Characterization of scintillating X-ray optical fiber sensors.

The paper presents a set of tests carried out in order to evaluate the design characteristics and the operating performance of a set of six X-ray extrinsic optical fiber sensors. The extrinsic sensor we developed is intended to be used as a low energy X-ray detector for monitoring radiation levels in radiotherapy, industrial applications and for personnel dosimetry. The reproducibility of the manufacturing process and the characteristics of the sensors were assessed. The sensors dynamic range, linearity, sensitivity, and reproducibility are evaluated through radioluminescence measurements, X-ray fluorescence and X-ray imaging investigations. Their response to the operating conditions of the excitation source was estimated. The effect of the sensors design and implementation, on the collecting efficiency of the radioluminescence signal was measured. The study indicated that the sensors are efficient only in the first 5 mm of the tip, and that a reflective coating can improve their response. Additional tests were done to investigate the concentricity of the sensors tip against the core of the optical fiber guiding the optical signal. The influence of the active material concentration on the sensor response to X-ray was studied. The tests were carried out by measuring the radioluminescence signal with an optical fiber spectrometer and with a Multi-Pixel Photon Counter.

Optical and THz investigations of mid-IR materials exposed to alpha particle irradiation.

The paper is the first comprehensive study on alpha particle irradiation effects on four mid-IR materials: CaF2, BaF2, Al2O3 (sapphire) and ZnSe. The measurements of the optical spectral transmittance, spectral diffuse reflectance, radioluminescent emission, terahertz (THz) spectral response, transmittance, absorbance, refractive index, real and imaginary parts of the dielectric constant and THz imaging are used as complementary investigations to evaluate these effects. The simulations were run to estimate: (i) the penetration depth, (ii) the scattering of alpha particle beam, (iii) the amount of material affected by this interaction, and (iv) the number of vacancies produced by the radiation exposure for each type of material. The simulation results are compared to the off-line measurement outcomes. The delay and spectral composition change of the reflected THz signal highlight the modification induced in the tested materials by the irradiation process.