RESUMEN
Poisson's ratio has not been experimentally measured earlier for meniscus in compression. It is however an important intrinsic material property needed in biomechanical analysis and computational models. In this study, equilibrium Poisson's ratio of bovine meniscus (nâ¯=â¯6) was determined experimentally by combining stress-relaxation measurements in unconfined and confined compression geometries. The average Young's modulus, aggregate modulus and Poisson's ratio were 0.182⯱â¯0.086â¯MPa, 0.252⯱â¯0.089â¯MPa and 0.316⯱â¯0.040, respectively. These moduli are consistent with previously determined values, but the Poisson's ratio is higher than determined earlier for meniscus in compression through biomechanical modelling analysis. This new experimentally determined Poisson's ratio value could be used in the analysis of biomechanical data as well as in computational finite element analysis when the Poisson's ratio is needed as an input for the analysis.
Asunto(s)
Fuerza Compresiva , Menisco , Animales , Fenómenos Biomecánicos , Bovinos , Módulo de Elasticidad , Análisis de Elementos Finitos , Distribución de Poisson , Estrés MecánicoRESUMEN
OBJECTIVE: Meniscal injuries can lead to mechanical overloading of articular cartilage and eventually to knee osteoarthritis. The objective was to evaluate the potential of contrast enhanced computed tomography (CECT) to image contrast agent (CA) diffusion in human menisci with a clinical cone beam CT scanner. DESIGN: Isolated human menisci (n = 26) were imaged using magnetic resonance imaging (MRI) and CECT in situ. Diffusion of anionic CA into the meniscus was imaged for up to 30 h. The results of CECT were compared with water, collagen and proteoglycan (PG) contents, biomechanical properties, age and histological and MR images of the samples. RESULTS: Diffusion of CA required over 25 h to reach equilibrium. The CA partition (the CA concentration in the tissue divided by that in the bath) at the 40 min time point correlated significantly with that at the 30 h time point in both lateral (r = 0.706, P = 0.007) and medial (r = 0.669, P = 0.012) menisci. Furthermore, CA partition in meniscus after 30 h of diffusion agreed qualitatively with the distribution of PGs. CONCLUSION: The cross-sectional distribution of CA was consistent with that reported in a previous µCT study on bovine meniscus. The time required to reach diffusion equilibrium was found impractical for clinical applications. However, based on the present results, shorter delay between injection and imaging (e.g., 40 min) could be feasible in clinical diagnostics of meniscal pathologies.
Asunto(s)
Tomografía Computarizada de Haz Cónico , Medios de Contraste , Meniscos Tibiales/anatomía & histología , Meniscos Tibiales/diagnóstico por imagen , Adulto , Factores de Edad , Anciano , Fenómenos Biomecánicos , Agua Corporal/metabolismo , Cadáver , Colágeno/metabolismo , Femenino , Humanos , Hidroxiprolina/metabolismo , Imagen por Resonancia Magnética , Masculino , Meniscos Tibiales/metabolismo , Persona de Mediana Edad , Ácidos Urónicos/metabolismo , Adulto JovenRESUMEN
Meniscus adapts to joint loads by depth- and site-specific variations in its composition and structure. However, site-specific mechanical characteristics of intact meniscus under compression are poorly known. In particular, mechanical nonlinearities caused by different meniscal constituents (collagen and fluid) are not known. In the current study, in situ indentation testing was conducted to determine site-specific elastic, viscoelastic and poroelastic properties of intact human menisci. Lateral and medial menisci (n=26) were harvested from the left knee joint of 13 human cadavers. Indentation tests, using stress-relaxation and dynamic (sinusoidal) loading protocols, were conducted for menisci at different sites (anterior, middle, posterior, n=78). Sample- and site-specific axisymmetric finite element models with fibril-reinforced poroelastic properties were fitted to the corresponding stress-relaxation curves to determine the mechanical parameters. Elastic moduli, especially the instantaneous and dynamic moduli, showed site-specific variation only in the medial meniscus (p<0.05 between the sites). The instantaneous and dynamic elastic moduli of the anterior horn were significantly (p<0.05) greater in the medial than lateral meniscus. The phase angle showed no statistically significant variation between the sites (p>0.05). The values for the strain-dependent fibril network modulus (nonlinear behaviour of collagen) were significantly different (p<0.05) between all sites in the medial menisci. Additionally, there was a significant difference (p<0.01) in the strain-dependent fibril network modulus between the lateral and medial anterior horns. The initial permeability was significantly different (p<0.05) in the medial meniscus only between the middle and posterior sites. For the strain-dependent permeability coefficient, only anterior and middle sites showed a significant difference (p<0.05) in the medial meniscus. This parameter demonstrated a significant difference (p<0.05) between lateral and medial menisci at the anterior horns. Our results reveal that under in situ indentation loading, medial meniscus shows more site-dependent variation in the mechanical properties as compared to lateral meniscus. In particular, anterior horn of medial meniscus was the stiffest and showed the most nonlinear mechanical behaviour. The nonlinearity was related to both collagen fibrils and fluid.
Asunto(s)
Colágeno/fisiología , Meniscos Tibiales/fisiología , Adulto , Anciano , Fenómenos Biomecánicos , Módulo de Elasticidad , Femenino , Humanos , Masculino , Persona de Mediana Edad , Líquido Sinovial/fisiología , Viscosidad , Adulto JovenRESUMEN
Nonlinear, linear and failure properties of articular cartilage and meniscus in opposing contact surfaces are poorly known in tension. Relationships between the tensile properties of articular cartilage and meniscus in contact with each other within knee joints are also not known. In the present study, rectangular samples were prepared from the superficial lateral femoral condyle cartilage and lateral meniscus of bovine knee joints. Tensile tests were carried out with a loading rate of 5mm/min until the tissue rupture. Nonlinear properties of the toe region, linear properties in larger strains, and failure properties of both tissues were analysed. The strain-dependent tensile modulus of the toe region, Young's modulus of the linear region, ultimate tensile stress and toughness were on average 98.2, 8.3, 4.0 and 1.9 times greater (p<0.05) for meniscus than for articular cartilage. In contrast, the toe region strain, yield strain and failure strain were on average 9.4, 3.1 and 2.3 times greater (p<0.05) for cartilage than for meniscus. There was a significant negative correlation between the strain-dependent tensile moduli of meniscus and articular cartilage samples within the same joints (r=-0.690, p=0.014). In conclusion, the meniscus possesses higher nonlinear and linear elastic stiffness and energy absorption capability before rupture than contacting articular cartilage, while cartilage has longer nonlinear region and can withstand greater strains before failure. These findings point out different load carrying demands that both articular cartilage and meniscus have to fulfil during normal physiological loading activities of knee joints.