RESUMEN
Three different regions of interest (ROIs) were defined in pQCT scans (XCT-3000 machine, Stratec, Germany) taken at the tibial mid-diaphyses of 12 pre-menopausal (pre-MP) and 12 post-menopausal (post-MP) women who were otherwise normal, according to the volumetric bone mineral density (vBMD) value of their corresponding pixels (voxels) as assessed by their respective attenuation values. They were classified as "low-vBMD" (LD-ROI, with a vBMD of 200-400 mg/cm(3)), corresponding chiefly to trabecular-subcortical bone; "medium-vBMD" (MD-ROI, vBMD = 400-800 mg/cm(3)), corresponding mainly to porous cortical bone or cortical-subcortical bone, and "high-vBMD" (HD-ROI, vBMD higher than 800 mg/cm(3)), corresponding to dense cortical bone. The fraction of the total cross-sectional bone area covered by the HD-ROI was 16% higher, and that covered by the MD-ROI 20% lower, in pre-MP than post-MP women. No differences concerning the LDROIs were found. A close, linearly negative relationship was found between the MD- and HD-ROI fractions in all the women together, with no inter-group differences in slope. The Stress-Strain Index (an indicator of the torsional stiffness and strength of the whole bones that involved both the vBMD and the spatial disposition of the HD bone in the cross-section - torsional moment of inertia -) correlated linearly and positively with the cross-sectional area of the HD-ROI, with a higher slope for pre-MP than post-MP women. Qualitatively, a. post-MP women showed a significantly more prevalent discontinuity of the voxels in the HD-ROI than pre-MP women, and b. the tendency of LD-ROIs to accumulate along the mechanically lesseffective (antero-posterior) axis of the image - a characteristic of pre-MP bones - was visually less evident in post-MP bones. These features describe non-invasively some changes induced by menopause in the human tibia that may be critical for defining the skeletal condition and to monitor the effects of treatments addressed either to protect or to improve mechanically the bone structure, beyond the possibilities of standard densitometry.
RESUMEN
Animal models are suitable to study many aspects of bone structure and strength. This article reviews some general principles of current bone biomechanics and describes the scope of the available methodology for biomechanical studies of the musculoskeletal system employing those models. The analysis comprises bone and muscle "mass" indicators provided by standard densitometry (DEXA); bone 'mass', 'apparent density', geometry or architectural design and strength and muscle strength indicators that can be determined by peripheral quantitative computed tomography (pQCT), and bone material and structural (whole-bone) properties than can be directly assessed by destructive mechanical tests. Some novel interrelationships that can be investigated that way are discussed, namely, 1. the pathogenetic analysis of the effects on whole-bone strength, 2. the discrimination between mineralization and microstructural factors as determinants of changes in the bone material or structural properties, 3. the evaluation of the interaction of a treatment with the ability of bone 'mechanostat' to optimize the bone architectural design by 'distribution / mass' and 'distribution / quality' curves, and 4. the analysis of effects on the musclebone interactions for a differential diagnosis between 'physiological' or 'disuse' and 'true' osteopenias and osteoporoses.
RESUMEN
Previous studies with standard densitometry (DXA) have suggested that the bone mass is strongly dependent on the muscle mass in the species, following a similar relationship at any age and sex hormones or related factors potentiate that relationship. Studies with pQCT indicated that the surplus bone mass per unit of muscle mass previously observed in premenopausal women would be stored in skeletal regions with relatively little mechanical relevance, thus avoiding remotion through mechanically oriented remodelling by the bone mechanostat. Scanning the distal radius with pQCT has also showed a highly significant, linear relationship between SSI of the distal radius and the dynamometric maximal bending moment of the forearm in normal men and women. In order to investigate similar relationships in regions that are inaccessible to pQCT, we used spinal radiographs and axial QCT. This study affords additional evidence to the previous references concerning the direct, significant impact of the regional muscle strength on the determination of the tomographic indicators of bone mechanical quality and their indirect repercussion of the skeletal condition (curvature of the spine).