Development and application of a protocol for extractables profiling from central venous catheters in neonates.

Peripherally inserted central catheters (PICC-lines) used in neonatology are made of thermoplastic polyurethane (TPU) or silicone. These materials usually contain substances that may leach into drug vehicles or blood. In this extractables study, we determined the optimal extraction conditions using TPU films containing defined amounts of butylhydroxytoluene (BHT) and then applied them on unused and explanted PICC-lines. Maceration and sonication tests were carried out with hexane, acetone and water as the extraction solvents. The analyses were performed using gas and liquid chromatography coupled with mass spectrometry detectors, as well as inductive coupled plasma optical emission spectroscopy to detect a wide range of extractables. We selected a limited list of substances to be sought from the usual adjuvants and monomers, related to their carcinogenic, mutagenic or reprotoxic properties and/or existence in endocrine disruptors lists. The TPU-film experiments showed that acetone was slightly better than hexane, and maceration better than sonication. When applied to PICC-lines, the extraction methods were almost similar but acetone was clearly better than hexane for TPU. From the 48 peaks initially observed in GC-MS, we ended up with 37 peaks to follow in TPU PICC-lines, among which were those of BHT and 4,4'-Methylenebis(cyclohexyl isocyanate) isomers. For silicone PICC-lines, out of 41 peaks initially observed in GC-MS, we followed 20 peaks, most of them being identified as cyclosiloxanes. Barium was the main inorganic element extracted for both PICC-lines. For TPU PICC-lines, the inter-batch variability was higher than for intra-batch, but in silicone devices both were similar. When compared to new PICC-lines, explanted TPU PICC-lines extracted peaks had a lower area under the curve (AUC), while the AUCs of the peaks were higher for the majority of silicone PICC-lines extract compounds. No identified substances were detected above their toxicological threshold, but isocyanates and cyclosiloxanes toxicity was mostly studied for other exposition routes than intravenous. The methods defined in this study were efficient in producing extractable profiles from both PICC-lines.

Comparative Study of Sorption Phenomena Between Three Medications and Syringes Made of Cyclic Olefin Copolymer or Polypropylene.

INTRODUCTION: Medical syringes are widely used in hospitals to store and administer drugs, and the contact time between the drugs and these syringes can vary from a few minutes to several weeks like for pharmaceutical preparations. The aim of this comparative study was to evaluate the potential sorption phenomena occurring between three drugs (paracetamol, diazepam and insulin aspart) and polypropylene syringes (PP) or syringes made of Cyclic Olefin Copolymer (COC). MATERIALS AND METHODS: 50 mL 3-part syringes made of either COC with crosslinked silicone on the barrel inner surface (COC-CLS) and a bromobutyl plunger seal, or PP lubricated with silicone oil (PP-SOL) with a polyisoprene plunger seal were used. RESULTS: COC-CLS syringes induced less sorption of diazepam and insulin than PP-SOL syringes and the plunger seal material seemed to be the main cause of these interactions. An alkalinization of the medications in contact with the PP-SOL syringes was observed. It could be caused by leachable compounds and should be investigated further. CONCLUSION: This work shows once again that it is essential to consider content-container interactions to help improve the safe use of parenteral drugs.

Medical devices used in NICU: The main source of plasticisers' exposure of newborns.

Phthalates and other plasticisers are extensively used in medical devices (MD) from which they can leach out and lead to potential multiple problems for the patients. This exposure is a major issue because it is associated with reproductive and neurodevelopment disorders. The Neonatal Intensive Care Units (NICU) population is at high risk due to the daily intensive medical interventions, the reduced ability of newborns to remove these contaminants and their higher sensitivity to endocrine disruptors. We conducted a multicentric biomonitoring study to assess and compare the urinary levels of DEHP (di-(2-ethylhexyl)phthalate), DEHTP (di-(2-ethylhexyl)terephthalate) and TEHTM (tri-(2-ethylhexyl)trimellitate) metabolites as biomarkers of this exposure during and after the newborns' stay in NICU. Daily urinary samples were collected in NICU and at discharge from the hospital for each patient. MD sources and exposure factors were also investigated. 508 urinary samples from 97 patients enrolled in centres 1 and 2 (C1/C2) were collected. The exposure of newborns to DEHP was greater than that of DEHTP and TEHTM, with a median concentration of DEHP metabolites (C1:195.63 ng/mL;C2:450.87 ng/mL) respectively 5 to 10 times higher and 57 to 228 times higher than the median concentrations of DEHTP and TEHTM metabolites. The urinary concentrations of DEHP and TEHTM metabolites were significantly lower at discharge than in NICU, with a 18-and 35-fold decrease for DEHP and a 4 and 8-fold decrease for TEHTM, respectively for C1 and C2, but were similar for DEHTP metabolites. MD used for respiratory assistance, infusion therapy,enteral nutrition and transfusion were the main sources of exposure. Smaller gestational age and body weight significantly increased the newborns' exposure. The elevated levels of DEHP metabolites in NICU patients are still alarming. Additional efforts are necessary to promote its substitution in MD by possibly safer alternatives such as TEHTM and DEHTP, particularly when used for the care of newborns.

Ex Vivo Model to Assess the Exposure of Patients to Plasticizers from Medical Devices during Pre-CAR-T Cells' Apheresis.

BACKGROUND: The treatment of relapsed or refractory leukemia remains a major problem. Among the new therapeutic approaches, the use of modified T lymphocytes, called chimeric antigen receptor T cells (CAR-T cells), seems promising. The first step of their preparation is leukapheresis, which involves the collection of mononuclear cells from the patient. This medical procedure requires numerous medical devices (MDs) made of plasticized polyvinylchloride (PVC). These compounds can leach out of the devices during contact with the patient's blood. The aim of our study was to evaluate the migration of the plasticizers contained in the MD during a simulated pre-CAR-T cell leukapheresis procedure, and to measure the patient's and their lymphocytes' exposure to them. METHODS: The qualitative and quantitative composition of the MD used for pre-CAR-T cell apheresis was determined by gas chromatography-mass spectrometry (GC-MS). Then, an ex vivo leukapheresis model using an ethanol/water simulant was performed to evaluate the plasticizers' migration under simulated clinical conditions of pre-CAR-T cells' cytapheresis. The plasticizers released into the simulant were quantified by GC-MS. RESULTS: Diethylhexylphthalate (DEHP) was found in the apheresis kit, with amounts ranging from 25% to 59% (g/100 g of PVC). Bis(2-ethylhexyl) adipate was detected at trace levels. A total of 98.90 ± 11.42 mg of DEHP was released into the simulant, corresponding to an exposure dose of 1.4 mg/kg for a 70 kg patient. CONCLUSIONS: Patients undergoing a pre-CAR-T cell apheresis are mainly exposed to DEHP, which can impact their health because of its endocrine disruption effect, but could also lead to a decrease in CAR-T cells' efficiency/quality.

Physicochemical Stability of a Novel Tacrolimus Ophthalmic Formulation for the Treatment of Ophthalmic Inflammatory Diseases.

Tacrolimus is an immunosuppressant used to treat a large variety of inflammatory or immunity-mediated ophthalmic diseases. However, there are currently no commercial industrial forms available that can provide relief to patients. Various ophthalmic formulations have been reported in the literature, but their stability has only been tested over short periods. The objective of this study was to evaluate the physicochemical stability of a preservative-free tacrolimus formulation (0.2 and 1 mg/mL) at three storage temperatures (5 °C, 25 °C and 35 °C) for up to nine months in a multidose eyedropper. Analyses performed were the following: visual inspection and chromaticity, turbidity, viscosity, size of micelles, osmolality and pH measurements, tacrolimus quantification by a stability-indicating liquid chromatography method, breakdown product research, and sterility assay. In an in-use study, tacrolimus quantification was also performed on the drops emitted from the eyedroppers. All tested parameters remained stable during the nine month period when the eyedrops were stored at 5 °C. However, during storage at 25 °C and 35 °C, several signs of chemical instability were detected. Furthermore, a leachable compound originating from a silicone part of the eyedropper was detected during the in-use assay. Overall, the 0.2 mg/mL and 1 mg/mL tacrolimus ophthalmic solutions were physicochemically stable for up to nine months when stored at 5 °C.

Physicochemical Stability of Monoclonal Antibodies: A Review.

Monoclonal antibodies (mAbs) are subject to instability issues linked to their protein nature. In this work, we review the different mechanisms that can be linked to monoclonal antibodies instability, the parameters, and conditions affecting their stability (protein structure and concentration, temperature, interfaces, light exposure, excipients and contaminants, and agitation) and the different analytical methods used for appropriate physicochemical stability studies: physical stability assays (aggregation, fragmentation, and primary, secondary, and tertiary structure analysis), chemical stability assays and quantitative assays. Finally, data from different published stability studies of mAbs formulations, either in their reconstituted form, or in diluted ready to administer solutions, was compiled. Overall, the physicochemical stability of mAbs is linked to numerous factors such as formulation, environment, and manipulations, and must be thoroughly investigated using several complementary analytical techniques, each of which allowing specific characterization information to be harvested. Several stability studies have been published, some of them showing possibilities of extended stability. However, those data should be questioned due to potential lacks in study methodology.

Stability of infliximab solutions in different temperature and dilution conditions.

Infliximab is a monoclonal antibody widely used for the treatment of inflammatory diseases. Over the past few years, many studies have assessed that monoclonal antibodies are prone to aggregation under stress conditions. The aim of this study was to investigate the stability of solutions of an infliximab biosimilar (Inflectra®) at different concentrations (0.4, 2 and 10 mg/mL). These solutions were separately submitted to three temperature conditions that are likely to happen during the drug dispensing system: -20 °C, 5 °C and 25 °C. To perform a complete characterization of infliximab physicochemical and structural stability, a wide range of analytical techniques was employed including: visual inspection, subvisible particles counting (HIAC), dynamic light scattering (DLS), size exclusion chromatography (SEC), cation exchange chromatography (CEX), and analysis of primary, secondary and tertiary structure. When stored at 25 °C, chemical instability was the main limiting factor (highlighted by CEX), while SEC showed only some acceptable variations. After a single freeze-thawing cycle, the amount of subvisible particles was significantly increased. Some variations were also visible in CEX and the hydrodynamic diameter was increased after thawing 10 mg/mL samples. In regard of these results, infliximab (Inflectra®) solutions should not be used after a single freeze-thawing cycle between reconstitution and administration to the patient. The results showed stability at 5 °C of up to 14 days for 10 mg/mL solutions and 90 days for 0.4 and 2 mg/mL solutions, whilst samples stored at 25 °C were stable only 7 days at 10 mg/mL and 30 days when diluted.