PH-101 under mild conditions. At the same time, the degree of polymerization and the thermal stability of the pretreated Avicel remain essentially unaltered with respect to the untreated Avicel. The diminution of the crystallinity has been related to the increase of the reactivity of the pretreated Avicel samples via analysis of the kinetics of their enzymatic hydrolysis. For selected samples, this improved reactivity has been confirmed through their effective carboxymethylation under a simplified and milder reaction procedure.
Asunto(s)
Celulosa , Líquidos Iónicos , Acetatos , Celulosa/química , Hidrólisis , Líquidos Iónicos/químicaRESUMEN
A wide range of room temperature ionic liquids based on the 3-methylpiperdinium cation core were produced from 3-methylpiperidine, which is a derivative of DYTEK® A amine. First, reaction with 1-bromoalkanes or 1-bromoalkoxyalkanes generated the corresponding tertiary amines (Rmßpip, R = alkyl or alkoxyalkyl); further quaternisation reactions with the appropriate methylating agents yielded the quaternary [Rmmßpip]X salts (X(-) = I(-), [CF3CO2](-) or [OTf](-); Tf = -SO2CF3), and [Rmmßpip][NTf2] were prepared by anion metathesis from the corresponding iodides. All [NTf2](-) salts are liquids at room temperature. [Rmmßpip]X (X(-) = I(-), [CF3CO2](-) or [OTf](-)) are low-melting solids when R = alkyl, but room temperature liquids upon introduction of ether functionalities on R. Neither of the 3-methylpiperdinium ionic liquids showed any signs of crystallisation, even well below 0 °C. Some related non-C-substituted piperidinium and pyrrolidinium analogues were prepared and studied for comparison. Crystal structures of 1-hexyl-1,3-dimethylpiperidinium tetraphenylborate, 1-butyl-3-methylpiperidinium bromide, 1-(2-methoxyethyl)-1-methylpiperidinium chloride and 1-(2-methoxyethyl)-1-methylpyrrolidinium bromide are reported. Extensive structural and physical data are collected and compared to literature data, with special emphasis on the systematic study of the cation ring size and/or asymmetry effects on density, viscosity and ionic conductivity, allowing general trends to be outlined. Cyclic voltammetry shows that 3-methylpiperidinium ionic liquids, similarly to azepanium, piperidinium or pyrrolidinium counterparts, are extremely electrochemically stable; the portfolio of useful alternatives for safe and high-performing electrolytes is thus greatly extended.
RESUMEN
Nickel supported on silica-alumina is an efficient and reusable photocatalyst for the reduction of CO2 to methane by H2, reaching selectivity above 95% at CO2 conversion over 90%. Although NiO behaves similarly, it undergoes a gradual deactivation upon reuse. About 26% of the photocatalytic activity of Ni/silica-alumina under solar light derives from the visible light photoresponse.
RESUMEN
Ionic liquids (ILs) have been employed as potentially environmentally friendly replacements for harmful organic solvents, but have also been studied for their use in bioelectrochemical applications, such as in microbial electrochemistry for bioenergy production, or in industrial biocatalysis. For these processes, low microbial toxicity is important and there is a growing need for microbial toxicology studies for novel ILs. In this study, we report initial toxicity data for novel ILs, based on azepanium and 3-methylpiperidinium cations. Agar disc diffusion assays are used, along with minimum inhibitory concentration (MIC) and minimum bactericidal concentration (MBC) determinations, to obtain rapid and inexpensive initial toxicity data for these novel ILs against Escherichia coli and Staphylococcus epidermidis. Many of the novel ILs characterised possess low microbial toxicity relative to well-studied ILs, highlighting their potential for further study in applications where this is a desirable property.
RESUMEN
The crystal structures of numerous iodinated ortho-carboranes have been studied, which has revealed the diversity of intermolecular interactions that these substances can adopt in the solid state. The nature-mostly as it relates to hydrogen and/or halogen bonds-and relative strength of such interactions can be adjusted by selectively introducing substituents onto the cluster, thus enabling the rational design of crystal lattices. In this work we present the newly determined crystal structures of the following iodinated ortho-carboranes: 9-I-1,2-closo-C(2)B(10)H(11), 4,5,7,8,9,10,11,12-I(8)-1,2-closo-C(2)B(10)H(4), 3,4,5,6,7,8,9,10,11,12-I(10)-1,2-closo-C(2)B(10)H(2), 1-Me-8,9,10,12-I(4)-1,2-closo-C(2)B(10)H(7), 1,2-Me(2)-8,9,10,12-I(4)-1,2-closo-C(2)B(10)H(6), and 1,2-Ph(2)-8,9,10,12-I(4)-1,2-closo-C(2)B(10)H(6). Their 3D supramolecular organization has been thoroughly investigated and compared to similar previously published crystal structures. Such a systematic survey has allowed us to draw some general trends. C(c)-HI--B hydrogen bonds (C(c)= cluster carbon atoms) appear to be significant in the growth of the crystal lattices of these compounds, given the acidity of hydrogen atoms bonded to C(c), and the polarization of B-I bonds. These hydrogen bonds can be disrupted by selectively blocking the positions next to C(c), that is, B(3) and B(6), with bulky substituents that prevent iodine atoms from approaching as hydrogen acceptors. Halogen bonds of the type B-II-B are frequently observed in most cases, thus suggesting that these interactions could be attractive in boron clusters. In addition, different substituents can be grafted onto the ortho-carborane surface, thereby providing further possibilities for homomeric or heteromeric molecular assembly.
RESUMEN
The incorporation of iodine atoms onto the boron vertices of the o-carborane framework causes, according to spectroscopic data, a uniform increase in the acidic character of the C(c)-H (C(c)= cluster carbon) vertices, whereas the incorporation of methyl groups onto the boron vertices of the o-carborane framework reduces their acidity. Methyl groups when attached to boron are electron-withdrawing in boron clusters, whereas iodine atoms bonded to boron act as electron donors. This has been proven on B-methyl and B-iodinated o-carboranes with NMR spectroscopy measurements and DFT calculations of natural bond orbital (NBO) charges, which show a cumulative buildup of positive cluster-only total charge (CTC) on B-methyl o-carboranes and a cumulative buildup of negative cluster-only total charge for B-iodinated o-carboranes.
RESUMEN
The combination of different boron cluster anions and some of the cations typically found in the composition of ionic liquids has been possible by straightforward metathetic reactions, producing new low melting point salts; the imidazolium cations have been systematically studied, [C(n)mim]+ (when [C(n)mim]+ = 1-alkyl-3-methylimidazolium; n = 2, 4, 6, 8, 10, 12, 14, 16, or 18). Melting points increase in the anionic order [Co(C2B9H11)2]- < [C2B9H12]- < [B10Cl10]2- < [B12Cl12]2-. Nevertheless, alkyl chain length dramatically influences the thermal behavior, suggesting that packing inefficiency is the main cause of the existence of room temperature ionic liquids. The salts [C(n)mim][Co(C2B9H11)2] (n = 4, 6, 8, 10, 12 or 14) are liquids at room temperature, presenting strikingly low glass transition temperatures (> or = -34 degrees C). The salts [C(n)mim]2[X] ([X]2- = [B10Cl10]2- or [B12Cl12]2-, n = 16 or 18) show liquid crystal phases between the solid and liquid states. Tetraalkylphosphonium salts of [B10Cl10]2- have also been prepared. Physical properties, such as thermal stability, density, or viscosity, have been measured for some selected samples. The presence of the perhalogenated dianion [B12Cl12]2- in the composition of the imidazolium salts renders highly thermally stable compounds. For example, [C2mim]2[B12Cl12] starts to decompose above 480 degrees C in a dynamic TGA analysis under a dinitrogen atmosphere. Crystal structures of [C2mim][Co(C2B9H11)2] and [C2mim]2[B12Cl12] have been determined. 1H NMR spectra of selected imidazolium-boron cluster anion salts have been recorded from solutions as a function of the concentration, showing trends related to the cation-anion interactions.
RESUMEN
Identification of active sites in heterogeneous metal catalysts is critical for understanding the reaction mechanism at the molecular level and for designing more efficient catalysts. Because of their structural flexibility, subnanometric metal catalysts, including single atoms and clusters with a few atoms, can exhibit dynamic structural evolution when interacting with substrate molecules, making it difficult to determine the catalytically active sites. In this work, Pt catalysts containing selected types of Pt entities (from single atoms to clusters and nanoparticles) have been prepared, and their evolution has been followed, while they were reacting in a variety of heterogeneous catalytic reactions, including selective hydrogenation reactions, CO oxidation, dehydrogenation of propane, and photocatalytic H2 evolution reaction. By in situ X-ray absorption spectroscopy, in situ IR spectroscopy, and high-resolution electron microscopy techniques, we will show that some characterization techniques carried out in an inadequate way can introduce confusion on the interpretation of coordination environment of highly dispersed Pt species. Finally, the combination of catalytic reactivity and in situ characterization techniques shows that, depending on the catalyst-reactant interaction and metal-support interaction, singly dispersed metal atoms can rapidly evolve into metal clusters or nanoparticles, being the working active sites for those abovementioned heterogeneous reactions.
RESUMEN
Alkyl glycoside biodegradable surfactants were produced from cellulose and 1-octanol or 1-dodecanol in a one-pot, two-step (hydrolysis-glycosidation) process in 1-butyl-3-methylimidazolium chloride. Both surfactant productivity and separation efficiencies have been strikingly enhanced compared to other previously reported ionic liquid processes. Production temperatures were decreased to limit the extent of glucose dehydration and further degradation processes, but the conversions remained high. Surfactant molar yields up to 72% were achieved by operating at 70 °C. Several separation procedures were tested to achieve high recoveries of both surfactant and ionic liquid. The use of a silica stationary phase was useful for isolation of the surfactant, whereas crystallization of the ionic liquid improved its separation efficiency. Finally, the precipitation of dodecyl glycosides in aqueous media was highly efficient for their isolation and for the recovery (>99%) of the ionic liquid by using only water as the solvent for separation.
Asunto(s)
Celulosa/química , Imidazoles/química , Tensoactivos/química , Espectroscopía Infrarroja por Transformada de Fourier , Tensoactivos/aislamiento & purificaciónRESUMEN
A series of alkyltributylphosphonium chloride ionic liquids, prepared from tributylphosphine and the respective 1-chloroalkane, C(n)H(2n+1)Cl (where n = 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 12 or 14), is reported. This work is a continuation of an extended series of tetraalkylphosphonium ionic liquids, where the focus is on the variability of n and its impact on the physical properties, such as melting points/glass transitions, thermal stability, density and viscosity. Experimental density and viscosity data were interpreted using QPSR and group contribution methods and the crystal structure of propyl(tributyl)phosphonium chloride is detailed.
RESUMEN
o-Carborane derivatives with precisely defined patterns of substitution have been prepared from 8,9,10,12-I(4)-1,2-closo-C(2)B(10)H(8) by replacing the iodine atoms, bonded to four adjacent boron vertices in the cluster, with allyl, and subsequently 3-hydroxypropyl groups. The resulting structures, comprising four pendant arms and two reactive vertices located on opposite sides of a central o-carborane core, can be envisaged as versatile precursors for dendritic growth.
Asunto(s)
Boranos/química , Cristalografía por Rayos X , Yodo/química , Conformación MolecularRESUMEN
New unsymmetrical selenides bearing an o-carborane and a naphthalene ring as the substituents were prepared by the cleavage of the corresponding diselenides. The compounds were characterized by means of spectroscopic and analytical methods. (77)Se NMR signals of the selenium atoms attached to the carbon atoms of the carborane cages are shifted downfield in comparison to those bonded only to the aromatic rings, indicating an electron withdrawing effect of the o-carboranyl substituent. Compounds 1-(2-R-1,2-dicarba-closo-carboranyl)naphthyl selenides (R = Me, 1; Ph, 2) were characterized by means of single crystal X-ray diffraction. The influence of the electronic nature of the substituents attached to the selenium atoms on the structural parameters and packing properties of naphthyl selenides are discussed. Theoretical calculations and cyclic voltammetry (CV) studies were carried out to compare the bonding nature of carboranyl and analogous aryl selenium compounds. Cyclic voltammetry studies of naphthyl carboranyl mono and diselenides have shown that the carboranyl fragment polarizes the Se lone pair making it less prone to generate a Se-Se bond.