RESUMEN
BACKGROUND: Bone grafting is the standard treatment for critical bone defects, but autologous grafts have limitations like donor site morbidity and limited availability, while commercial artificial grafts may have poor integration with surrounding bone tissue, leading to delayed healing. Magnesium deficiency negatively impacts angiogenesis and bone repair. Therefore, incorporating magnesium into a synthetic biomaterial could provide an excellent bone substitute. This study aims to evaluate the morphological, mechanical, and biological properties of a calcium phosphate cement (CPC) sponge composed of tetracalcium phosphate (TTCP) and monocalcium phosphate monohydrate (MCPM), which could serve as an excellent bone substitute by incorporating magnesium. METHODS: This study aims to develop biomedical materials composed mainly of TTCP and MCPM powder, magnesium powder, and collagen. The materials were prepared using a wet-stirred mill and freeze-dryer methods. The particle size, composition, and microstructure of the materials were investigated. Finally, the biological properties of these materials, including 3-(4,5-dimethylthiazol-2-yl)-2,5- diphenyltetrazolium bromide (MTT) assay for biocompatibility, effects on bone cell differentiation by alkaline phosphatase (ALP) activity assay and tartrate-resistant acid phosphatase (TRAP) activity assay, and endothelial cell tube formation assay for angiogenesis, were evaluated as well. RESULTS: The data showed that the sub-micron CPC powder, composed of TTCP/MCPM in a 3.5:1 ratio, had a setting time shorter than 15 minutes and a compressive strength of 4.39±0.96 MPa. This reveals that the sub-micron CPC powder had an adequate setting time and mechanical strength. We found that the sub-micron CPC sponge containing magnesium had better biocompatibility, including increased proliferation and osteogenic induction effects without cytotoxicity. The CPC sponge containing magnesium also promoted angiogenesis. CONCLUSION: In summary, we introduced a novel CPC sponge, which had a similar property to human bone promoted the biological functions of bone cells, and could serve as a promising material used in bone regeneration for critical bone defects.
RESUMEN
Rapid detection of the handiness of chiral molecules is an important topic for pharmaceutical industries because chiral drugs with opposing handiness sometimes exhibit unwanted side effects. In this research, a rapid optical method is proposed to determine the handiness of the chiral drug "Thalidomide". The platform is a large array of three-dimensional (3D) twisted metamaterials fabricated with a novel method by combining nanospherical-lens lithography (NLL) and hole-mask lithography (HML). The fabrication is high-throughput and the twisted metamaterials cover a large area. Strong circular dichroism (CD) response is observed in the near-infrared (NIR) region, which enables the chiral detection to be performed by a low-cost and portable spectroscope system. The proposed nanofabrication method significantly improves the capabilities of NLL and HML, which can be quickly adapted to fabricate various periodic 3D metamaterials. In addition, the results of this research pave the road for the rapid penetration of nanophotonics into the pharmaceutical industries.
Asunto(s)
Nanoestructuras/química , Talidomida/química , Dicroismo Circular/métodos , EstereoisomerismoRESUMEN
We present a polarization Linnik interference microscope with a nematic liquid-crystal (NLC) phase shifter for full-field optical coherence tomography of high-quality images. The rotating half-wave plate in conventional achromatic phase shifters was replaced by three liquid-crystal (LC) half-wave plates for implementing three-step phase-shifting interferometry. Thus, the NLC device generates phase shifts quickly and has no vibrations. In addition, the phase shift can be set to an arbitrary value between 0 and 2π by altering the azimuth angles of the LC cells. A tomographic image is retrieved from three sequential phase-shifted interferograms by using a three-step algorithm. The experimental results confirm the feasibility of the proposed technology.