Combining mixed titania morphologies into a complex assembly thin film by iterative block-copolymer-based sol­gel templating.

Sol­gel templating combined with iterative spin-coating steps are used to custom-tailor hierarchically structured titania thin films. Using poly(styrene-block-ethylene oxide) P(S-b-PEO) as the structure directing agent, a foam-like structure is combined with nanogranules. Both structural elements are merged into a complex assembly in thin film geometry. The resulting morphology is pictured by SEM and probed with GISAXS. The installed mesoporous titania sandwich structure exhibits holes with a size of 45 nm which makes it promising for applications in photovoltaics or photocatalysis. An optical characterization completes the structural investigation.

Structure and flow of droplets on solid surfaces.

The structure and flow of droplets on solid surfaces is investigated with imaging and scattering techniques and compared to simulations. To access nanostructures at the liquid-solid interface advanced scattering techniques such as grazing incidence small-angle x-ray scattering (GISAXS) with micro- and nanometer-sized beams, GISAXS and in situ imaging ellipsometry and GISAXS tomography are used. Using gold nanoparticle suspensions, structures observed in the wetting area due to deposition are probed in situ during the drying of the droplets. After drying, nanostructures in the wetting area and inside the dried droplets are monitored. In addition to drying, a macroscopic movement of droplets is caused by body forces acting on an inclined substrate. The complexity of the solid surfaces is increased from simple silicon substrates to binary polymer brushes, which undergo a switching due to the liquid in the droplet. Nanostructures introduced in the polymer brush due to the movement of droplets are observed.

Stability and dynamics of droplets on patterned substrates: insights from experiments and lattice Boltzmann simulations.

The stability and dynamics of droplets on solid substrates are studied both theoretically and via experiments. Focusing on our recent achievements within the DFG-priority program 1164 (Nano- and Microfluidics), we first consider the case of (large) droplets on the so-called gradient substrates. Here the term gradient refers to both a change of wettability (chemical gradient) or topography (roughness gradient). While the motion of a droplet on a perfectly flat substrate upon the action of a chemical gradient appears to be a natural consequence of the considered situation, we show that the behavior of a droplet on a gradient of topography is less obvious. Nevertheless, if care is taken in the choice of the topographic patterns (in order to reduce hysteresis effects), a motion may be observed. Interestingly, in this case, simple scaling arguments adequately account for the dependence of the droplet velocity on the roughness gradient (Moradi et al 2010 Europhys. Lett. 89 26006). Another issue addressed in this paper is the behavior of droplets on hydrophobic substrates with a periodic arrangement of square shaped pillars. Here, it is possible to propose an analytically solvable model for the case where the droplet size becomes comparable to the roughness scale (Gross et al 2009 Europhys. Lett. 88 26002). Two important predictions of the model are highlighted here. (i) There exists a state with a finite penetration depth, distinct from the full wetting (Wenzel) and suspended (Cassie-Baxter, CB) states. (ii) Upon quasi-static evaporation, a droplet initially on the top of the pillars (CB state) undergoes a transition to this new state with a finite penetration depth but then (upon further evaporation) climbs up the pillars and goes back to the CB state again. These predictions are confirmed via independent numerical simulations. Moreover, we also address the fundamental issue of the internal droplet dynamics and the terminal center of mass velocity on a flat substrate.