Wafer-Scale Growth and Transfer of High-Quality MoS2 Array by Interface Design for High-Stability Flexible Photosensitive Device.

Transition metal disulfide compounds (TMDCs) emerges as the promising candidate for new-generation flexible (opto-)electronic device fabrication. However, the harsh growth condition of TMDCs results in the necessity of using hard dielectric substrates, and thus the additional transfer process is essential but still challenging. Here, an efficient strategy for preparation and easy separation-transfer of high-uniform and quality-enhanced MoS2 via the precursor pre-annealing on the designed graphene inserting layer is demonstrated. Based on the novel strategy, it achieves the intact separation and transfer of a 2-inch MoS2 array onto the flexible resin. It reveals that the graphene inserting layer not only enhances MoS2 quality but also decreases interfacial adhesion for easy separation-transfer, which achieves a high yield of ≈99.83%. The theoretical calculations show that the chemical bonding formation at the growth interface has been eliminated by graphene. The separable graphene serves as a photocarrier transportation channel, making a largely enhanced responsivity up to 6.86 mA W-1, and the photodetector array also qualifies for imaging featured with high contrast. The flexible device exhibits high bending stability, which preserves almost 100% of initial performance after 5000 cycles. The proposed novel TMDCs growth and separation-transfer strategy lightens their significance for advances in curved and wearable (opto-)electronic applications.

Effect of Geometrical Parameters on the Mechanical Performance of Bamboo-Inspired Gradient Hollow-Strut Octet Lattice Structure Fabricated by Additive Manufacturing.

Hollow-strut metal lattice structures are currently attracting extensive attention due to their excellent mechanical performance. Inspired by the node structure of bamboo, this study aimed to investigate the mechanical performance of the gradient hollow-strut octet lattice structure fabricated by laser powder bed fusion (LPBF). The effect of geometrical parameters on the yield strength, Young's modulus and energy absorption of the designed octet unit cells were studied and optimized by FEA analysis. The hollow-strut geometrical parameters that deliver the best mechanical property combinations were identified, and the corresponding unit cells were then redesigned into the 3 × 3 × 3 type lattice structures for experimental evaluations. Compression tests confirmed that the designed gradient hollow-strut octet lattice structures demonstrated superior mechanical properties and deformation stability than their solid-strut lattice structure counterparts. The underlying deformation mechanism analysis revealed that the remarkably enhanced bending strength of the gradient hollow-strut lattice structure made significant contributions to its mechanical performance improvement. This study is envisaged to shed light on future hollow-strut metal lattice structure design for lightweight applications, with the final aim of enhancing the component's mechanical properties and/or lowering its density as compared with the solid-strut lattice structures.

Performance of High Efficiency Avalanche Poly-SiGe Devices for Photo-Sensing Applications.

This paper explores poly-silicon-germanium (poly-SiGe) avalanche photo-sensors (APSs) involving a device of heterojunction structures. A low pressure chemical vapor deposition (LPCVD) technique was used to deposit epitaxial poly-SiGe thin films. The thin films were subjected to annealing after the deposition. Our research shows that the most optimal thin films can be obtained at 800 °C for 30 min annealing in the hydrogen atmosphere. Under a 3-µW/cm2 incident light (with a wavelength of 550 nm) and up to 27-V biased voltage, the APS with a n+-n-p-p+ alloy/SiO2/Si-substrate structure using the better annealed poly-SiGe film process showed improved performance by nearly 70%, 96% in responsivity, and 85% in quantum efficiency, when compared to the non-annealed APS. The optimal avalanche multiplication factor curve of the APS developed under the exponent of n = 3 condition can be improved with an increase in uniformity corresponding to the APS-junction voltage. This finding is promising and can be adopted in future photo-sensing and optical communication applications.

Group conquers efficacy: Preschoolers' imitation under conflict between minimal group membership and behavior efficacy.

Research has found that preschoolers' imitation demonstrates in-group bias and is guided by behavior efficacy. However, little is known about whether children's sensitivity to behavior efficacy affects their in-group imitation. This study aimed to investigate preschoolers' imitation tendency when group preference and behavior efficacy are in conflict. Participants were 4-year-old (N = 72) and 6-year-old (N = 72) preschoolers in China. They observed two demonstrators (one in-group and one out-group) pressing two different buttons, respectively, to turn on a music box, and were then asked to try it themselves. In the experimental condition, the out-group demonstrator always succeeded, whereas the in-group demonstrator failed half the time. The results showed that more 6-year-old children imitated the less-effective behaviors of the in-group demonstrator, whereas 4-year-old children showed no such inclination. Two control conditions confirmed that children chose to imitate in-group rather than out-group members (Control 1: both in-group and out-group demonstrators succeeded all four times), and could imitate according to efficacy (Control 2: two in-group demonstrators succeeded two and four times, respectively). These results indicated that 6-year-olds faithfully followed the in-group modeled behavior, regardless of behavior efficacy. Results are discussed through the social function of in-group imitative learning.

Joint Bearing and Range Estimation of Multiple Objects from Time-Frequency Analysis.

Direction-of-arrival (DOA) and range estimation is an important issue of sonar signal processing. In this paper, a novel approach using Hilbert-Huang transform (HHT) is proposed for joint bearing and range estimation of multiple targets based on a uniform linear array (ULA) of hydrophones. The structure of this ULA based on micro-electro-mechanical systems (MEMS) technology, and thus has attractive features of small size, high sensitivity and low cost, and is suitable for Autonomous Underwater Vehicle (AUV) operations. This proposed target localization method has the following advantages: only a single snapshot of data is needed and real-time processing is feasible. The proposed algorithm transforms a very complicated nonlinear estimation problem to a simple nearly linear one via time-frequency distribution (TFD) theory and is verified with HHT. Theoretical discussions of resolution issue are also provided to facilitate the design of a MEMS sensor with high sensitivity. Simulation results are shown to verify the effectiveness of the proposed method.

Spinal SIRPα1-SHP2 interaction regulates spinal nerve ligation-induced neuropathic pain via PSD-95-dependent NR2B activation in rats.

The fact that neuropathic pain mechanisms are not well understood is a major impediment in the development of effective clinical treatments. We examined whether the interaction between signal regulatory protein alpha 1 (SIRPα1) and Src homology-2 domain-containing protein tyrosine phosphatase 2 (SHP2), and the downstream spinal SHP2/postsynaptic density 95 (PSD-95)/N-methyl-d-aspartate receptor NR2B subunit signaling cascade play a role in neuropathic pain. Following spinal nerve ligation (L5), we assessed tactile allodynia using the von Frey filament test and analyzed dorsal horn samples (L4-5) by Western blotting, reverse transcription polymerase chain reaction, coimmunoprecipitation, and immunofluorescence. Nerve ligation induced allodynia, SIRPα1, SHP2, phosphorylated SHP2 (pSHP2), and phosphorylated NR2B (pNR2B) expression, and SHP2-PSD-95, pSHP2-PSD-95, PSD-95-NR2B, and PSD-95-pNR2B coimmunoprecipitation in the ipsilateral dorsal horn. In allodynic rats, injury-induced SHP2 immunoreactivity was localized in the ipsilateral dorsal horn neurons and coincident with PSD-95 and NR2B immunoreactivity. SIRPα1 silencing using small interfering RNA (siRNA; 1, 3, or 5µg/rat for 7days) prevented injury-induced allodynia and the associated changes in protein expression, phosphorylation, and coimmunoprecipitation. Intrathecal administration of NSC-87877 (an SHP2 antagonist; 1, 10, or 100µM/rat) and SIRPα1-neutralizing antibodies (1, 10, or 30µg/rat) suppressed spinal nerve ligation-induced allodynia, spinal SHP2 and NR2B phosphorylation, and SHP2/phosphorylated SHP2-PSD-95 and PSD-95-NR2B/phosphorylated NR2B coprecipitation. SHP2 siRNA led to similar effects as the NSC-87877 and SIRPα1 antibody treatments, except it prevented the allodynia-associated spinal SHP2 expression. In conclusion, our results suggest that a spinal SIRPα1-SHP2 interaction exists that subsequently triggers SHP2/PSD-95/NR2B signaling, thereby playing a role in neuropathic pain development.

EphrinB2 induces pelvic-urethra reflex potentiation via Src kinase-dependent tyrosine phosphorylation of NR2B.

Recently, the role of EphB receptor (EphBR) tyrosine kinase and their ephrinB ligands in pain-related neural plasticity at the spinal cord level have been identified. To test whether Src-family tyrosine kinase-dependent glutamatergic N-methyl-d-aspartate receptor NR2B subunit phosphorylation underlies lumbosacral spinal EphBR activation to mediate pelvic-urethra reflex potentiation, we recorded external urethra sphincter electromyogram reflex activity and analyzed protein expression in the lumbosacral (L(6)-S(2)) dorsal horn in response to intrathecal ephrinB2 injections. When compared with vehicle solution, exogenous ephrinB2 (5 µg/rat it)-induced reflex potentiation, in associated with phosphorylation of EphB1/2, Src-family kinase, NR2B Y1336 and Y1472 tyrosine residues. Both intrathecal EphB1 and EphB2 immunoglobulin fusion protein (both 10 µg/rat it) prevented ephrinB2-dependent reflex potentiation, as well as protein phosphorylation. Pretreatment with PP2 (50 µM, 10 µl it), an Src-family kinase antagonist, reversed the reflex potentiation, as well as Src kinase and NR2B phosphorylation. Together, these results suggest the ephrinB2-dependent EphBR activation, which subsequently provokes Src kinase-mediated N-methyl-d-aspartate receptor NR2B phosphorylation in the lumbosacral dorsal horn, is crucial for the induction of spinal reflex potentiation contributing to the development of visceral pain and/or hyperalgesia in the pelvic area.

Intrathecal cdk5 inhibitor, roscovitine, attenuates morphine antinociceptive tolerance in rats.

AIM: To investigate the effect of cyclin-dependent kinase 5 (Cdk5) inhibitor roscovitine on the morphine antinociceptive tolerance development in rats. METHODS: Tail-flick test as pain threshold measurement and intrathecal injection techniques were used. RESULTS: Intrathecal roscovitine infusion alone produced an antinociceptive effect. Tolerance was induced by continuous intrathecal infusion of morphine 5 microg/h for 5 d. Co-administration of intrathecal roscovitine 1 microg/h for 5 d enhanced the morphine antinociceptive effect in tolerant rats. It also caused a shift in the morphine antinociceptive dose-response curve to the left when co-administered with morphine during tolerance induction, and caused a 67 % reduction in the increase in the ED50 of morphine (dose producing 50 % of the maximum response). CONCLUSION: Cdk5 modulation is involved in the antinociceptive tolerance of morphine. Intrathecal roscovitine administration could attenuate this tolerance development.