RESUMEN
Shock wave measurement is vital in assessing explosive power and designing warheads. To obtain satisfactory observation data of explosive shock waves, it is preferable for optical sensors to possess high-dynamic range and high-time resolution capabilities. In this paper, the event camera is first employed to observe explosive shock waves, leveraging its high dynamic range and low latency. A comprehensive procedure is devised to measure the motion parameters of shock waves accurately. Firstly, the plane lines-based calibration method is proposed to compute the calibration parameters of the event camera, which utilizes the edge-sensitive characteristic of the event camera. Then, the fitted ellipse parameters of the shock wave are estimated based on the concise event data, which are gained by utilizing the characteristics of the event triggering and shock waves' morphology. Finally, the geometric relationship between the ellipse parameters and the radius of the shock wave is derived, and the motion parameters of the shock wave are estimated. To verify the performance of our method, we compare our measurement results in the TNT explosion test with the pressure sensor results and empirical formula prediction. The relative measurement error compared to pressure sensors is the lowest at 0.33% and the highest at 7.58%. The experimental results verify the rationality and effectiveness of our methods.
RESUMEN
The blast resistance of a sandwich-walled cylinder/ring comprising two metal face-sheets and a graded metal foam core, subjected to internal air blast loading, is investigated. Analytical models are developed for the deformation of the sandwich cylinder with positive and negative gradient cores under internal blast loading. The deformation process is divided into three distinct phases, namely the fluid-structure interaction phase, core-crushing phase, and outer face-sheet deformation phase. Finite element modeling is performed using the Voronoi material model. The proposed analytical models are verified through finite element analysis, and reasonable agreement is observed between the analytical predictions and finite element results. The sandwich structures with high energy absorption capacity or low maximum radial deflection are satisfied for the protecting purpose of impact/blast resistance requirements. Typical deformation processes are classified and analyzed; the effects of explosive charge, face-sheet thickness, and core gradient on the structural response are also examined. The results indicate that both the deformation modes and the structural response of the cylinders are sensitive to the blast charge and core configuration. It is concluded that energy absorption capacity and maximum radial deflection are two conflicting goals for achieving high impact/blast resistance capability. An in-depth understanding of the behavior in sandwich-walled cylinders under blast impulse and the influence of the core configuration helps realize the advantages and disadvantages of using graded foam materials in sandwich structures and can provide a guideline for structural design.
RESUMEN
Experimental and numerical analyses were carried out to reveal the behaviors of two-layer graded aluminum foam materials for their dynamic compaction under blast loading. Blast experiments were conducted to investigate the deformation and densification wave formation of two-layer graded foams with positive and negative gradients. The shape of the stress waveform changed during the propagation process, and the time of edge rising was extended. Finite element models of two-layer graded aluminum foam were developed using the periodic Voronoi technique. Numerical analysis was performed to simulate deformation, energy absorption, and transmitted impulse of the two-layer graded aluminum foams by the software ABAQUS/Explicit. The deformation patterns were presented to provide insights into the influences of the foam gradient on compaction wave mechanisms. Results showed that the densification wave occurred at the blast end and then gradually propagated to the distal end for the positive gradient; however, compaction waves simultaneously formed in both layers and propagated to the distal end in the same direction for the negative gradient. The energy absorption and impulse transfer were examined to capture the effect of the blast pressure and the material gradient. The greater the foam gradient, the more energy dissipated and the more impulse transmitted. The absorbed energy and transferred impulse are conflicting objectives for the blast resistance capability of aluminum foam materials with different gradient distributions. The results could help in understanding the performance and mechanisms of two-layer graded aluminum foam materials under blast loading and provide a guideline for effective design of energy-absorbing materials and structures.