RESUMEN
The adjustable structures and remarkable physicochemical properties of 2D monoelemental materials, such as silicene and germanene, have attracted significant attention in recent years. They can be transformed into silicane (SiH) and germanane (GeH) through covalent functionalization via hydrogen atom termination. However, synthesizing these materials with a scalable and low-cost fabrication process to achieve high-quality 2D SiH and GeH poses challenges. Herein, groundbreaking 2D SiH and GeH materials with varying compositions, specifically Si0.25Ge0.75H, Si0.50Ge0.50H, and Si0.75Ge0.25H, are prepared through a simple and efficient chemical exfoliation of their Zintl phases. These 2D materials offer significant advantages, including their large surface area, high mechanical flexibility, rapid electron mobility, and defect-rich loose-layered structures. Among these compositions, the Si0.50Ge0.50H electrode demonstrates the highest discharge capacity, reaching up to 1059 mAh g-1 after 60 cycles at a current density of 75 mA g-1. A comprehensive ex-situ electrochemical analysis is conducted to investigate the reaction mechanisms of lithiation/delithiation in Si0.50Ge0.50H. Subsequently, an initial assessment of the c-Li15(SixGe1- x)4 phase after lithiation and the a-Si0.50Ge0.50 phase after delithiation is presented. Hence, this study contributes crucial insights into the (de)lithiation reaction mechanisms within germanane-silicane alloys. Such understanding is pivotal for mastering promising materials that amalgamate the finest properties of silicon and germanium.
RESUMEN
2D monoelemental materials, particularly germanene and silicene (the single layer of germanium and silicon), which are the base materials for modern electronic devices demonstrated tremendous attraction for their 2D layer structure along with the tuneable electronics and optical band gap. The major shortcoming of synthesized thermodynamically very unstable layered germanene and silicene with their inclination toward oxidation was overcome by topochemical deintercalation of a Zintl phase (CaGe2, CaGe1.5Si0.5, and CaGeSi) in a protic environment. The exfoliated Ge-H, Ge0.75Si0.25H, and Ge0.5Si0.5H were successfully synthesized and employed as the active layer for photoelectrochemical photodetectors, which showed broad response (420-940 nm), unprecedented responsivity, and detectivity on the order of 168 µA W-1 and 3.45 × 108 cm Hz1/2 W-1, respectively. The sensing capability of exfoliated germanane and silicane composites was explored using electrochemical impedance spectroscopy with ultrafast response and recovery time of less than 1 s. These positive findings serve as the application of exfoliated germanene and silicene composites and can pave a new path to practical applications in efficient future devices.
RESUMEN
Since the first synthesis of germanane (GeH) reported in 2013, two-dimensional germanium-based materials have been intensively studied. Over the past decade, several methodologies for the functionalization of germanane have been introduced. The first approach utilized exfoliation of Zintl phase CaGe2 with alkyl halides. Liu's solvothermal method was used for the synthesis of methyl germanane. Another methodology utilized Ge-H activation with sodium naphthalenide and its subsequent alkylation. All of these methods provide functionalized germananes; thus, a comparison of these methods is needed. In this paper, such a comparison of current synthetic approaches towards alkyl germananes is reported, and additionally, a new method for Ge-H activation utilizing a NaK equimolar alloy is presented as a fourth approach. For this purpose, eight alkyl reagents were chosen representing reactive benzyl bromides as well as linear esters and nitriles because they contain easily trackable functional groups. The materials were characterized using Fourier transform infrared spectroscopy, Raman spectroscopy, X-ray photoelectron spectroscopy, and thermogravimetric analysis, and the data were compared. The comparison of all methods revealed not only some drawbacks for each method but also their advantages. The method utilizing sodium naphthalenide provided the lowest degree of surface coverage, whereas the solvothermal method seemed to provide materials with the highest degree of functionalization; unfortunately, the functionalization was also accompanied by a high degree of surface oxidation, i.e., (Ge-OH/GeâO) formation. The highest degree of surface coverage accompanied by the lowest degree of surface oxidation was achieved employing Goldberger's phase transfer direct exfoliation of CaGe2 as well as Ge-H activation using the NaK alloy with subsequent alkylation.
RESUMEN
Flavinium salts are frequently used in organocatalysis but their application in photoredox catalysis has not been systematically investigated to date. We synthesized a series of 5-ethyl-1,3-dimethylalloxazinium salts with different substituents in the positions 7 and 8 and investigated their application in light-dependent oxidative cycloelimination of cyclobutanes. Detailed mechanistic investigations with a coumarin dimer as a model substrate reveal that the reaction preferentially occurs via the triplet-born radical pair after electron transfer from the substrate to the triplet state of an alloxazinium salt. The very photostable 7,8-dimethoxy derivative is a superior catalyst with a sufficiently high oxidation power (E*=2.26â V) allowing the conversion of various cyclobutanes (with Eox up to 2.05â V) in high yields. Even compounds such as all-trans dimethyl 3,4-bis(4-methoxyphenyl)cyclobutane-1,2-dicarboxylate can be converted, whose opening requires a high activation energy due to a missing pre-activation caused by bulky adjacent substituents in cis-position.
RESUMEN
Germanium, with a high theoretical capacity based on alloyed lithium and germanium (1384 mA h g-1 Li15Ge4), has stimulated tremendous research as a promising candidate anode material for lithium-ion batteries (LIBs). However, due to the alloying reaction of Li/Ge, the problems of inferior cycle life and massive volume expansion of germanium are equally obvious. Among all Ge-based materials, the unique layered 2D germanane (GeH and GeCH3) with a graphene-like structure, obtained by a chemical etching process from the Zintl phase CaGe2, could enable storage of large quantities of lithium between their interlayers. Besides, the layered structure has the merit of buffering the volume expansion due to the tunable interlayer spacing. In this work, the beyond theoretical capacities of 1637 mA h g-1 for GeH and 2048 mA h g-1 for GeCH3 were achieved in the initial lithiation reaction. Unfortunately, the dreadful capacity fading and electrode fracture happened during the subsequent electrochemical process. A solution, i.e. introducing single-wall carbon nanotubes (SWCNTs) into the structure of the electrodes, was found and further confirmed to improve their electrochemical performance. More noteworthy is the GeH/SWCNT flexible electrode, which exhibits a capacity of 1032.0 mA h g-1 at a high current density of 2000 mA g-1 and a remaining capacity of 653.6 mA h g-1 after 100 cycles at 500 mA g-1. After 100 cycles, the hybrid germanane/SWCNT electrodes maintained good integrity without visible fractures. These results indicate that introducing SWCNTs into germanane effectively improves the electrochemical performance and maintains the integrity of the electrodes for LIBs.
RESUMEN
Photoelectrochemical (PEC) systems represent powerful tools to convert electromagnetic radiation into chemical fuels and electricity. In this context, two-dimensional (2D) materials are attracting enormous interest as potential advanced photo(electro)catalysts and, recently, 2D group-IVA metal monochalcogenides have been theoretically predicted to be water splitting photocatalysts. In this work, we use density functional theory calculations to theoretically investigate the photocatalytic activity of single-/few-layer GeSe nanoflakes for both the hydrogen evolution reaction (HER) and the oxygen evolution reaction (OER) in pH conditions ranging from 0 to 14. Our simulations show that GeSe nanoflakes with different thickness can be mixed in the form of nanoporous films to act as nanoscale tandem systems, in which the flakes, depending on their thickness, can operate as HER- and/or OER photocatalysts. On the basis of theoretical predictions, we report the first experimental characterization of the photo(electro)catalytic activity of single-/few-layer GeSe flakes in different aqueous media, ranging from acidic to alkaline solutions: 0.5 M H2SO4 (pH 0.3), 1 M KCl (pH 6.5), and 1 M KOH (pH 14). The films of the GeSe nanoflakes are fabricated by spray coating GeSe nanoflakes dispersion in 2-propanol obtained through liquid-phase exfoliation of synthesized orthorhombic (Pnma) GeSe bulk crystals. The PEC properties of the GeSe nanoflakes are used to design PEC-type photodetectors, reaching a responsivity of up to 0.32 AW-1 (external quantum efficiency of 86.3%) under 455 nm excitation wavelength in acidic electrolyte. The obtained performances are superior to those of several self-powered and low-voltage solution-processed photodetectors, approaching that of self-powered commercial UV-Vis photodetectors. The obtained results inspire the use of 2D GeSe in proof-of-concept water photoelectrolysis cells.
RESUMEN
Two-dimensional materials attract enormous attention across several scientific fields. The current demands in nano- and optoelectronics, semiconductors, or in catalysis have been accelerating the research process in the field of 2D materials. Among the 14th group 2D materials besides graphene and silicene, layered germanium represents a promising candidate for another class of materials, and its functionalization represents a way to tune either its electronic or optical properties. Here, the exfoliation and functionalization of germanane surface is achieved via abstraction of hydrogen from Ge-H bond and its subsequent alkylation utilizing n-alkyl halides or trifluoromethyl (CF3) group containing benzyl halides. Composition of materials is confirmed by several methods including FT-IR, Raman, X-ray photoelectron, and energy-dispersive X-ray spectroscopy as well as X-ray powder diffraction. Scanning and transmission electron spectroscopy is used to reveal the layered morphology of functionalized germananes.
RESUMEN
Black phosphorus (BP) in its monolayer form called phosphorene is thought of as a successor of graphene and is of great interest for (opto)electronic applications. A quantitative and scalable method for the synthesis of (mono-)few-layer phosphorene has been an outstanding challenge due to the process irreproducibility and environmental degradation capability of the BP. Here, we report a facile controlled electrochemical exfoliation method for the preparation of a few-layer phosphorene (FP) with nearly 100% yield. Our approach relies on the low-potential influence in anhydrous and oxygen-free low-boiling acetonitrile (AN) and N,N-dimethylformamide (DMF) using alkylammonium ions. Herein, intercalation of positive ions into BP interlayers occurred with a minimum potential of -2.95 V in DMF and -2.85 V in AN and the non-damaging and highly accurate electrochemical exfoliation lasted at -3.8 V. A variety of analytical methods have revealed that in particular DMF-based exfoliation results in high-quality phosphorene of 1-5 layers with good crystallinity and lateral sizes up to tens of micrometers. Moreover, assurance of the oxygen- and water-free environment allowed us to minimize the surface oxidation of BP and, consequently, exfoliated phosphorene. We pioneer an effective and reproducible printing transfer of electrochemically exfoliated phosphorene films onto various flexible and rigid substrates. The surfactant-free process of exfoliation allowed assembly and transfer of thin films based on FP. The phosphorene-based films characterized as direct gap semiconductors have a layer-number-dependent bandgap with a tuning range larger than that of other 2D materials. We show that on varying the films' thickness, it is possible to modify their optical properties, which is a significant advantage for compact and switchable optoelectronic components.
RESUMEN
The rediscovery of graphene in 2004 has started an enormous chase in the research of 2D materials. A new family of layered 2D materials consisting of the 14th group elements beyond carbon has already been reported. Here, a new methodology in germanene chemistry is presented using germanane (Ge6 H6 ) as a stable and easily accessible starting material for effective synthesis of novel germanene derivatives. The modification procedure utilizing strong bases-alkali metal arenides-for deprotonation of germanane and its subsequent functionalization with p-nitrobenzyl bromide is described. Functionalization of germanene is confirmed by FT-IR, Raman, and XPS spectroscopy as well as by X-ray diffraction analysis.
RESUMEN
Two-dimensional materials have been extensively studied over the last two decades as they represent a class of materials with properties applicable in catalysis, sensing, optical devices, nanoelectronics, supercapacitors, and semiconductors. The properties of 2D materials can be tuned by exfoliation into mono- or few-layered systems and mainly by surface modification, which can result, for example, in altering the band gap or enhancing material stability toward degradation. This review focuses on the derivatization of group 14 layered materials beyond graphene silicene, germanene, and stanene and summarizes their preparation as well as chemical and physical properties. This review provides the current state-of-the-art in the field and provides a perspective for future development in the field of chemical derivatization of 2D materials beyond graphene.
RESUMEN
Layered black phosphorus has been attracting great attention due to its interesting material properties which lead to a plethora of proposed applications. Several approaches are demonstrated here for covalent chemical modifications of layered black phosphorus in order to form P-C and P-O-C bonds. Nucleophilic reagents are highly effective for chemical modification of black phosphorus. Further derivatization approaches investigated were based on radical reactions. These reagents are not as effective as nucleophilic reagents for the surface covalent modification of black phosphorus. The influence of covalent modification on the electronic structure of black phosphorus was investigated using ab initio calculations. Covalent modification exerts a strong effect on the electronic structure including the change of band-gap width and spin polarization.
RESUMEN
Two new photocatalytic systems based on flavinium species formed in situ by protonation of riboflavin-tetraacetate (1) with triflic acid or prepared in advance via alloxazine quaternization are presented as effective tools for oxidative cyclobutane ring [2 + 2] cycloreversion using visible light. The system with 1,3-dimethyl-8-trifluoromethylalloxazinium perchlorate (2c) was found to be superior allowing an acid-free mild procedure, which results in the opening of cyclobutanes with high oxidation potential (up to 2.14 V) and/or with sensitive groups (e.g., furan) without side reactions.