RESUMEN
A facile solution process was employed to prepare CsPbI3 as an anode material for Li-ion batteries. Rietveld refinement of the X-ray data confirms the orthorhombic phase of CsPbI3 at room temperature. As obtained from bond valence calculations, strained bonds between Pb and I are identified within PbI6 octahedral units. Morphological study shows that the as-prepared δ-CsPbI3 forms a nanorod-like structure. The XPS analysis confirm the presence of Cs (3d, 4d), Pb (4d, 4f, 5d) and I (3p, 3d, 4d). The lithiation process involves both intercalation and conversion reactions, as confirmed by cyclic voltammetry (CV) and first-principles calculations. Impedance spectroscopy coupled with the distribution function of relaxation times identifies charge transfer processes due to Li metal foil and anode/electrolyte interfaces. An initial discharge capacity of 151 mAhg-1 is found to continuously increase to reach a maximum of ~275 mAhg-1 at 65 cycles, while it drops to ~240 mAhg-1 at 75 cycles and then slowly decreases to 235 mAhg-1 at 100 cycles. Considering the performance and structural integrity during electrochemical performance, δ-CsPbI3 is a promising material for future Li-ion battery (LIB) application.
RESUMEN
Dissolution of lithium polysulfide (LiPS) into the electrolyte during discharging, causing shuttling of LiPS from the cathode to the lithium (Li) metal, is mainly responsible for the capacity decay and short battery life of lithium-sulfur batteries (LSBs). Herein, we designed a separator comprising polypropylene (PP) coated with MoO3 nanobelts (MNBs), prepared through facile grinding of commercial MoO3 powder. The formation of Li2Sn-MoO3 during discharging inhibited the polysulfide shuttling; during charging, Li passivated LixMoO3 facilitated ionic transfer during the redox reaction by decreasing the charge transfer resistance. This dual-interaction mechanism of LiPS-with both Mo and the formation of LixMoO3-resulted in a substantially high initial discharge capacity at a very high current density of 5C, with 29.4% of the capacity retained after 5000 cycles. The simple fabrication approach and extraordinary cycle life observed when using this MNB-coated separator suggest a scalable solution for future commercialization of LSBs.
RESUMEN
Despite issues related to dendrite formation, research on Li metal anodes has resurged because of their high energy density. In this study, graphene oxide (GO) layers are decorated onto Li metal anodes through a simple process of drop-casting and spray-coating. The self-assembly of GO is exploited to synthesize coatings having compact, mesoporous, and macroporous morphologies. The abilities of the GO coatings to suppress dendrite formation are compared through Li|Li symmetrical cell charging at a current density of 5 mA cm-2 for 2000 cycles-a particularly abusive test. The macroporous structure possesses the lowest impedance, whereas the compact structure excels in terms of stability. Moreover, GO exhibits a low nucleation overpotential and is transformed into reduced GO with enhanced conductivity during the operation of the cells; both factors synergistically mitigate the issue of dendrite formation. Li-S batteries incorporating the GO-decorated Li anodes exhibit an initial capacity of 850 mA h g-1 and maintain their stability for 800 cycles at a C-rate of 1 C (1675 mA h g-1), suggesting the applicability of GO in future rechargeable batteries.