A strategy for evaluation of isotopic enrichment and structural integrity of deuterium labelled compounds by using HR-MS and NMR.

Determining the purity of deuterium labelled compounds is important due to the increasing use of these compounds in mass spectrometry (MS) based quantitative analyses for targeting metabolic flux, reducing toxicity, confirming reaction mechanisms during synthesis, predicting enzyme mechanisms, and enhancing the efficacy of drugs, in quantitative proteomics, and also as internal standards. In the present study, a strategy using liquid chromatography electrospray ionization high resolution mass spectrometry (LC-ESI-HR-MS) and nuclear magnetic resonance (NMR) spectroscopy was proposed to determine the isotopic enrichment and structural integrity of deuterium labelled compounds. The proposed strategy involves recording full scan MS, extracting and integrating isotopic ions, and calculating the isotopic enrichment of the desired labelled compounds. NMR analysis confirms structural integrity or positions of labelled atoms and can provide insights into the relative percent isotopic purity. This strategy was used to evaluate the isotopic enrichment and structural integrity of in-house synthesized compounds as well as a series of commercially available deuterium labelled compounds. The % isotopic purity for labelled compounds of a benzofuranone derivative (BEN-d2), tamsulosin-d4 (TAM-d4), oxybutynin-d5 (OXY-d5), eplerenone-d3 (EPL-d3), and propafenone-d7 (PRO-d7) was calculated and found to be 94.7, 99.5, 98.8, 99.9, and 96.5, respectively. All the samples were run in triplicate and the results were observed to be reproducible.

Isolation and characterization of pseudo degradation products of acalabrutinib using ESI-HRMS/MS and NMR: Formation of possible geometrical isomers.

A forced degradation study of acalabrutinib (ACB), used to treat relapsed mantle cell lymphoma, was performed to identify and characterize all possible major degradation products formed under different stress conditions. The degradation products (DP) were separated using reverse phase UHPLC system on Kinetex EVO C18 column. Major DPs formed were isolated using semi-preparative HPLC and characterized by LC-ESI-HRMS/MS and NMR. ACB degraded to form seven major degradants (DP-I to DP-VII). DP-I and DP-V were formed under alkaline stress condition, whereas DP-II, DP-III, DP-VI and DP-VII were formed under both acidic and basic conditions. Further, DP-IV was formed when ACB drug was exposed to hydrogen peroxide stress condition. ACB was found to be stable when subjected to aqueous (neutral pH), thermal and UV radiation of 254 nm, as it has not shown any significant degradation under these conditions. Interestingly, two pairs of pseudo geometrical isomeric DPs (DP-II and DP-III, DP-VI and DP-VII) were observed. The plausible degradation pathway of ACB and fragmentation patterns of both ACB and major DPs were discussed.

RP-HPLC separation of interconvertible rotamers of a 5-tetrahydroisoquinolin-6-yl-pyridin-3-yl acetic acid derivative and confirmation by VT NMR and DFT study.

Due to emergence of drug resistance and drug tolerability, there is urgent need for discovery of new chemical entity for the treatment of HIV infection. As a part of in-house small molecule drug discovery program for HIV infection, sodium-2-(tert-butoxy)- 2-(5-(2-(2-chloro-6-methylbenzyl)- 1,2,3,4-tetrahydroisoquinolin-6-yl)- 4-(4,4-dimethylpiperidin-1-yl)- 2,6-dimethylpyridin-3-yl) acetate (SCMTDDA) was prepared as an intermediate for the synthesis of an API, designed as a HIV-1 integrase inhibitor. Initially, the final compound was isolated as a mixture of rotamers. In the current study, we have developed a simple and efficient achiral, reversed phase (RP) HPLC method to separate the interconvertible rotamers of SCMTDDA. The effect of several parameters, including stationary phase, buffer, modifiers and column temperature, were optimized for the chromatographic separation and it was observed that best separation was achieved on a SunFire C18 column using TFA/acetonitrile (ACN) - methanol (MeOH) (1:1 v/v) as the mobile phase at 10 0C. The chromatographic observations were complemented with variable-temperature NMR and energy barrier calculations using density functional theory (DFT).

Impact of CO2-solvent separators on the degradation of benzyl-2,3-dihydroxypiperidine-1-carboxylate during preparative supercritical fluid chromatographic (SFC) purification.

During a preparative separation of the cis enantiomeric pair of benzyl-2,3-dihydroxypiperidine-1-carboxylate using supercritical-fluid chromatography (SFC) with methanol modifier, significant degradation of the products in the collected fractions was observed when a Waters SFC-350® (Milford, MA, USA) was used, but same was not observed when a Waters SFC-80q® (Milford, MA, USA) was used. Through a systematic investigation, we discovered that the compound degraded over time under an acidic condition created by the formation of methyl carbonic acid from methanol and CO2. The extent of the product degradation was dependent on the time and the concentration of CO2 remained in the product fraction, which was governed by the efficiency of CO2-methanol separation during the fraction collection. Hence, we demonstrated that the different designs of CO2-solvent separator (high pressurized cyclone in Waters SFC-350® and low-pressurized vortexing separator in Waters SFC-80q®®) had a significant impact on the degradation of an acid-sensitive compound. The acidity caused by CO2 in methanol was supported by diminished degradation after a nitrogen purging or after neutralizing the collected fractions with a base. Three different solutions to overcome the degradation problem of the acid sensitive compounds using SFC-350® with the high pressurized separator were investigated and demonstrated. The degraded products were isolated as four enantiomers and their relative stereochemistry were established based on 2D NMR data along with the plausible mechanism of degradation.

Use of Hybrid Capillary Tube Apparatus on 400 MHz NMR for Quantitation of Crucial Low-Quantity Metabolites Using aSICCO Signal.

Metabolites of new chemical entities can influence safety and efficacy of a molecule and often times need to be quantified in preclinical studies. However, synthetic standards of metabolites are very rarely available in early discovery. Alternate approaches such as biosynthesis need to be explored to generate these metabolites. Assessing the quantity and purity of these small amounts of metabolites with a nondestructive analytical procedure becomes crucial. Quantitative NMR becomes the method of choice for these samples. Recent advances in high-field NMR (>500 MHz) with the use of cryoprobe technology have helped to improve sensitivity for analysis of small microgram quantity of such samples. However, this type of NMR instrumentation is not routinely available in all laboratories. To analyze microgram quantities of metabolites on a routine basis with lower-resolution 400 MHz NMR instrument fitted with a broad band fluorine observe room temperature probe, a novel hybrid capillary tube setup was developed. To quantitate the metabolite in the sample, an artificial signal insertion for calculation of concentration observed (aSICCO) method that introduces an internally calibrated mathematical signal was used after acquiring the NMR spectrum. The linearity of aSICCO signal was established using ibuprofen as a model analyte. The limit of quantification of this procedure was 0.8 mM with 10 K scans that could be improved further with the increase in the number of scans. This procedure was used to quantify three metabolites-phenytoin from fosphenytoin, dextrophan from dextromethorphan, and 4-OH-diclofenac from diclofenac-and is suitable for minibiosynthesis of metabolites from in vitro systems.

Fipronil Compound Consumption Presenting as Status Epilepticus.

Fipronil is a broadspectrum N-phenylpyrazole insecticide with gamma-aminobutyric acid type A receptor inhibitory action causing hyperexcitability of central nervous system. There is no literature reported in the past concerning its acute toxicity in human beings. A case report is useful for workers in medical and veterinary field. Hence, we are reporting a case in which young male intoxicated with fipronil compound was presented to the emergency department for having generalized tonic-clonic seizures and subsequently with the features of delirium for few days. This patient was treated with benzodiazepines which controlled the seizures and antipsychotics were given for few days for treating the psychosis.