RESUMEN
We report, to the best of our knowledge, the highest power conductive-cooled active-mirror amplifier (CcAMA) using Yb:YAG with a pulse energy of 10 J. By using four liquid-nitrogen circulating cooled laser heads, we achieved a repetition rate, pulse energy, and average power of 33.3 Hz, 9.3 J, and 310 W, respectively. The problem of wavefront distortion, which is difficult to solve with a large-aperture active-mirror laser, is suppressed by using reinforcing materials with the same thermal expansion coefficient. We have confirmed that the wavefront distortion is small (0.15λ P-V per head) at 100 Hz operation, which paves the way for 100 Hz operation with the CcAMA concept.
RESUMEN
This study demonstrates fast pulse train switching using a coherent polarization beam combiner with a phase difference detection (PDD) algorithm. Based on the highly stable feedback control obtained with the PDD algorithm, stable burst-mode extraction with an arbitrary duty cycle was achieved with a contrast ratio of 800:1 for a third-harmonic light (347 nm) of a 5 MHz pulsed Yb-doped fiber laser. The proposed method can be effectively used for high-speed switching in high-average-power pulsed laser systems.
RESUMEN
Comparing with the non-collinear optical parametric amplification (NOPA), the gain bandwidth could be significantly enhanced by the wide-angle NOPA (WNOPA), i.e., with a divergent signal (WNOPA-S) or pump (WNOPA-P). In a uniaxial crystal, the spectral symmetry/asymmetry of WNOPA is introduced. In WNOPA-S, the ultra-broadband gain spectrum can be obtained in two phase-matching directions at both sides of the pump, however, the output is heavily angularly dispersed. In WNOPA-P, although the gain bandwidth enhancement is only achieved in one phase-matching direction, i.e., on the opposite side of the crystal axis, it is free of angular dispersion. The stabilities of the gain spectrum in NOPA and in WNOPA-P are experimentally compared and theoretically analyzed. Compared with NOPA, WNOPA-P supports an even broader and more stable gain spectrum, and compared with WNOPA-S, WNOPA-P is angular-dispersion-free. The conversation efficiency of WNOPA-P is the same as NOPA. We suppose WNOPA-P is ideally suitable for the amplification of stable ultra-broadband few-cycle pulse lasers.
RESUMEN
The spatial distribution of the optical parametric fluorescence generated in a negative uniaxial nonlinear crystal is asymmetric with respect to the pump when the pump beam has a slight divergence angle. The formation mechanism of this phenomenon and the influence of parameters were analyzed and discussed from a theoretical standpoint. Moreover, two potential applications of this phenomenon were experimentally demonstrated, showing the temporal contrast improvement of ultra-intense lasers and the intensity enhancement of special light sources induced by the optical parametric generation.
RESUMEN
We describe a sub-nanosecond pulse laser system that delivers high-average-power green and ultraviolet (UV) light. This system includes a front end, two modules each of which has four photonic crystal fiber main amplifiers, two sets of coherent beam combiners with efficiencies of 83 and 90%, and two sets of harmonic converters. A single beam was ultimately produced through polarization-beam combining. The maximum average output power was 955 W at the fundamental wavelength (1040 nm) with a 10 MHz repetition rate and 285 ps pulse duration. The M-square of the UV was 1.3. The average power of each of its harmonics is 600 W in green (520 nm) and 300 W in UV (347 nm). The nonlinear crystals were longitudinally cooled by Peltier devices for efficient harmonic conversion.
RESUMEN
We present a high-average-power green laser based on second harmonic conversion of a laser diode-pumped master oscillator Nd:YAG power amplifier system. The power amplifier chain includes a stimulated Brillouin scattering (SBS) cell that was used a phase-conjugate mirror to double-pass scheme. That suppresses the thermal phase distortion and compresses the pulse duration. The fundamental beam output power was 670 W with a pulse width of 7.9 ns. A second harmonic power of 335 W with a 4.8-ns pulse width and 80-mJ pulse energy was produced using a LiB3O5 (LBO) crystal.
RESUMEN
A chiral structure is formed by the optical radiation force induced by a circularly polarized light that has spin angular momentum; chiral structures are expected to be used for light control devices and molecular chirality discrimination devices. In this paper, we clarify the relationship between the differences in the distributions of the optical radiation force and the possibility of formation of chiral structures. We first simulate the optical radiation force distribution in the case of a Gaussian beam that successfully forms a chiral structure. Given a vector [Formula: see text] with a centre of the light spot [Formula: see text] and polar coordinates [Formula: see text], and an optical radiation force vector [Formula: see text] at [Formula: see text], the angle [Formula: see text] and [Formula: see text] must be constant with respect to the declination angle [Formula: see text] for a chiral structure to form. These conditions are fulfilled in the case of a 6-beam interference pattern, but not in the case of a 4-beam interference pattern, which is consistent with the result that no chiral structure is formed in the latter case. The equations derived for simulation of optical radiation force distribution can be used for any optical intensity distribution, and will be of great help in the research of any dielectrics deformation.
RESUMEN
The optical properties, Faraday effect and Verdet constant of ceramic terbium gallium garnet (TGG) have been measured at 1064 nm, and were found to be similar to those of single crystal TGG at room temperature. Observed optical characteristics, laser induced bulk-damage threshold and optical scattering properties of ceramic TGG were compared with those of single crystal TGG. Ceramic TGG is a promising Faraday material for high-average-power YAG lasers, Yb fiber lasers and high-peak power glass lasers for inertial fusion energy drivers.
RESUMEN
Noble metal nanodots have been applied to plasmonic devices, catalysts, and highly sensitive detection in bioinstruments. We have been studying the fabrications of them through a laser-induced dot transfer (LIDT) technique, a type of laser-induced forward transfer (LIFT), in which nanodots several hundred nm in diameter are produced via a solid-liquid-solid (SLS) mechanism. In the previous study, an interference laser processing technique was applied to LIDT, and aligned Au nanodots were successfully deposited onto an acceptor substrate in a single shot of femtosecond laser irradiation. In the present experiment, Pt thin film was applied to this technique, and the deposited nanodots were measured by scanning electron microscopy (SEM) and compared with the Au nanodots. A typical nanodot had a roundness fr=0.98 and circularity fcirc=0.90. Compared to the previous experiment using Au thin film, the size distribution was more diffuse, and it was difficult to see the periodic alignment of the nanodots in the parameter range of this experiment. This method is promising as a method for producing large quantities of Pt particles with diameters of several hundred nm.
RESUMEN
We experimentally demonstrated coherent beam combining using optical parametric amplification with a nonlinear crystal pumped by random-phased multiple-beam array of the second harmonic of a Nd:YAG laser at 10-Hz repetition rate. In the proof-of-principle experiment, the phase jump between two pump beams was precisely controlled by a motorized actuator. For the demonstration of multiple-beam combining a random phase plate was used to create random-phased beamlets as a pump pulse. Far-field patterns of the pump, the signal, and the idler indicated that the spatially coherent signal beams were obtained on both cases. This approach allows scaling of the intensity of optical parametric chirped pulse amplification up to the exa-watt level while maintaining diffraction-limited beam quality.
RESUMEN
A diode-pumped joule class in a 10 Hz output Nd:YLF ring amplifier has been developed. A phase conjugate plate was developed as a wavefront corrector for the residual wavefront distortion of an Nd:YLF rod. We have demonstrated a 0.46 J output of 10 ns pulse duration at 10 Hz repetition rate with 1.5 nJ of input energy. The effective gain of the ring amplifier system was 84.8 dB. To our knowledge, this is the highest magnification with joule-level output energy in a single-stage amplifier system that has ever been built. As a preamplifier system, this system contributed a demonstration of 21.3 J in a 10 Hz output diode-pumped Nd:glass zigzag slab laser system with a stimulated Brillouin scattering- phase conjugation mirror. We describe a robust and effective method of wavefront correction for high-energy laser systems.