RESUMEN
The industrial adoption of low-carbon technologies and renewable electricity requires novel tools for electrifying unitary steps and efficient energy storage, such as the catalytic synthesis of valuable chemical carriers. The recently-discovered use of microwaves as an effective reducing agent of solid materials provides a novel framework to improve this chemical-conversion route, thanks to promoting oxygen-vacancy formation and O2-surface exchange at low temperatures. However, many efforts are still required to boost the redox properties and process efficiency. Here, we scrutinise the dynamics and the physicochemical dependencies governing microwave-induced redox transformations on solid-state ion-conducting materials. The reduction is triggered upon a material-dependent induction temperature, leading to a characteristically abrupt rise in electric conductivity. This work reveals that the released O2 yield strongly depends on the material's composition and can be tuned by controlling the gas-environment composition and the intensity of the microwave power. The reduction effect prevails at the grain surface level and, thus, amplifies for fine-grained materials, and this is ascribed to limitations in oxygen-vacancy diffusion across the grain compared to a microwave-enhanced surface evacuation. The precise cyclability and stability of the redox process will enable multiple applications like gas depuration, energy storage, or hydrogen generation in several industrial applications.
RESUMEN
Dense alumina toughened zirconia nanocomposites (ATZ, 3Y-TZP with 20â¯wt% Al2O3) were densified by non-conventional microwave sintering technology at relatively low temperatures (1200 and 1300⯰C). The sintering method and its effect on densification, microstructure, mechanical properties and tribological behaviour were investigated. The outcomes demonstrated that the density rose as the sintering temperature was higher, and therefore the mechanical properties were enhanced, reaching a maximum hardness (18.4⯱â¯0.4â¯GPa) and fracture toughness (5.7⯱â¯0.3MPa·â¯m1/2). In addition, the samples were subjected to a tribological test in dry and wet conditions, using artificial saliva. In both cases, the coefficient of friction and wear volume for samples obtained by microwave sintering are lower than conventional samples, with the wear volume being two times higher in dry conditions than in wet conditions.
Asunto(s)
Óxido de Aluminio/química , Fenómenos Mecánicos , Microondas , Nanocompuestos/química , Nanotecnología , Circonio/química , Fricción , Dureza , TemperaturaRESUMEN
In this study, real-time and in-situ permittivity measurements under intense microwave electromagnetic fields are proposed as a powerful technique for the study of microwave-enhanced thermal processes in materials. In order to draw reliable conclusions about the temperatures at which transformations occur, we address how to accurately measure the bulk temperature of the samples under microwave irradiation. A new temperature calibration method merging data from four independent techniques is developed to obtain the bulk temperature as a function of the surface temperature in thermal processes under microwave conditions. Additionally, other analysis techniques such as Differential Thermal Analysis (DTA) or Raman spectroscopy are correlated to dielectric permittivity measurements and the temperatures of thermal transitions observed using each technique are compared. Our findings reveal that the combination of all these procedures could help prove the existence of specific non-thermal microwave effects in a scientifically meaningful way.