RESUMO
Biological photo-voltaic systems are a type of microbial fuel cell employing photosynthetic microbes at the anode, enabling the direct transduction of light energy to electrical power. Unlike the anaerobic bacteria found in conventional microbial fuel cells that use metals in the environment as terminal electron acceptors, oxygenic photosynthetic organisms are poorly adapted for electron transfer out of the cell. Mutant strains of the cyanobacterium Synechocystis sp. PCC 6803 were created in which all combinations of the three respiratory terminal oxidase complexes had been inactivated. These strains were screened for the ability to reduce the membrane-impermeable soluble electron acceptor ferricyanide, and the results were compared to the performance of the mutants in a biological photo-voltaic system. Deletion of the two thylakoid-localised terminal oxidases, the bd-quinol oxidase and cytochrome c oxidase resulted in a 16-fold increase in ferricyanide reduction rate in the dark compared to the wild-type. A further improvement to a 24-fold increase was seen upon deletion of the remaining "alternative respiratory terminal oxidase". These increases were reflected in the peak power generated in the biological photo-voltaic systems. Inactivation of all three terminal oxidase complexes resulted in a substantial redirection of reducing power; in the dark the equivalent of 10% of the respiratory electron flux was channelled to ferricyanide, compared to less than 0.2% in the wild-type. Only minor improvements in ferricyanide reduction rates over the wild-type were seen in illuminated conditions, where carbon dioxide is preferentially used as an electron sink. This study demonstrates the potential for optimising photosynthetic microbes for direct electrical current production.
Assuntos
Oxirredutases/metabolismo , Synechocystis/enzimologia , Eletricidade , Eletrodos , Ferricianetos/química , Ferricianetos/metabolismo , Mutação , Oxirredução , Oxirredutases/genética , Oxigênio/química , Oxigênio/metabolismoRESUMO
A large variety of new energy-generating technologies are being developed in an effort to reduce global dependence on fossil fuels, and to reduce the carbon footprint of energy generation. The term 'biological photovoltaic system' encompasses a broad range of technologies which all employ biological material that can harness light energy to split water, and then transfer the resulting electrons to an anode for power generation or electrosynthesis. The use of whole cyanobacterial cells is a good compromise between the requirements of the biological material to be simply organized and transfer electrons efficiently to the anode, and also to be robust and able to self-assemble and self-repair. The principle that photosynthetic bacteria can generate and transfer electrons directly or indirectly to an anode has been demonstrated by a number of groups, although the power output obtained from these devices is too low for biological photovoltaic devices to be useful outside the laboratory. Understanding how photosynthetically generated electrons are transferred through and out of the organism is key to improving power output, and investigations on this aspect of the technology are the main focus of the present review.
Assuntos
Cianobactérias/metabolismo , Fontes de Energia Bioelétrica , Cianobactérias/fisiologia , Transporte de Elétrons , Oxirredução , FotossínteseRESUMO
CRISPR-interference (CRISPRi) is a powerful genetic tool with wide application in bacteria. In this work a single plasmid system is presented which expresses deactivated Cas9 and a short guide RNA sequence from separate inducible promoters, enabling up to 40-fold repression of target genes with minimal leaky repression in the uninduced state. The plasmid is designed for rapid spacer insertion with easy screening for correct clones, and a simple one-day protocol with >99.9% assembly efficiency is described. This plasmid is made available to the research community with a view to facilitating wider use of CRISPRi in bacterial systems.
RESUMO
Bioelectrochemical approaches for energy conversion rely on efficient wiring of natural electron transport chains to electrodes. However, state-of-the-art exogenous electron mediators give rise to significant energy losses and, in the case of living systems, long-term cytotoxicity. Here, we explored new selection criteria for exogenous electron mediation by examining phenazines as novel low-midpoint potential molecules for wiring the photosynthetic electron transport chain of the cyanobacterium Synechocystis sp. PCC 6803 to electrodes. We identified pyocyanin (PYO) as an effective cell-permeable phenazine that can harvest electrons from highly reducing points of photosynthesis. PYO-mediated photocurrents were observed to be 4-fold higher than mediator-free systems with an energetic gain of 200 mV compared to the common high-midpoint potential mediator 2,6-dichloro-1,4-benzoquinone (DCBQ). The low-midpoint potential of PYO led to O2 reduction side-reactions, which competed significantly against photocurrent generation; the tuning of mediator concentration was important for outcompeting the side-reactions whilst avoiding acute cytotoxicity. DCBQ-mediated photocurrents were generally much higher but also decayed rapidly and were non-recoverable with fresh mediator addition. This suggests that the cells can acquire DCBQ-resistance over time. In contrast, PYO gave rise to steadier current enhancement despite the co-generation of undesirable reactive oxygen species, and PYO-exposed cells did not develop acquired resistance. Moreover, we demonstrated that the cyanobacteria can be genetically engineered to produce PYO endogenously to improve long-term prospects. Overall, this study established that energetic gains can be achieved via the use of low-potential phenazines in photosynthetic bioelectrochemical systems, and quantifies the factors and trade-offs that determine efficacious mediation in living bioelectrochemical systems.
RESUMO
A central aim of synthetic biology is to build organisms that can perform useful activities in response to specified conditions. The digital computing paradigm which has proved so successful in electrical engineering is being mapped to synthetic biological systems to allow them to make such decisions. However, stochastic molecular processes have graded input-output functions, thus, bioengineers must select those with desirable characteristics and refine their transfer functions to build logic gates with digital-like switching behaviour. Recent efforts in genome mining and the development of programmable RNA-based switches, especially CRISPRi, have greatly increased the number of parts available to synthetic biologists. Improvements to the digital characteristics of these parts are required to enable robust predictable design of deeply layered logic circuits.
Assuntos
Biologia Computacional/métodos , Redes Reguladoras de Genes/genética , Biologia Sintética/métodos , Bactérias/genética , Sistemas CRISPR-Cas/genética , Linhagem Celular Tumoral , Proteínas de Ligação a DNA/genética , Células HeLa , Humanos , MicroRNAs/genéticaRESUMO
Synthetic biologists aim to construct novel genetic circuits with useful applications through rational design and forward engineering. Given the complexity of signal processing that occurs in natural biological systems, engineered microbes have the potential to perform a wide range of desirable tasks that require sophisticated computation and control. Realising this goal will require accurate predictive design of complex synthetic gene circuits and accompanying large sets of quality modular and orthogonal genetic parts. Here we present a current overview of the versatile components and tools available for engineering gene circuits in microbes, including recently developed RNA-based tools that possess large dynamic ranges and can be easily programmed. We introduce design principles that enable robust and scalable circuit performance such as insulating a gene circuit against unwanted interactions with its context, and we describe efficient strategies for rapidly identifying and correcting causes of failure and fine-tuning circuit characteristics.
Assuntos
Redes Reguladoras de Genes , Marcação de Genes/métodos , Engenharia Genética/métodos , Genoma Microbiano , Biologia Sintética/métodosRESUMO
Microorganisms are able to respond effectively to diverse signals from their environment and internal metabolism owing to their inherent sophisticated information processing capacity. A central aim of synthetic biology is to control and reprogramme the signal processing pathways within living cells so as to realise repurposed, beneficial applications ranging from disease diagnosis and environmental sensing to chemical bioproduction. To date most examples of synthetic biological signal processing have been built based on digital information flow, though analogue computing is being developed to cope with more complex operations and larger sets of variables. Great progress has been made in expanding the categories of characterised biological components that can be used for cellular signal manipulation, thereby allowing synthetic biologists to more rationally programme increasingly complex behaviours into living cells. Here we present a current overview of the components and strategies that exist for designer cell signal processing and decision making, discuss how these have been implemented in prototype systems for therapeutic, environmental, and industrial biotechnological applications, and examine emerging challenges in this promising field.