Structural, Chemical, and Mechanical Properties of Pressure Garments as a Function of Simulated Use and Repeated Laundering.

Pressure garments are widely employed for management of postburn scarring. Although pressure magnitude has been linked to efficacy, maintenance of uniform pressure delivery is challenging. An understanding of garment fabric properties is needed to optimize pressure delivery for the duration of garment use. To address this issue, compression vests were manufactured using two commonly used fabrics, Powernet or Dri-Tek Tricot, to achieve 10% reduction in circumference for a child-sized mannequin. Applied pressure was tracked on five anatomical sites over 23 hours, before laundering or after one and five laundering cycles. Load relaxation and fatigue of fabrics were tested before laundering or after one and five laundering cycles, and structural analysis via scanning electron microscopy was performed. Prior to laundering, pressure vests fabricated using Powernet or Dri-Tek Tricot generated a maximum pressure on the mannequin of 20 and 23 mm Hg, respectively. With both fabrics, pressure decreased during daily wear. Following five laundering cycles, Dri-Tek Tricot vests delivered a maximum of 7 vs 15 mm Hg pressure for Powernet at the same site. In cyclic tensile and load relaxation tests, exerted force correlated with fabric weave orientation with greatest force measured parallel to a fabric's long axis. The results demonstrate that Powernet exhibited the greatest applied force with the least garment fatigue. Fabric orientation with respect to the primary direction of tension was a critical factor in pressure generation and maintenance. This study suggests that fabrication of garments using Powernet with its long axis parallel to patient's body part circumference may enhance the magnitude and maintenance of pressure delivery.

Quantum confined peptide assemblies with tunable visible to near-infrared spectral range.

Quantum confined materials have been extensively studied for photoluminescent applications. Due to intrinsic limitations of low biocompatibility and challenging modulation, the utilization of conventional inorganic quantum confined photoluminescent materials in bio-imaging and bio-machine interface faces critical restrictions. Here, we present aromatic cyclo-dipeptides that dimerize into quantum dots, which serve as building blocks to further self-assemble into quantum confined supramolecular structures with diverse morphologies and photoluminescence properties. Especially, the emission can be tuned from the visible region to the near-infrared region (420 nm to 820 nm) by modulating the self-assembly process. Moreover, no obvious cytotoxic effect is observed for these nanostructures, and their utilization for in vivo imaging and as phosphors for light-emitting diodes is demonstrated. The data reveal that the morphologies and optical properties of the aromatic cyclo-dipeptide self-assemblies can be tuned, making them potential candidates for supramolecular quantum confined materials providing biocompatible alternatives for broad biomedical and opto-electric applications.

Integrin-dependent interaction of human vascular endothelial cells on biomimetic peptide surfactant polymers.

Biomimetic surfactant polymers designed by molecular grafting of pendant RGD peptides (Pep) and dextran oligosaccharides (Dex) in different ratios onto the backbone of poly(vinyl amine) (PVAm) were examined for their ability to promote endothelial cell (EC) growth. Adhesion, formation of focal contacts, and expression of integrin receptors were examined in EC seeded onto a series of novel surfactants containing 100% dextran (PVAm[Pep (0%)]) to 100% peptide (PVAm[Pep (100%)]) compared to fibronectin control. Interaction of EC on polymer was specific, as soluble GRGDSP, but not GRGESP, was able to inhibit both adhesion and spreading of EC. At three hours, EC attachment and spreading were rapid and comparable on fibronectin and PVAm[Pep (100%)], rounded on PVAm[Pep (0%)], and intermediate on PVAm[Pep (25%)], (PVAm[Pep (50%)], and PVAm[Pep (75%)], with increasing peptide ratio favoring more spreading, although all the substrates had similar hydrophilicity. Cells that spread well on fibronectin and PVAm[Pep (100%)] had sharp spikes of vinculin localized at the termination point of actin stress fibers. Formation of stress fibers and focal adhesions on other substrates were correlated with spreading pattern of EC and the peptide content. EC seeded on fibronectin expressed alpha5beta1 integrins all along the stress fibers and throughout the entire cytoskeleton, but this distribution pattern was less prominent on PVAm[Pep (100%)]. However, expression and distribution of vitronectin receptors (alpha(v)beta3) were similar on both fibronectin and PVAm[Pep (100%)], suggesting a strong cell adhesion on PVAm[Pep (100%)]. Viability of EC was also comparable on both fibronectin and PVAm[Pep (100%)] at 24 h. Substrates with high proportion of dextran limited cell adhesion, probably by decreasing protein adsorption. These results suggest that it may be possible to engineer substrates that promote cell adhesion in a receptor-dependent manner while blocking nonspecific protein adsorption, which may have potential as interface materials for prostheses used in cardiovascular system.

Extracellular matrix-like surfactant polymers containing arginine-glycine-aspartic acid (RGD) peptides.

We report on a novel series of biomimetic polymers exhibiting interfacial properties similar to the extracellular matrix. A series of well-defined surfactant polymers were synthesized by simultaneously incorporating arginine-glycine-aspartic acid (RGD) peptide, dextran oligosaccharide, and hexyl ligands with controlled feed ratios onto a poly(vinyl amine) (PVAm) backbone. The peptide sequence was H-GSSSGRGDSPA-NH(2) (Pep) having a hydrophilic extender at the amino terminus and capped carboxy terminus. The peptide-to-dextran (Pep:Dex) ratios were varied to create surfactants having 0, 25, 50, 75, and 100 mol-% peptide relative to dextran. The surfactants were characterized by IR, NMR and atomic force microscopy (AFM) for composition and surface active properties. AFM confirmed full surface coverage of PVAm(Pep)(100%) on graphite, and supported the mechanism of interdigitation of hexyl ligands between surfactant molecules within a specified range of hexyl chain densities. the attachment and growth of human pulmonary artery endothelial cells on the PVAm(Pep)(100%) surface was identical to the fibronectin positive control. Cell adhesion decreased dramatically with decreasing peptide density on the surfactant polymers. Molecular model of a peptide surfactant polymer, consisting of poly(vinyl amine) backbone with peptide, dextran oligosaccharide and hexyl branches coupled to the polymer chain.