Dynamic structural twist in metal-organic frameworks enhances solar overall water splitting.

Photocatalytic overall water splitting holds great promise for solar-to-hydrogen conversion. Maintaining charge separation is a major challenge but is key to unlocking this potential. Here we discovered a metal-organic framework (MOF) that shows suppressed charge recombination. This MOF features electronically insulated Zn2+ nodes and two chemically equivalent, yet crystallographically independent, linkers. These linkers behave as an electron donor-acceptor pair with non-overlapping band edges. Upon photoexcitation, the MOF undergoes a dynamic excited-state structural twist, inducing orbital rearrangements that forbid radiative relaxation and thereby promote a long-lived charge-separated state. As a result, the MOF achieves visible-light photocatalytic overall water splitting, in the presence of co-catalysts, with an apparent quantum efficiency of 3.09 ± 0.32% at 365 nm and shows little activity loss in 100 h of consecutive runs. Furthermore, the dynamic excited-state structural twist is also successfully extended to other photocatalysts. This strategy for suppressing charge recombination will be applicable to diverse photochemical processes beyond overall water splitting.

Charge redistribution of a spatially differentiated ferroelectric Bi4Ti3O12 single crystal for photocatalytic overall water splitting.

Artificial photosynthesis is a promising approach to produce clean fuels via renewable solar energy. However, it is practically constrained by two issues of slow photogenerated carrier migration and rapid electron/hole recombination. It is also a challenge to achieve a 2:1 ratio of H2 and O2 for overall water splitting. Here we report a rational design of spatially differentiated two-dimensional Bi4Ti3O12 nanosheets to enhance overall water splitting. Such a spatially differentiated structure overcomes the limitation of charge transfer across different crystal planes in a single crystal semiconductor. The experimental results show a redistribution of charge within a crystal plane. The resulting photocatalyst produces 40.3 µmol h-1 of hydrogen and 20.1 µmol h-1 of oxygen at a near stoichiometric ratio of 2:1 and a solar-to-hydrogen efficiency of 0.1% under simulated solar light.

Boron-incorporated nanosized SUZ-4 zeolite for DME carbonylation.

Boron-incorporated nanosized HB-SUZ-4 showcased a noteworthy 24% boost in dimethyl ether carbonylation, with an elevation in methyl acetate selectivity from 91.8% to 96.0%. The improved performance is attributed to shortened diffusion lengths along the 8-member ring channels, decreased Brønsted acidity in the 10-member ring channels, and Lewis acid sites stabilizing CO.

The Ferroelectric Effects of Rhombohedral and Tetragonal BiFeO3 in Photoelectrochemical Water Splitting.

The phase of BiFeO3 (BFO) as well as its domain configuration can be tuned by strain engineering. Phase change may greatly influence the properties of the polarization field and hence charge separation. However, the photoelectrochemical properties of different BFO phases have rarely been addressed. Here, the photoelectrochemical study of tetragonal (T-) and rhombohedral (R-) phase BFO films was conducted under visible light illumination. The photocurrent density of R-BFO is 5 times that of T-BFO. A ferroelectric domain study shows that T-BFO features single domain structure in contrast to the polydomain structure of R-BFO. Higher charge separation efficiency is achieved in R-BFO, dominated by the domain walls as conducting pathways for efficient charge separation and transfer. This work provides a fundamental understanding of the photoelectrochemical properties of T- and R-BFO, offering valuable insights for the development of BFO-based materials for solar energy conversion.

New Alkalescent Electrolyte Chemistry for Zinc-Ferricyanide Flow Battery.

Alkaline zinc-ferricyanide flow batteries are efficiency and economical as energy storage solutions. However, they suffer from low energy density and short calendar life. The strongly alkaline conditions (3 mol L-1 OH-) reduce the solubility of ferri/ferro-cyanide (normally only 0.4 mol L-1 at 25 °C) and induce the formation of zinc dendrites at the anode. Here, we report a new zinc-ferricyanide flow battery based on a mild alkalescent (pH 12) electrolyte. Using a chelating agent to rearrange ferri/ferro-cyanide ion-solvent interactions and improve salt dissociation, we increased the solubility of ferri/ferro-cyanide to 1.7 mol L-1 and prevented zinc dendrites. Our battery has an energy density of ~74 Wh L-1 catholyte at 60 °C and remains stable for 1800 cycles (1800 hours) at 0 °C and for >1400 cycles (2300 hours) at 25 °C. An alkalescent zinc-ferricyanide cell stack built using this alkalescent electrolyte stably delivers 608 W of power for ~40 days.

Surface photovoltage microscopy for mapping charge separation on photocatalyst particles.

Solar-driven photocatalytic reactions offer a promising route to clean and sustainable energy, and the spatial separation of photogenerated charges on the photocatalyst surface is the key to determining photocatalytic efficiency. However, probing the charge-separation properties of photocatalysts is a formidable challenge because of the spatially heterogeneous microstructures, complicated charge-separation mechanisms and lack of sensitivity for detecting the low density of separated photogenerated charges. Recently, we developed surface photovoltage microscopy (SPVM) with high spatial and energy resolution that enables the direct mapping of surface-charge distributions and quantitative assessment of the charge-separation properties of photocatalysts at the nanoscale, potentially providing unprecedented insights into photocatalytic charge-separation processes. Here, this protocol presents detailed procedures that enable researchers to construct the SPVM instruments by integrating Kelvin probe force microscopy with an illumination system and the modulated surface photovoltage (SPV) approach. It then describes in detail how to perform SPVM measurements on actual photocatalyst particles, including sample preparation, tuning of the microscope, adjustment of the illuminated light path, acquisition of SPVM images and measurements of spatially resolved modulated SPV signals. Moreover, the protocol also includes sophisticated data analysis that can guide non-experts in understanding the microscopic charge-separation mechanisms. The measurements are ordinarily performed on photocatalysts with a conducting substrate in gases or vacuum and can be completed in 15 h.

Liquid metal-embraced photoactive films for artificial photosynthesis.

The practical applications of solar-driven water splitting pivot on significant advances that enable scalable production of robust photoactive films. Here, we propose a proof-of-concept for fabricating robust photoactive films by a particle-implanting technique (PiP) which embeds semiconductor photoabsorbers in the liquid metal. The strong semiconductor/metal interaction enables resulting films efficient collection of photogenerated charges and superior photoactivity. A photoanode of liquid-metal embraced BiVO4 can stably operate over 120 h and retain ~ 70% of activity when scaled from 1 to 64 cm2. Furthermore, a Z-scheme photocatalyst film of liquid-metal embraced BiVO4 and Rh-doped SrTiO3 particles can drive overall water splitting under visible light, delivering an activity 2.9 times higher than that of the control film with gold support and a 110 h stability. These results demonstrate the advantages of the PiP technique in constructing robust and efficient photoactive films for artificial photosynthesis.

Bio-inspired Two-dimensional Nanofluidic Ionic Transistor for Neuromorphic Signal Processing.

Voltage-gated ion channels prevalent in neurons play important roles in generating action potential and information transmission by responding to transmembrane potential. Fabricating bio-inspired ionic transistors with ions as charge carriers will be crucial for realizing neuro-inspired devices and brain-liking computing. Here, we reported a two-dimensional nanofluidic ionic transistor based on a MXene membrane with sub-1 nm interlayer channels. By applying a gating voltage on the MXene nanofluidic, a transmembrane potential will be generated to active the ionic transistor, which is similar to the transmembrane potential of neuron cells and can be effectively regulated by changing membrane parameters, e.g., thickness, composition, and interlayer spacing. For the symmetric MXene nanofluidic, a high on/off ratio of ~2000 can be achieved by forming an ionic depletion or accumulation zone, contingent on the sign of the gating potential. An asymmetric PET/MXene-composited nanofluidic transitioned the ionic transistor from ambipolar to unipolar, resulting in a more sensitive gate voltage characteristic with a low subthreshold swing of 560 mV/decade. Furthermore, ionic logic gate circuits, including the "NOT", "NAND", and "NOR" gate, were implemented for neuromorphic signal processing successfully, which provides a promising pathway towards highly parallel, low energy consumption, and ion-based brain-like computing.