Control of the pore architecture in three-dimensional hydroxyapatite-reinforced hydrogel scaffolds.

Hydrogels (gellan or agarose) reinforced with nanocrystalline carbonated hydroxyapatite (nCHA) were prepared by the GELPOR3D technique. This simple method is characterized by compositional flexibility; it does not require expensive equipment, thermal treatment, or aggressive or toxic solvents, and yields a three-dimensional (3D) network of interconnected pores 300-900 µm in size. In addition, an interconnected porosity is generated, yielding a hierarchical porous architecture from the macro to the molecular scale. This porosity depends on both the drying/preservation technology (freeze drying or oven drying at 37 ○C) and on the content and microstructure of the reinforcing ceramic. For freeze-dried samples, the porosities were approximately 30, 66 and below 3% for pore sizes of 600-900 µm, 100-200 µm and 50-100 nm, respectively. The pore structure depends much on the ceramic content, so that higher contents lead to the disappearance of the characteristic honeycomb structure observed in low-ceramic scaffolds and to a lower fraction of the 100-200-µm-sized pores. The nature of the hydrogel did not affect the pore size distribution but was crucial for the behavior of the scaffolds in a hydrated medium: gellan-containing scaffolds showed a higher swelling degree owing to the presence of more hydrophilic groups.

Design of 3D Scaffolds for Hard Tissue Engineering: From Apatites to Silicon Mesoporous Materials.

Advanced bioceramics for bone regeneration constitutes one of the pivotal interests in the multidisciplinary and far-sighted scientific trajectory of Prof. Vallet Regí. The different pathologies that affect osseous tissue substitution are considered to be one of the most important challenges from the health, social and economic point of view. 3D scaffolds based on bioceramics that mimic the composition, environment, microstructure and pore architecture of hard tissues is a consolidated response to such concerns. This review describes not only the different types of materials utilized: from apatite-type to silicon mesoporous materials, but also the fabrication techniques employed to design and adequate microstructure, a hierarchical porosity (from nano to macro scale), a cell-friendly surface; the inclusion of different type of biomolecules, drugs or cells within these scaffolds and the influence on their successful performance is thoughtfully reviewed.

Suppression of anoikis by collagen coating of interconnected macroporous nanometric carbonated hydroxyapatite/agarose scaffolds.

Three dimensional interconnected macroporous (pore diameter: 600-800 µm) hydroxyapatite/agarose disks have been evaluated in this study as potential bone regeneration scaffolds. With this purpose, the adhesion and proliferation of human Saos-2 osteoblasts on this biomaterial were analyzed. As an index of cell function, the following parameters were measured: cell morphology, viability, cell size/complexity, cell cycle, reactive oxygen species (ROS) content, and lactate dehydrogenase (LDH) release. The existence of anoikis induced by inappropriate contacts between the cell and the scaffold has been detected by scanning electron microscopy, confocal microscopy, and flow cytometry. The intracellular nitric oxide content has been also measured as potential inducer of anoikis. The positive effects of previous scaffold coating with type I collagen on osteoblast adhesion as well as the collagen protection against anoikis have been demonstrated in this study.