Polycaprolactone-Vitamin E TPGS Micellar Formulation for Oral Delivery of Paclitaxel.

This study aimed to investigate the potential of polycaprolactone-vitamin E TPGS (PCL-TPGS) micelles as a delivery system for oral administration of paclitaxel (PTX). The PCL-TPGS copolymer was synthesized using ring opening polymerization, and PTX-loaded PCL-TPGS micelles (PTX micelles) were prepared via a co-solvent evaporation method. Characterization of these micelles included measurements of size, polydispersity, and encapsulation efficiency. The cellular uptake of PTX micelles was evaluated in Caco-2 cells using rhodamine 123 (Rh123) as a fluorescent probe. Moreover, an everted rat sac study was conducted to evaluate the ex vivo permeability of PTX micelles. Additionally, a comparative pharmacokinetic study of PTX micelles versus the marketed formulation, Ebetaxel® (a Taxol generic), was performed after a single oral administration to rats. The results demonstrated that the micellar formulation significantly improved PTX solubility (nearly 1 mg/mL). The in vitro stability and release of PTX micelles in simulated gastric fluid (SGF) and simulated intestinal fluid (SIF) demonstrated that PTX micelles remained stable for up to 24 h and significantly slowed the release of PTX in both media compared to Ebetaxel®. The in vitro cellular uptake, ex vivo intestinal permeability, and in vivo pharmacokinetic profile demonstrated that PTX micelles enhanced the permeability and facilitated a rapid absorption of the drug. Conclusively, the PCL7000-TPGS3500 micelles exhibit potential as an effective oral delivery system for PTX.

Preparation, optimization, and characterization of genistein-ginseng long-acting polymeric gel as a breast cancer treatment alternative.

To address the prevalent genistein (GST) metabolism and inadequate intestinal absorption, an oral long-acting and gastric in-situ gelling gel was designed to encapsulate and localize the intestinal release of the loaded genistein-ginseng (GST-GNS) solid dispersion. Because of the high breast perfusion of GST upon oral absorption, the GST-GNS solid dispersion was developed to enhance GST's dissolution and penetration while offering a synergistic impact against breast cancer (BC). Physiochemical analysis of the GST-GNS solid dispersion, release analysis, gel characterizations, storage stability, penetration, and in vitro cytotoxicity studies were carried out. GST-GNS solid dispersion showed improved dissolution and penetration as compared to raw GST. GST-GNS solid dispersion homogenous shape particles and hydrophilic contacts were revealed by scanning electron microscopy and Fourier Transform-Infrared analysis, respectively. GST-GNS solid dispersion's diffractogram shows the amorphous character. A second modification involved creating a gastric in-situ gelling system loaded with GST-GNS solid dispersion. This system demonstrated improved GST penetration employing the solid dispersion, as well as the localizing of the GST release at the intestinal media and antitumor synergism against BC. For a better therapeutic approach for BC, the innovative oral GST long-acting gel encasing the GST-GNS solid dispersion would be recommended.

Polycaprolactone - Vitamin E TPGS micelles for delivery of paclitaxel: In vitro and in vivo evaluation.

This study aimed to present findings on a paclitaxel (PTX)-loaded polymeric micellar formulation based on polycaprolactone-vitamin E TPGS (PCL-TPGS) and evaluate its in vitro anticancer activity as well as its in vivo pharmacokinetic profile in healthy mice in comparison to a marketed formulation. Micelles were prepared by a co-solvent evaporation method. The micelle's average diameter and polydispersity were determined using dynamic light scattering (DLS) technique. Drug encapsulation efficiency was assessed using an HPLC assay. The in vitro cytotoxicity was performed on human breast cancer cells (MCF-7 and MDA-MB-231) using MTT assay. The in vivo pharmacokinetic profile was characterized following a single intravenous dose of 4 mg/kg to healthy mice. The mean diameters of the prepared micelles were ≤ 100 nm. Moreover, these micelles increased the aqueous solubility of PTX from ∼0.3 µg/mL to reach nearly 1 mg/mL. While the PTX-loaded micelles showed an in vitro cytotoxicity comparable to the marketed formulation (Ebetaxel), drug-free PCL-TPGS micelles did not show any cytotoxic effects on both types of breast cancer cells (∼100% viability). Pharmacokinetics of PTX as part of PCL-TPGS showed a significant increase in its volume of distribution compared to PTX conventional formulation, Ebetaxel, which is in line with what was reported for clinical nano formulations of PTX, i.e., Abraxane, Genexol-PM, or Apealea. The findings of our studies indicate a significant potential for PCL-TPGS micelles to act as an effective system for solubilization and delivery of PTX.

Fine excipient materials in carrier-based dry powder inhalation formulations: The interplay of particle size and concentration effects.

The contributions of fine excipient materials to drug dispersibility from carrier-based dry powder inhalation (DPI) formulations are well recognized, although they are not completely understood. To improve the understanding of these contributions, we investigated the influences of the particle size of the fine excipient materials on characteristics of carrier-based DPI formulations. We studied two particle size grades of silica microspheres, with volume median diameters of 3.31 µm and 8.14 µm, as fine excipient materials. Inhalation formulations, each composed of a lactose carrier material, one of the fine excipient materials (2.5% or 15.0% w/w), and a drug (fluticasone propionate) material (1.5% w/w) were prepared. The physical microstructure, the rheological properties, the aerosolization pattern, and the aerodynamic performance of the formulations were studied. At low concentration, the large silica microspheres had a more beneficial influence on the drug dispersibility than the small silica microspheres. At high concentration, only the small silica microspheres had a beneficial influence on the drug dispersibility. The results reveal influences of fine excipient materials on mixing mechanics. At low concentration, the fine particles improved deaggregation and distribution of the drug particles over the surfaces of the carrier particles. The large silica microspheres were associated with a greater mixing energy and a greater improvement in the drug dispersibility than the small silica microspheres. At high concentration, the large silica microspheres kneaded the drug particles onto the surfaces of the carrier particles and thus impaired the drug dispersibility. As a critical attribute of fine excipient materials in carrier-based dry powder inhalation formulations, the particle size demands robust specification setting.

Sorafenib and Piperine co-loaded PLGA nanoparticles: Development, characterization, and anti-cancer activity against hepatocellular carcinoma cell line.

Hepatocellular carcinoma (HCC) exhibits high mortality rates in the advanced stage (>90 %). Sorafenib (SORA) is a targeted therapy approved for the treatment of advanced HCC; however, the reported response rate to such a therapeutic is suboptimal (<3%). Piperine (PIP) is an alkaloid demonstrated to exert a direct tumoricidal activity in HCC and improve the pharmacokinetic profiles of anticancer drugs including SORA. In this study, we developed a strategy to improve efficacy outcomes in HCC using PIP as an add-on treatment to support the first-line therapy SORA using biodegradable Poly (D, L-Lactide-co-glycolide, PLGA) nanoparticles (NPs). SORA and PIP (both exhibit low aqueous solubility) were co-loaded into PLGA NPs (PNPs) and stabilized with various concentrations of polyvinyl alcohol (PVA). The SORA and PIP-loaded PNPs (SP-PNPs) were characterized using Fourier Transform Infrared (FTIR) Spectroscopy, X-ray Powder Diffraction (XRD), Dynamic Light Scattering (DLS), and Scanning Electron Microscopy (SEM), Release of these drugs from SP-PNPs was investigated in vitro at both physiological and acidic pH, and kinetic models were employed to assess the mechanism of drug release. The in vitro efficacy of SP-PNPs against HCC cells (HepG2) was also evaluated. FTIR and XRD analyses revealed that the drugs encapsulated in PNPs were in an amorphous state, with no observed chemical interactions among the drugs or excipients. Assessment of drug release in vitro at pH 5 and 7.4 showed that SORA and PIP loaded in PNPs with 0.5 % PVA were released in a sustained manner, unlike pure drugs, which exhibited relatively fast release. SP-PNPs with 0.5 % PVA were spherical, had an average size of 224 nm, and had a high encapsulation efficiency (SORA âˆ¼ 82 %, PIP âˆ¼ 79 %), as well as superior cytotoxicity compared to SORA monotherapy in vitro. These results suggest that combining PIP with SORA using PNPs may be an effective strategy for the treatment of HCC and may set the stage for a comprehensive in vivo study to evaluate the efficacy and safety of this novel formulation using a murine HCC model.

Critical attributes of fine excipient materials in carrier-based dry powder inhalation formulations: The particle shape and surface properties.

The potential of fine excipient materials to improve the aerodynamic performance of carrier-based dry powder inhalation (DPI) formulations is well acknowledged but not fully elucidated. To improve the understanding of this potential, we studied two fine excipient materials: micronized lactose particles and silica microspheres. Inhalation formulations, each composed of a coarse lactose carrier, one of the two fine excipient materials (0.0-15.0 % w/w), and a spray-dried drug (fluticasone propionate) material (1.5 % w/w) were prepared. The physical structure, the flow behavior, the aerosolization behavior, and the aerodynamic performance of the formulations were studied. The two fine excipient materials similarly occupied carrier surface macropores. However, only the micronized lactose particles formed agglomerates and appeared to increase the tensile strength of the formulations. At 2.5 % w/w, the two fine excipient materials similarly improved drug dispersibility, whereas at higher concentrations, the micronized lactose material was more beneficial than the silica microspheres. The findings suggest that fine excipient materials improve drug dispersibility from carrier-based DPI formulations at low concentrations by filling carrier surface macropores and at high concentrations by forming agglomerates and/or enforcing fluidization. The study emphasizes critical attributes of fine excipient materials in carrier-based DPI formulations.

3D printed capsule shells for personalized dosing of cyclosporine-loaded SNEDDS.

Cyclosporine (CsA) is a potent immunosuppressant agent that has been used since 1980 for the treatment of various autoimmune diseases and is extensively used to enhance the survival rate of patients and grafts following organ transplant surgeries. CsA is a poorly soluble drug with a narrow therapeutic window and inter-subject variability, which can lead to graft rejection, nephrotoxicity and other severe adverse effects. This study explores a novel method that combines solubility enhancement of CsA using SNEDDS formulation and personalized dosage delivery using 3D printing technology. The oil phase was chosen as a combination of caproyl 90 and octanoic acid while the Smix phase was chosen as a combination of cremophore El and PEG 400. The optimized liquid SNEDDS was solidified using PEG 6000. An FDM printer was used to print a capsular shell with an oval base that ascends to form a dome with an opening at the top. This opening is used to fill the molten CsA-loaded SNEDDS formulation using a pipette or syringe. The CsA-loaded SNEDDS formulation was characterized by FTIR, DSC and SEM/EDX. The in-vitro release of CsA showed complete release within sixty minutes and followed Korsmeyer-Peppas release kinetics. The drug release was not affected by either the shell opening size or the amount of the loaded formulation. This novel method is simple and straightforward for personalized dosage delivery of drug-loaded SNEDDS formulations.