RESUMEN
Hydroxyapatite (HA) promotes excellent bone regeneration in bone-tissue engineering, due to its similarity to bone mineral and its ability to connect to living tissues. These factors promote the osteointegration process. This process can be enhanced by the presence of electrical charges, stored in the HA. Furthermore, several ions can be added to the HA structure to promote specific biological responses, such as magnesium ions. The main objective of this work was to extract hydroxyapatite from sheep femur bones and to study their structural and electrical properties by adding different amounts of magnesium oxide. The thermal and structural characterizations were performed using DTA, XRD, density, Raman spectroscopy and FTIR analysis. The morphology was studied using SEM, and the electrical measurements were registered as a function of frequency and temperature. Results show that: (i) an increase of MgO amount indicates that the solubility of MgO is below 5%wt for heat treatments at 600 °C; (ii) the rise of MgO content increases the capacity for electrical charge storage; (iii) sheep hydroxyapatite presents itself as a natural source of hydroxyapatite, environmentally sustainable and low cost, and promising for applications in regenerative medicine.
RESUMEN
In this research, as an alternative to chemical and physical methods, environmentally and cost-effective antimicrobial zinc oxide nanoparticles (ZnO NP) were produced by the green synthesis method. The current study focuses on the production of ZnO NP starting from adequate precursor and Zingiber officinale aqueous root extracts (ginger). The produced ZnO NP was loaded into electrospun nanofibers at different concentrations for various tissue engineering applications such as wound dressings. The produced ZnO NPs and ZnO NP-loaded nanofibers were examined by Scanning Electron Microscopy (SEM) for morphological assessments and Fourier-transform infrared spectrum (FT-IR) for chemical assessments. The disc diffusion method was used to test the antimicrobial activity of ZnO NP and ZnO NP-loaded nanofibers against three representatives strains, Escherichia coli (Gram-negative bacteria), Staphylococcus aureus (Gram-positive bacteria), and Candida albicans (fungi) microorganisms. The strength and stretching of the produced fibers were assessed using tensile tests. Since water absorption and weight loss behaviors are very important in tissue engineering applications, swelling and degradation analyses were applied to the produced nanofibers. Finally, the MTT test was applied to analyze biocompatibility. According to the findings, ZnO NP-loaded nanofibers were successfully synthesized using a green precipitation approach and can be employed in tissue engineering applications such as wound dressing.
RESUMEN
Diabetic wounds have a slow healing process and easy to be infected. In addition to current drug treatments, supportive approaches are needed for diabetic wound treatment. In this study, we aimed to load Aloe Vera (AV) and Hypericum perforatum oil (HPO) with PCL/Ge (Poly (É-caprolactone)/Gelatine) polymeric biodegradable by electrospinning method into nanofiber dressings on an experimental diabetic wound model to compare the diabetic wound healing effect. Changes in the amount and chemical structure of phospholipids, proteins, and lipids were investigated in the blood and serum samples of the animals using Fourier transform infrared (FTIR) analysis. To evaluate biological events associated with the wound repair process in inflammatory phase we used oxidant and antioxidant status to determine the healing status of wounds such as Total antioxidant status (TAS), Total oxidant level (TOS) and tumor necrosis factor alpha (TNF-α) levels. TOS level increased in DM groups and decreased in the AV and HPO group. Oxidative stress index decreased and TNF-α level increased in the HPO group. FTIR spectra showed changes in the phospholipids, proteins, and carbon chain of lipids in the whole blood as well as serum of DM rats. FTIR spectra combined with Principal component analysis (PCA) showed, that treated DM rats by AV and HPO caused return chemical structure of blood and serum to this observed in control group. Higher similarity with control group for HPO rats was observed. HPO is better than AV in the alternative for healing on diabetic wound. Thus, we have demonstrated that IR spectroscopy and multivariate data analysis and biochemical assays are consistent and correlative with each other.
Asunto(s)
Aloe , Diabetes Mellitus , Hypericum , Nanofibras , Animales , Vendajes , Ratas , Cicatrización de HeridasRESUMEN
Natural calcium phosphates derived from fish wastes are a promising material for biomedical application. However, their sintered ceramics are not fully characterized in terms of mechanical and biological properties. In this study, natural calcium phosphate was synthesized through a thermal calcination process from salmon fish bone wastes. The salmon-derived calcium phosphates (sCaP) were sintered at different temperatures to obtain natural calcium phosphate bioceramics and then were investigated in terms of their microstructure, mechanical properties and biocompatibility. In particular, this work is concerned with the effects of grain size on the relative density and microhardness of the sCaP bioceramics. Ca/P ratio of the sintered sCaP ranged from 1.73 to 1.52 when the sintering temperature was raised from 1000 to 1300 °C. The crystal phase of all the sCaP bioceramics obtained was biphasic and composed of hydroxyapatite (HA) and tricalcium phosphate (TCP). The density and microhardness of the sCaP bioceramics increased in the temperature interval 1000-1100 °C, while at temperatures higher than 1100 °C, these properties were not significantly altered. The highest compressive strength of 116 MPa was recorded for the samples sintered at 1100 °C. In vitro biocompatibility was also examined in the behavior of osteosarcoma (Saos-2) cells, indicating that the sCaP bioceramics had no cytotoxicity effect. Salmon-derived biphasic calcium phosphates (BCP) have the potential to contribute to the development of bone substituted materials.
Asunto(s)
Materiales Biocompatibles/química , Neoplasias Óseas/patología , Sustitutos de Huesos/química , Huesos/química , Fosfatos de Calcio/farmacología , Cerámica/farmacología , Osteosarcoma/patología , Animales , Neoplasias Óseas/tratamiento farmacológico , Fosfatos de Calcio/química , Proliferación Celular , Cerámica/química , Humanos , Ensayo de Materiales , Osteosarcoma/tratamiento farmacológico , Salmón , Propiedades de Superficie , Células Tumorales CultivadasRESUMEN
BACKGROUND: We evaluated the Bovine hydroxyapatite (BHA) structure. BHA powder was admixed with 5 and 10 wt% natural pumice (NP). Compression strength, Vickers micro hardness, Fourier transform infrared spectroscopy, scanning electron microscopy (SEM) and X-ray diffraction studies were performed on the final NP-BHA composite products. The cells proliferation was investigated by MTT assay and SEM. Furthermore, the antimicrobial activity of NP-BHA samples was interrogated. RESULTS: Variances in the sintering temperature (for 5 wt% NP composites) between 1000 and 1300 °C, reveal about 700 % increase in the microhardness (~100 and 775 HV, respectively). Composites prepared at 1300 °C demonstrate the greatest compression strength with comparable result for 5 wt% NP content (87 MPa), which are significantly better than those for 10 wt% and those that do not include any NP (below 60 MPa, respectively). CONCLUSION: The results suggested the optimal parameters for the preparation of NP-BHA composites with increased mechanical properties and biocompatibility. Changes in micro-hardness and compression strength can be tailored by the tuning the NP concentration and sintering temperature. NP-BHA composites have demonstrated a remarkable potential for biomedical engineering applications such as bone graft and implant.