Enamel Deproteinization or Sandblasting for Enamel Reconditioning Before Acid Etching to Enhance the Shear Bond Strength of Metallic Brackets in a Third Bonding: An In Vitro Study.

ABSTRACT

BACKGROUND: Enamel conditioning with 37% phosphoric acid is the most common technique during orthodontic bracket bonding procedures. However, due to the repeated de-bonding of the orthodontic brackets during treatment, other methods were needed to condition the enamel surface and increase the bond strength. This study aimed to compare the effect of conditioning the enamel surface by sandblasting with aluminum oxide particles or 5.25% sodium hypochlorite gel in combination with acid etching compared to acid etching alone on shear bond strength (SBS). MATERIAL AND METHODS: One hundred eight extracted upper premolars were randomly divided into three groups according to the conditioning enamel surface method. After the first and second bonding of metal brackets, new metal brackets were bonded with a total-etching adhesive after enamel conditioning using different methods: acid etching only (37% phosphoric acid for 30 seconds) (AE group), sodium hypochlorite associated with acid etching (5.25% NaOCl gel for 60 seconds and then acid etching for 30 seconds) (NaOCl-AE group), and sandblasting associated with acid etching (sandblasting for five seconds and then acid etching for 30 seconds) (SB-AE group). The shear bond strengths of the brackets were tested with a universal testing machine. One-way analysis of variance (ANOVA) and Tukey's honestly significant difference (HSD) tests were used to detect significant differences in shear bond strength among groups at the third bonding. Repeated-measure ANOVA and Bonferroni's tests were used to detect significant differences in shear bond strength among the bonding attempts within each group. RESULTS: 5.25% sodium hypochlorite associated with the acid etching method produced significantly greater shear bond strength than sandblasting associated with acid etching and acid etching only methods at the third bonding (16.40 ± 5.80 MPa, 13.60.47 ± 6.40 MPa, and 9.90 ± 4.40 MPa, respectively; P < 0.001). However, there was no significant difference between the AE and SB-AE groups (P = 0.247). In addition, we found a significant decrease in the shear bond strength within each group after each bonding attempt. CONCLUSION: Conditioning the enamel surface with 5.25% sodium hypochlorite associated with acid etching produced greater bond strength than conditioning by sandblasting associated with acid etching and acid etching only at the third bonding. The bond strength of the metal bracket decreased with increasing bonding attempts, even with the application of enamel surface conditioning methods.