RESUMEN
We construct a terahertz swept source optical coherence tomography system using a continuous-wave diode multiplier source in the 600-GHz band for defect inspection in multilayer objects and evaluate its performance. Using this system, we image a multilayer plastic sample to demonstrate the effectiveness of nondestructive three-dimensional imaging. To enhance the depth resolution, we apply an annihilating filter to the analysis and confirm that two surfaces of a 1-mm-thick plastic plate can be resolved. In addition, the repeatability of measured thicknesses is 0.22 mm. These values are approximately one-half and one-tenth of the resolution achievable by conventional Fourier analysis, respectively.
RESUMEN
This publisher's note contains corrections to Opt. Lett.45, 77 (2020)OPLEDP0146-959210.1364/OL.45.000077.
RESUMEN
We studied the spectral linewidth narrowing of wavelength-swept actively mode-locked ring lasers (AMLLs). The numerical calculations for the static-state AMLL led us to predict that anomalous dispersion would narrows the linewidth. We examined the effect experimentally using AMLL setups for normal and anomalous dispersive cavities via the normal or inverse use of a linearly chirped fiber Bragg grating. The experiment indicated that the cavity with anomalous dispersion always generates narrower linewidth lasers than its normal dispersion equivalent. The cavity with anomalous dispersion also achieved a 0.08 nm linewidth. Using the anomalous dispersion setup, we observed instantaneous linewidth broadening during wavelength sweeping. Although the coherence of AMLL decreased drastically when the sweep rate became very rapid beyond a single roundtrip, narrow-linewidth lasing was observed within a single roundtrip. In summary, we demonstrated the use of 150 kHz wavelength sweeping with a 40-nm range and a 2.7-m short-length anomalous dispersion cavity.