Selective separation of furfural and hydroxymethylfurfural from an aqueous solution using a supported hydrophobic deep eutectic solvent liquid membrane.

For the first time, 12 different supported deep eutectic solvent (DES) liquid membranes were prepared and characterized. These membranes consist of a polymeric support impregnated with a hydrophobic DES. First, the different membranes were characterized and their stability in water and air was determined. Subsequently, the supported DES liquid membranes were applied for the recovery of furfural (FF) and hydroxymethylfurfural (HMF) from aqueous solutions. The effects of substrate properties (e.g. pore size), DES properties (e.g. viscosity) and concentrations of FF and HMF in the feed phase on the observed diffusivities and permeabilities were assessed. It was found that the addition of DES enhances the transport of FF and HMF through the polymeric membrane support. In particular, the use of the DES consisting of thymol + lidocaine (in the molar ratio 2 : 1) impregnated in a polyethylene support resulted in enhanced transport for both FF and HMF, and is most interesting for (in situ) isolation of FF and HMF from aqueous solutions, e.g. in biorefinery processes.

Vapor Pressure Assessment of Sulfolane-Based Eutectic Solvents: Experimental, PC-SAFT, and Molecular Dynamics.

Since their discovery, deep eutectic solvents (DES) have been explored in multiple applications. However, the complete physicochemical characterization is still nonexistent for many of the proposed and used DES. In particular, vapor pressure, which is a crucial property for the application of DES as solvents, is very rarely available. In this work, the measurement of the total and partial pressures of two sulfolane-based DES, tetrabutylammonium bromide:sulfolane and tetrabutylphosphonium bromide:sulfolane, in several proportions, from 40 to 100 °C and atmospheric pressure, was performed using headspace gas chromatography mass spectrometry, HS-GC-MS. A large decrease on the total pressure was recorded which, together with the finding that total pressures showed negative deviations from Raoult's law, is indicative of the favorable, strong interactions between the two components within the DES. Additionally, the study of vapor pressure change with DES molar composition was carried out, and surprisingly, the existence of inflection points in the pressure curve was observed. Experimental results were modeled using the PC-SAFT equation of state, and in addition, MD simulations were performed to provide a molecular understanding of the pressure data. Considering the different results and insights obtained from the used strategies, it can be concluded that both DES systems have especially strong interactions between salt and sulfolane, at high sulfolane content, due to the different structural rearrangement of the liquid state.

Removal of alkali and transition metal ions from water with hydrophobic deep eutectic solvents.

Hydrophobic deep eutectic solvents were used for the first time for the removal of metal ions from non-buffered water. It was shown that the extraction occurs via an ion exchange mechanism in which all transition metal ions could be extracted with high distribution coefficients, even for high Co2+ concentrations and low DES/water mass ratios. Maximum extraction efficiency could be reached within 5 s and regeneration was possible.

Bis(phenolate)amine-supported lanthanide borohydride complexes for styrene and trans-1,4-isoprene (co-)polymerisations.

New bis(phenolate)amine-supported neodymium borohydride complexes and their previously reported samarium analogues were tested as catalysts for the polymerisation of styrene and isoprene. Reaction of Na2O2N(L) (L = py, OMe, NMe2) with Nd(BH4)3(THF)3 afforded the borohydride complexes Nd(O2N(L))(BH4)(THF) (L = py (1-Nd), OMe (2-Nd), NMe2 (3-Nd)). Complex 1-Nd has shown a propensity to form phenolate-O-bridged dimer [Nd(µ-O2N(py))(BH4)]2 (1'-Nd) as previously observed with the samarium analogues Sm(O2N(L))(BH4)(THF) (L = py or Pr). X-ray structures of 1'-Nd and 2-Nd were determined and are presented. The neodymium borohydride complexes 1-Nd to 3-Nd and their samarium analogues Sm(O2N(L))(BH4)(THF)x (L = py (1-Sm), OMe (2-Sm), NMe2 (3-Sm), Pr (4-Sm)) were tested as catalysts for the polymerisation of isoprene and styrene in the presence of n-butylethylmagnesium (Mg((n)Bu)(Et)). All complexes were found to be active for the polymerisation of isoprene in these conditions, leading to polyisoprene up to 95.1% trans-1,4 stereoregular. They were also found to be active for the polymerisation of styrene leading to atactic polystyrene in all cases. Interestingly, samarium-based complexes were found to be more active than the neodymium ones toward this latter monomer, in sharp contrast to what is usually observed with rare earth borohydride complexes. The structure of both trans-polyisoprenes and polystyrenes obtained were studied in detail by MALDI-ToF analysis in order to better understand the polymerisation mechanisms. The coordinative chain transfer polymerisation (CCTP) of both monomers was further conducted using Mg((n)Bu)(Et) as transfer agent. Finally, the statistical copolymerisation of isoprene and styrene was examined using these catalytic systems, leading to the formation of poly[(trans-1,4-isoprene)-co-styrene] with up to 39% of styrene moieties inserted in a highly trans-1,4-stereoregular polyisoprene.