A comparison of seal in seven supraglottic airway devices using a cadaver model of elevated esophageal pressure.

BACKGROUND: Supraglottic airway devices are increasingly important in clinical anesthesia and prehospital emergency medicine, but there are only few data to assess the risk for aspiration. We designed this study to compare the seal of seven supraglottic airway devices in a cadaver model of elevated esophageal pressure. METHODS: The classic laryngeal mask airway, laryngeal mask airway ProSeal, intubating laryngeal mask airway Fastrach, laryngeal tube, laryngeal tube LTS II, Combitube, and Easytube were inserted into unfixed human cadavers with an exposed esophagus that had been connected to a water column of 130 cm height. Slow and fast increases of esophageal pressure were performed and the water pressure at which leakage appeared was registered. RESULTS: The Combitube, Easytube, and intubating laryngeal mask Fastrach withstood the water pressure up to more than 120 cm H2O. The laryngeal mask airway ProSeal, laryngeal tube, and laryngeal tube LTS II were able to block the esophagus until 72-82 cm H2O. The classic laryngeal mask airway showed leakage at 48 cm H2O, but only minor leakage was found in the trachea. Devices with an additional esophageal drain tube drained fluid sufficiently without pulmonary aspiration. CONCLUSIONS: Concerning the risk of aspiration, the use of devices with an additional esophageal drainage lumen might be superior for use in patients with an increased risk of aspiration. The Combitube, Easytube, and intubating laryngeal mask Fastrach showed the best capacity to withstand an increase of esophageal pressure.

[Continuing medical education in Aesthetic Medicine: hands--on course on the usage of hyaluronic acids of different particle size on anatomic preparations]. / Fortbildung Asthetische Medizin: Hospitationskurs zur Anwendung von Hyaluronsäurepräparaten unterschiedlicher Partikelgrösse am anatomischen Präparat.

The Division of Evidence Based Medicine (dEBM), Clinic for Dermatology, Venerology and Allergology, Charité--Universitätsmedizin Berlin, offers on a regular basis workshops focusing on different areas of aesthetic medicine. Once a year a joint course is provided in cooperation with the Institute of Anatomy, offering the participants the possibility to improve their injection techniques as well as their knowledge on the facial anatomy. This course is focused on treatment with hyaluronic acids of different particle size. Besides the classical indications, it considers new indications such as correcting the shape of the nose or lacrimal groove. Thirteen physicians participated in the course, which was evaluated as very helpful as it improved not only the injection technique but also the knowledge of anatomy.

[Optimization of conventional X-ray images for the detection of hook of hamate fractures]. / Optimierung von konventionellen Röntgenaufnahmen zur Erkennung von Hamulus ossis hamati Frakturen.

Fractures of the hook of the hamate are a rare event. The fracture cannot always be detected clinically and standard radiographs do not always provide an overlap-free image of the hook of the hamate, so that fractures can easily be overlooked. The objective of the present study was to examine if the sensitivity of detecting hamulus ossis hamati fractures can further be improved by a modified conventional radiographic projection. After dissection of the hook of the hamate on 10 cadaver hands, a fracture was produced close to the base using a surgical chisel. Conventional radiographs were then performed in four different projections (dorso-palmar, lateral, carpal-tunnel and oblique view). The oblique view was obtained in a 45 degrees supination position, slight extension and radial duction, with the tube tilted from distal to proximal by 30 degrees. An axial spiral CT was used as a reference for detection of the fracture. The highest sensitivity of the conventional radiographs, with 8/10 identified fractures (80%), was achieved by the oblique view. The carpal-tunnel view with 4/10 (40%) and the dorso-palmar projection with 3/10 (30%) were much lower. All fractures were missed in the lateral projection. If all of the conventional radiographic projections are taken into account, the sensitivity is increased to 90%. All of the fractures were reliably detected in the axial CT-image. If a hamulus ossis hamati fracture is suspected clinically, in addition to the dorso-palmar and carpal-tunnel view, the special oblique view described here should be performed as a third projection plane, while the lateral view can be dispensed with. However, even if all projections are taken into account, a negative finding in the conventional radiographic imaging does not exclude a fracture with absolute certainty. In such cases, a CT or MRI should be performed to exclude a fracture.

Cribra orbitalia visualized in computed tomography.

Cribra orbitalia are sieve-like lesions of the orbital roof. While common in historic skulls, they have long been absent in those examined in the last decades. Only recently we found low-grade cribra orbitalia in some contemporary cases. Though of unknown origin, this lesion is often attributed to anemia and deficiency diseases. It is theoretically possible to visualize cribra orbitalia in living subjects by computed tomography and thus study their etiology. The aim of our study was to investigate the possibilities of computed tomography for visualizing cribra orbitalia. We used multislice computed tomography (MSCT) in the spiral and sequential mode to image medium-grade cribra orbitalia of moderate severity in a human skull. Virtual endoscopic and 3-D images were produced by post-processing. The best results were obtained by the sequential mode and 3-D reconstruction. Given a thin slice thickness and a wide slice angle between slice plane and the orbital roof, the threshold level seems to be the most important factor influencing realistic reproduction and should be finely adjusted according to bone density. Clinical research may now begin by examining relevant patients undergoing CT.

Minimal Invasive Fixation of Hamate Hook Fractures Through a Dorsal Percutaneous Approach Using a Mini Compression Screw: An Experimental Feasibility Study.

PURPOSE: Isolated fractures of the hamate hook can be treated by conservative or surgical means. Because nonoperative treatment is associated with high nonunion rates, surgical treatment with open reduction and internal fixation through a palmar approach is often preferred. The aim of this study was to refine surgical treatment of hamate hook fractures using a cannulated mini compression screw through a dorsal percutaneous approach. METHODS: Artificial fractures of the hamate hook were created in five male cadaver hands under fluoroscopy. Using an ulnar approach, the hamate hook was fractured at the base (n = 3) and middle third (n = 2) of the hook using an osteotome. Each fracture was visualized by X-ray and computed tomography. Under fluoroscopy, the fracture was stabilized with a 1.1 mm K wire through a dorsal percutaneous approach which guided the introduction of a 3 mm diameter cannulated mini compression screw. The screw position was then controlled by X-ray and computed tomography. RESULTS: Percutaneous fixation of the fractured hook through the dorsal approach was achieved in all cases. Regardless of the fracture location, all fragments were adapted into anatomically correct positions. No displacement or disruption of the cortex of the hook was observed with central screw positioning. CONCLUSION: Minimal invasive repair of isolated hamate hook fractures through a dorsal percutaneous approach is feasible. The special properties of the cannulated mini compression screw allow optimal screw positioning and stable fixation without risk of diplacement or disruption of the hook fragment.