Impact ionization-induced bistability in CMOS transistors at cryogenic temperatures for capacitorless memory applications.

Cryogenic operation of complementary metal oxide semiconductor (CMOS) silicon transistors is crucial for quantum information science, but it brings deviations from standard transistor operation. Here, we report on sharp current jumps and stable hysteretic loops in the drain current as a function of gate voltage V G for both n- and p-type commercial-foundry 180-nm-process CMOS transistors when operated at voltages exceeding 1.3 V at cryogenic temperatures. The physical mechanism responsible for the device bistability is impact ionization charging of the transistor body, which leads to effective back-gating of the inversion channel. This mechanism is verified by independent measurements of the body potential. The hysteretic loops, which have a >107 ratio of high to low drain current states at the same V G, can be used for a compact capacitorless single-transistor memory at cryogenic temperatures with long retention times.

Use of quantum effects as potential qualifying metrics for "quantum grade silicon".

Across solid state quantum information, materials deficiencies limit performance through enhanced relaxation, charge defect motion or isotopic spin noise. While classical measurements of device performance provide cursory guidance, specific qualifying metrics and measurements applicable to quantum devices are needed. For quantum applications, new materials metrics, e.g., enrichment, are needed, while existing, classical metrics like mobility might be relaxed compared to conventional electronics. In this work, we examine locally grown silicon superior in enrichment, but inferior in chemical purity compared to commercial-silicon, as part of an effort to underpin the materials standards needed for quantum grade silicon and establish a standard approach for intercomparison of these materials. We use a custom, mass-selected ion beam deposition technique, which has produced isotopic enrichment levels up to 99.99998 % 28Si, to isotopically enrich 28Si, but with chemical purity > 99.97% due the MBE techniques used. From this epitaxial silicon, we fabricate top-gated Hall bar devices simultaneously on the 28Si and on the adjacent natural abundance Si substrate for intercomparison. Using standard-methods, we measure maximum mobilities of ≈(1740±2)cm2/(V⋅s) at an electron density of (2.7×1012±3×108) cm-2 and ≈(6040±3)cm2/(V⋅s) at an electron density of (1.2×1012±5×108) cm-2 at T=1.9 K for devices fabricated on 28Si and natSi, respectively. For magnetic fields B>2 T, both devices demonstrate well developed Shubnikov-de Haas (SdH) oscillations in the longitudinal magnetoresistance. This provides transport characteristics of isotopically enriched 28Si, and will serve as a benchmark for classical transport of 28Si at its current state, and low temperature, epitaxially grown Si for quantum devices more generally.

Non-volatile memory devices with redox-active diruthenium molecular compound.

Reduction-oxidation (redox) active molecules hold potential for memory devices due to their many unique properties. We report the use of a novel diruthenium-based redox molecule incorporated into a non-volatile Flash-based memory device architecture. The memory capacitor device structure consists of a Pd/Al2O3/molecule/SiO2/Si structure. The bulky ruthenium redox molecule is attached to the surface by using a 'click' reaction and the monolayer structure is characterized by x-ray photoelectron spectroscopy to verify the Ru attachment and molecular density. The 'click' reaction is particularly advantageous for memory applications because of (1) ease of chemical design and synthesis, and (2) provides an additional spatial barrier between the oxide/silicon to the diruthenium molecule. Ultraviolet photoelectron spectroscopy data identified the energy of the electronic levels of the surface before and after surface modification. The molecular memory devices display an unsaturated charge storage window attributed to the intrinsic properties of the redox-active molecule. Our findings demonstrate the strengths and challenges with integrating molecular layers within solid-state devices, which will influence the future design of molecular memory devices.

Switching mechanisms in flexible solution-processed TiO2 memristors.

Memristors are emerging as unique electrical devices with potential applications in memory, reconfigurable logic and biologically inspired computing. Due to the novelty of these devices, the complete details of their switching mechanism is not yet well established. In this work, the switching mechanism of our solution-processed titanium dioxide-based memristor is investigated by studying how variations in the device area and film thickness affect electrical behavior and correlating these behavioral changes to proposed switching mechanisms. The conduction path of the switching is also investigated through electrical characterization of devices both before and after physically cutting the devices in half, as well as through infrared imaging of the devices during operation. The results suggest that the electrical behavior of these devices is dominated by a localized, charge-based phenomenon that exhibits a dependence on device area.

Contact-induced crystallinity for high-performance soluble acene-based transistors and circuits.

The use of organic materials presents a tremendous opportunity to significantly impact the functionality and pervasiveness of large-area electronics. Commercialization of this technology requires reduction in manufacturing costs by exploiting inexpensive low-temperature deposition and patterning techniques, which typically lead to lower device performance. We report a low-cost approach to control the microstructure of solution-cast acene-based organic thin films through modification of interfacial chemistry. Chemically and selectively tailoring the source/drain contact interface is a novel route to initiating the crystallization of soluble organic semiconductors, leading to the growth on opposing contacts of crystalline films that extend into the transistor channel. This selective crystallization enables us to fabricate high-performance organic thin-film transistors and circuits, and to deterministically study the influence of the microstructure on the device characteristics. By connecting device fabrication to molecular design, we demonstrate that rapid film processing under ambient room conditions and high performance are not mutually exclusive.

Regulation of subcellular localization of the aryl hydrocarbon receptor (AhR).

The aryl hydrocarbon receptor (AhR) is a ligand-activated transcription factor that mediates the toxicity of dioxin and other xenobiotics. In the absence of exogenous ligand, AhR is cytosolic. We investigated how AhR is retained in the cytosol and how dioxin induces AhR to move to the nucleus. Disruption of nuclear export of AhR by the nuclear export inhibitor leptomycin B (LMB) or by mutation of the AhR nuclear export signal resulted in nuclear accumulation of AhR in the absence of exogenous ligand. Mutation of the AhR nuclear localization signal resulted in defects in nuclear import of AhR in both the presence and the absence of exogenous ligand. Dioxin treatment caused a more rapid accumulation of AhR in the nucleus than LMB treatment. In the presence of both dioxin and LMB, nuclear accumulation of AhR was more rapid than in the presence of dioxin alone. Our results show that AhR shuttles between the nucleus and the cytosol in the absence of exogenous ligand. Binding of ligand induces an increase in the rate of nuclear import of AhR but does not eliminate nuclear export of AhR.

Using a tropism-modified adenoviral vector to circumvent inhibitory factors in ascites fluid.

Peritoneal compartmentalization of advanced stage ovarian cancer provides a rational scenario for gene therapy strategies. Several groups are exploring intraperitoneal administration of adenoviral (Ad) vectors for this purpose. We examined in vitro gene transfer in the presence of ascites fluid from ovarian cancer patients and observed significant inhibition of Ad-mediated gene transfer. The inhibitory activity was not identified as either complement or cellular factors, but depletion of IgG from ascites removed the inhibitory activity, implicating neutralizing anti-Ad antibodies. A wide range of preexisting anti-Ad antibody titers in patient ascites fluid was measured by ELISA. Western blot analysis demonstrated that the antibodies were directed primarily against the Ad fiber protein. To circumvent inhibition by neutralizing antibodies, a genetically modified adenoviral vector was tested. The Ad5Luc.RGD vector has an Arg-Gly-Asp (RGD) peptide sequence inserted into the fiber knob domain and enters cells through a nonnative pathway. Compared with the conventional Ad5 vector, Ad5Luc.RGD directed efficient gene transfer to cell lines and primary ovarian cancer cells in the presence of ascites fluid containing high-titer neutralizing anti-Ad antibodies. These results suggest that such modified Ad vectors will be needed to achieve efficient gene transfer in the clinical setting.

Immunoassay monitoring of polychlorinated biphenyls (PCBs) in the Great Lakes.

Although polychlorinated biphenyls (PCBs) are no longer manufactured, they are still entering the environment. In some compartments of the environment, PCB concentrations are a serious concern. This is especially true in compartments which accumulate PCBs, and in food items consumed by humans and wildlife. Also, there are situations in which management decisions require rapid, sensitive, accurate measurements, which can be made in real time under field conditions. Methods to use an enzyme-linked immunosorbent assay (ELISA) for PCBs were developed and applied to sediments and fish muscle homogenates collected from the Great Lakes. The extraction methods developed can be applied in the field with non-hazardous solvents, in the absence of sophisticated laboratory equipment. The method detection limit for PCBs in dimethyl sulfoxide (DMSO) extracts of sediment was 0.9 mg/kg. For PCBs in isopropanol extracts of fish tissue, the method detection limit was 0.6 mg/kg. The resolution of the ELISA was 0.83 mg/kg at 1.1 mg/kg and 1.6 mg/kg at 1.7 mg/kg, for sediment and fish tissue, respectively.

Temperate phages and bacteriocins of the gliding bacterium Cytophaga johnsonae.

A collection of 30 independently isolated strains of Cytophaga johnsonae was screened for the presence of temperate bacteriophages. Two strains were found to harbour phages. The newly isolated phages differ in several respects from the 43 previously isolated phages for C. johnsonae. Both phages are polyhedral, approximately 60 nm in diameter, and have no apparent tail structure. They are chloroform sensitive, and plaque formation is inhibited by agar. Both are capable of establishing a stable association with host cells. Twenty-nine of the 30 strains produced diffusible substances that specifically inhibited the growth of other C. johnsonae strains or closely related species and that could not be propagated. These substances appear to be bacteriocins, some of which, like bacteriophages, are active only against motile cells, while other inhibit nonmotile as well as motile cells. One of each of these two types of bacteriocins was partially characterized and both were found to be proteinaceous in nature and bactericidal in effect.

Anti-Ata causing mild hemolytic disease of the newborn.

We report here a case of moderately severe hemolytic disease of the newborn (HDN) due to anti-Ata. The gravida 5 proposita was group A rr and previously was found to have anti-Ata and -D. At the 35-week mark of this pregnancy, her anti-Ata demonstrated a titer of 256, score 79. Fluid obtained by amniocentesis at 36 weeks showed an optical density at 450 nm of 0.08 (midzone). The baby was delivered at 38 weeks by cesarean section. The cord cells were group A rr with a 3+ direct antiglobulin test. The dichloromethane eluate of the infant's cells demonstrated anti-Ata specificity only. At birth, the infant's total bilirubin (TB) was 2.1 mg per dl and the hematocrit level (Hct) was 33.8 percent. Within 8 hours, the TB had risen to 3.8 mg per dl. Phototherapy was initiated at 7-1/2 hours and maintained for 40 hours. The infant's TB rose to a maximum level of 10.5 mg per dl 24 hours after phototherapy was discontinued. At discharge 4 days postpartum, the infant's TB had dropped to 9.2 mg per dl, and the Hct value was 38 percent. On a visit 7 days postpartum, the infant's TB level had fallen to 6.5 mg per dl and the hct value was 38 percent. Transfusions were not necessary.