RESUMEN
In recent years, ternary layered double hydroxide (LDH) has become a research hotspot for electrode materials and oxygen evolution reaction (OER) catalyst due to the enhanced synergistic effect between individual elements. However, the application of LDH is greatly limited by its low electrical conductivity and the disadvantage that nanosheets tend to accumulate and mask the active sites. Herein, a novel Ru-doped CoNiFe - LDH was prepared via a facile hydrothermal method. According to the density functional theory (DFT) calculations, the doping of Ru element could improve electron state density and band gaps of LDH and consequently boosted the electrochemical reaction kinetics as well as electrical conductivity. Furthermore, introduction of Ru atom induced the formation of porous flower-like structures in nanosheets. Compared to CoNiFe - LDH (28.9 m2/g), Ru-doped CoNiFe - LDH performed larger specific surface area of 53.1 m2/g, resulting in more electrochemically active sites. In these case, Ru-doped CoNiFe - LDH demonstrated better energy storage performance of 176.0 mAh/g at 1 A/g compared to original CoNiFe - LDH (78.9 mAh/g at 1 A/g). Besides, the assembled Ru-doped CoNiFe - LDH//activated carbon (AC) device delivered a maximum energy density of 36.4 W h kg-1 at the power density of 740.3 W kg-1 and an outstanding cycle life (78.7 % after 10,000 cycles). Meanwhile, Ru-doped CoNiFe - LDH exhibited lower overpotential (339 mV at 50 mA cm-2) and Tafel slope (93.2 mV dec-1). Therefore, this work provided novel and valuable insights into the rational doping of Ru elements for the controlled synthesis of supercapacitor electrode materials and OER catalysts.
RESUMEN
Traditionally, the formation of amorphous shear bands in crystalline materials has been undesirable, because shear bands can nucleate voids and act as precursors to fracture. They also form as a final stage of accumulated damage. Only recently were shear bands found to form in undefected crystals, where they serve as the primary driver of plasticity without nucleating voids. Here we have discovered trends in materials properties that determine when amorphous shear bands will form and whether they will drive plasticity or lead to fracture. We have identified the materials systems that exhibit shear-band deformation, and by varying the composition, we were able to switch from ductile to brittle behaviour. Our findings are based on a combination of experimental characterization and atomistic simulations, and they provide a potential strategy for increasing the toughness of nominally brittle materials.
RESUMEN
The decomposition of the Nd-Ce-Fe-B phase to form CeFe2 has been usually believed to have an important positive effect on the magnetic properties of Nd-Ce-Fe-B permanent magnetic materials. In this work, a new decomposition process of the Nd-Ce-Fe-B phase on the formation of the CeFe2 phase was observed to play a negative role in its magnetic properties. It is demonstrated that the Nd-Ce-Fe-B phase decomposes into non-magnetic CeFe2, accompanied by the precipitation of Fe soft-phase. The kinks usually occurring in the demagnetization curves of Ce-rich Nd-Ce-Fe-B magnets have been determined to be related to the Fe soft-phase. Instead of using CeFe2 as a grain-boundary phase, another Ce-Cu boundary phase has been explored to efficiently improve the coercivity of Ce-rich Nd-Ce-Fe-B magnets, provided that the Ce-Cu boundary phase has an appropriate Ce to Cu ratio. The present results contribute to the mechanism comprehension and high-performance design of Nd-Ce-Fe-B permanent magnetic materials.
RESUMEN
Dislocation activity is critical to ductility and the mechanical strength of metals. Dislocations are the primary drivers of plastic deformation, and their interactions with each other and with other microstructural features such as grain boundaries (GBs) lead to strengthening of metals. In general, suppressing dislocation activity leads to brittleness of polycrystalline materials. Here, we find an intermetallic that can accommodate large plastic strain without the help of dislocations. For small grain sizes, the primary deformation mechanism is GB sliding, whereas for larger grain sizes the material deforms by direct amorphization along shear planes. The unusual deformation mechanisms lead to the absence of traditional Hall-Petch (HP) relation commonly observed in metals and to an extended regime of strength weakening with grain refinement, referred to as the inverse HP relation. The results are first predicted in simulations and then confirmed experimentally.
RESUMEN
The well-known idea of "structure determines properties" can be understood profoundly in the case of hexagonal zinc dicyanometalate. Using density functional theory (DFT) calculations, we show the uniaxial negative thermal expansion (NTE) and negative linear compressibility (NLC) properties of Zn[Au(CN)2]2. The temperature dependence of phonon frequencies within the quasi-harmonic approximation (QHA) is investigated. The abnormal phonon hardening (frequency increase on heating) is detected in the ranges of 0-225, 320-345, and 410-430 cm-1, which can be indicative of the unusual physical properties of Zn[Au(CN)2]2. Due to the significance of low-energy phonon frequencies in Zn[Au(CN)2]2, in this work, the corresponding vibrational mode of the lowest-frequency optical phonon at the zone center is analyzed. The specific topology of a springlike framework that will produce the effects of a compressed spring on heating and an extended spring under hydrostatic pressure is identified and leads to the coexistence of uniaxial-NTE and NLC behaviors in Zn[Au(CN)2]2. The distinguishing phonon group velocity along the a axis and c axis facilitates different responses for both the axes under temperature and hydrostatic pressure field. Through an analysis and visualization of the spatial dependence of elastic tensors, it is found that a negative Poisson's ratio (NPR) is presented in all projection planes due to the specific topology.
RESUMEN
Using the first-principles exact muffin-tin orbitals method in combination with the coherent potential approximation, we investigated the magnetic properties, exchange interactions, and temperature-dependent half-metallicity of the Co2Mn(Ga1-xZx) (Z=Si, Ge, Sn) alloys. The total magnetic moment follows perfectly a previously proposed Slater-Pauling relation, i.e., µ0 = Nt - 24, with Nt being the number of valence electrons. The Co-Mn and Co1-Co2 (inter-sublattice) interactions are dominated by direct exchange, whereas the Co1-Co1 (intra-sublattice) interaction is characterized by superexchange. The Mn-Mn exchange interaction in Co2MnGa is of long-ranged RKKY-type. However, the Mn-Mn exchange interactions in Co2MnZ are relatively localized and can be attributed to superexchange. The Co-Mn, Co1-Co2 and Co1-Co1 total exchange interactions increase with x, whereas the Mn-Mn total exchange interactions show convex behavior. The calculated Curie temperature (TC) increases with x. The ability of Z to enhance TC follows the sequence of Si > Ge > Sn, in agreement with the experimental findings. The temperature dependence of the spin polarization at the Fermi level [P(T)] is investigated based on the disordered local moment model. P(T) drops abruptly at temperatures much lower than TC. At temperatures higher than 200 K, the composition with higher TC generally corresponds to larger P(T).