RESUMEN
Ultrasound is a promising technology for the improvement of zeolite production, due to its beneficial effects on mass transfer and nucleation. However, a broad understanding of the sonication parameters that influence the growth of zeolites most is still lacking. In the present work, zeolite A was synthesized and the kinetic model of Gualtieri was used to obtain information about the crystallization parameters. The effect of the sonication power and duration on the relative crystallinity and particle size distribution were investigated using a Langevin-type transducer operating at 40 kHz. The experimental data shows that ultrasound has a significant effect on the nucleation and growth. With that, a reduction of up to 40 % of the initial synthesis time can be achieved. Additionally, a narrower particle size distribution is achieved when ultrasound is used during the zeolite A synthesis.
RESUMEN
In this work, NaX zeolite was synthesized and the effect of ultrasound irradiation on reaction kinetics, morphological and structural properties was investigated. Ultrasound was applied, by using a plate transducer (91.8 kHz), for the first time during the crystallization of zeolite NaX, at high temperature, varying the irradiation moment and its duration. Furthermore, ultrasound was applied after the crystallization by a horn-type transducer (20-24 kHz) at low temperature. The effects of irradiated volume (100-300 mL), sonication time (2-10 min) and ultrasound power (10-200 W) were studied with a power intensity up to 100 W/cm2. It was found that the application of ultrasound during the first hour of crystallization resulted in 20% reduction of reaction time compared to a standard crystallization. Ultrasound can also reduce the agglomeration degree of the final powder by combining high power and long sonication time. After 5 min sonication time at 0.3 W/mL, the tapped density of the powder was increased by 10%, from 0.37 to 0.41 g/mL. Finally, by scanning electron microscopy (SEM) it was demonstrated that ultrasound can disrupt the agglomerates without affecting the morphology of individual crystals.
RESUMEN
Ultrasonic micro-reactors are frequently applied to prevent micro-channel clogging in the presence of solid materials. Continuous sonication will lead to a sizeable energy input resulting in a temperature increase in the fluidic channels and concerns regarding microchannel degradation. In this paper, we investigate the application of pulsed ultrasound as a less invasive approach to prevent micro-channel clogging, while also controlling the temperature increase. The inorganic precipitation of barium sulfate particles was studied, and the impact of the effective ultrasonic treatment ratio, frequency and load power on the particle size distribution, pressure and temperature was quantified in comparison to non-sonicated experiments. The precipitation reactions were performed in a continuous reactor consisting of a micro-reactor chip attached to a Langevin-type transducer. It was found that adjusting the pulsed ultrasound conditions prevented microchannel clogging by reducing the particle size to the same magnitude as observed for continuous sonication. Furthermore, reducing the effective treatment ratio from 100 to 12.5% decreases the temperature rise from 7 to 1⯰C.