Optimization of a pre-concentration method for the analysis of mercury isotopes in low-concentration foliar samples.

Hg isotope analysis in samples from background regions is constrained by the presence of low Hg concentration and therefore requires a pre-concentration method. Existing Hg pre-concentration methods are constrained by long sample processing time and limited sample loading capacity. Using foliar samples as a test case, an optimized Hg pre-concentration method is presented that involves the microwave-assisted digestion of samples for Hg isotope analysis with the addition of a pre-digestion step. Microwave-digested foliar samples and CRMs were transferred to an impinger, reduced with SnCl2, and collected in a 2.25 mL concentrated inverse aqua regia (3:1 HNO3:HCl, v/v). This resulted in an optimal acid concentration in the solution ideal for analysis on MC-ICP-MS. The time for purging with Hg-free N2 was optimized to 30 min and the efficiency of the pre-concentration method was tested using a combination of approaches. Tests performed on pure reagents and matrix of foliar samples spiked with 197Hg radiotracer showed recoveries averaging 99 ± 1.7% and 100 ± 3.0%, respectively. Mercury at concentrations as low as 1.83 ng g-1 was pre-concentrated by digesting aliquots of foliage samples in individual digestion vessels. Recoveries following their pre-concentration averaged 99 ± 6.0%, whereas recoveries of 95 ± 4.7% and 95 ± 2.5% were achieved for NIST SRM 1575a (pine needle) and reagents spiked with NIST SRM 3133, respectively. Analysis using multicollector-ICP-MS showed low fractionation of δ202Hg during sample pre-concentration with no significant mass-independent fractionation. The proposed method is a relatively simple and robust way to prepare Hg samples for Hg isotopic analysis and is suitable even for complex biological matrices.

Calibration Approach for Gaseous Oxidized Mercury Based on Nonthermal Plasma Oxidation of Elemental Mercury.

Atmospheric mercury measurements carried out in the recent decades have been a subject of bias largely due to insufficient consideration of metrological traceability and associated measurement uncertainty, which are ultimately needed for the demonstration of comparability of the measurement results. This is particularly challenging for gaseous HgII species, which are reactive and their ambient concentrations are very low, causing difficulties in proper sampling and calibration. Calibration for atmospheric HgII exists, but barriers to reliable calibration are most evident at ambient HgII concentration levels. We present a calibration of HgII species based on nonthermal plasma oxidation of Hg0 to HgII. Hg0 was produced by quantitative reduction of HgII in aqueous solution by SnCl2 and aeration. The generated Hg0 in a stream of He and traces of reaction gas (O2, Cl2, or Br2) was then oxidized to different HgII species by nonthermal plasma. A highly sensitive 197Hg radiotracer was used to evaluate the oxidation efficiency. Nonthermal plasma oxidation efficiencies with corresponding expanded standard uncertainty values were 100.5 ± 4.7% (k = 2) for 100 pg of HgO, 96.8 ± 7.3% (k = 2) for 250 pg of HgCl2, and 77.3 ± 9.4% (k = 2) for 250 pg of HgBr2. The presence of HgO, HgCl2, and HgBr2 was confirmed by temperature-programmed desorption quadrupole mass spectrometry (TPD-QMS). This work demonstrates the potential for nonthermal plasma oxidation to generate reliable and repeatable amounts of HgII compounds for routine calibration of ambient air measurement instrumentation.

Validating an Evaporative Calibrator for Gaseous Oxidized Mercury.

Understanding atmospheric mercury chemistry is the key for explaining the biogeochemical cycle of mercury and for improving the predictive capability of computational models. Increased efforts are being made to ensure comparable Hg speciation measurements in the air through establishing metrological traceability. While traceability for elemental mercury has been recently set, this is by no means the case for gaseous oxidized mercury (GOM). Since a calibration unit suitable for traceable GOM calibrations based on evaporation of HgCl2 solution was recently developed, the purpose of our work was to extensively evaluate its performance. A highly specific and sensitive 197Hg radiotracer was used for validation over a wide range of concentrations. By comparing experimental and calculated values, we obtained recoveries for the calibration unit. The average recoveries ranged from 88.5% for 1178 ng m-3 HgCl2 gas concentration to 39.4% for 5.90 ng m-3 HgCl2 gas concentration. The losses were due to the adsorption of oxidized Hg on the inner walls of the calibrator and tubing. An adsorption isotherm was applied to estimate adsorption enthalpy (ΔHads); a ΔHads value of -12.33 kJ mol-1 was obtained, suggesting exothermal adsorption. The results of the calibrator performance evaluation suggest that a newly developed calibration unit is only suitable for concentrations of HgCl2 higher than 1 µg m-3. The concentration dependence of recoveries prevents the system from being used for calibration of instruments for ambient GOM measurements. Moreover, the previously assessed uncertainty of this unit at µg m-3 level (2.0%, k = 2) was re-evaluated by including uncertainty related to recovery and was found to be 4.1%, k = 2. Calibrator performance was also evaluated for HgBr2 gas calibration; the recoveries were much lower for HgBr2 gas than for HgCl2 gas even at a high HgBr2 gas concentration (>1 µg m-3). As HgBr2 is often used as a proxy for various atmospheric HgBr species, the suitability of the unit for such calibration must be further developed.

Application of traceable calibration for gaseous oxidized mercury in air.

BACKGROUND: The current speciation methods for mercury (Hg) measurements are fraught with considerable uncertainty, from sample collection to calibration. High reactivity of gaseous oxidized Hg (GOM) species and their ultra-trace level presence makes them difficult to sample and calibrate. Given that improper calibration may lead to measurement biases, reliable and metrologically traceable calibration methods are required for accurately quantifying GOM in air. In the present study, we applied the recently developed calibration method based on non-thermal plasma oxidation of elemental Hg, to a commercially available Hg air speciation system for actual environmental measurements of GOM for the first time. RESULTS: Hg species such as HgO, HgCl2, and HgBr2 were produced with trace amounts of reactant gases (oxygen and electrolytically produced chlorine and bromine) and the production was driven by plasma-assisted oxidation. The plasma oxidation efficiency of elemental Hg with oxygen was 98.5 ± 7.5 % (k = 2), while that for chlorine and bromine was 96.8 ± 6.9 % (k = 2) and 97.4 ± 9.6 % (k = 2), respectively. The calibration method was tested against the internal permeation (Hg0) source of the Tekran 2537B Hg analyzer on-field by loading HgO to different KCl-coated denuders using the plasma. GOM concentrations were measured using the Tekran speciation system. With internal calibration, concentrations were up to 9.1 % lower than those in plasma calibration, thereby emphasizing the importance of the calibration strategy. Measurement uncertainty (k = 2) further emphasizes this distinction. Internal calibration measurement uncertainty was 36.8 %, while plasma calibration boasted lower uncertainty at 13.8 %. SIGNIFICANCE: The non-thermal plasma calibration strategy, as a unique and discrete calibration method traceable to the NIST SRM 3133 for ambient air GOM measurements, provide a higher level of confidence in the accuracy of GOM measurements with several advantages over other methods. Calibrations at extreme low concentrations (<100 pg) are possible with this method relevant to ambient air GOM concentrations.

Comparison of active measurements, lichen biomonitoring, and passive sampling for atmospheric mercury monitoring.

The number of atmospheric mercury (Hg) monitoring stations is growing globally. However, there are still many regions and locations where Hg monitoring is limited or non-existent. Expansion of the atmospheric Hg monitoring network could be facilitated by the use of cost-effective monitoring methods. As such, biomonitoring and passive monitoring offer a unique alternative to well-established monitoring by active measurements, since they do not require a power supply and require minimal workload to operate. The use of biomonitoring (lichens and mosses) and passive air samplers (PASs) (various designs with synthetic materials) has been reported in the literature, and comparisons with active measurement methods have also been made. However, these studies compared either biomonitoring or PASs (not both) to only one type of active measurement. In our work, we used transplanted (7 sampling sites) and in situ lichens (8 sampling sites) for biomonitoring, two PASs from different producers (3 sampling sites), and two different active measurement types (continuous and discontinuous active measurements, 1 and 8 sampling sites, respectively) to evaluate their effectiveness as monitoring methods. In the 9-month sampling campaign, 3 sampling locations with different characteristics (unpolluted, vicinity of a cement plant, and vicinity of a former Hg mine) were used. The results obtained with lichens and PASs clearly distinguished between sampling locations with different Hg concentrations; using both PASs and lichens together increased the confidence of our observations. The present work shows that biomonitoring and passive sampling can be effectively used to identify areas with elevated atmospheric Hg concentrations. The same can be said for discontinuous active measurements; however, the discrepancy between atmospheric Hg concentrations derived from PASs and discontinuous active measurements should be further investigated in the future.

Tree rings as historical archives of atmospheric mercury: A critical review.

Historical concentrations of atmospheric mercury (Hg) are uncertain, as monitoring only began a few decades ago. Tree rings can serve as historical archives of Hg, providing centennial trends. The vast majority of tree-ring Hg studies have been published in the last decade, demonstrating the growing use of tree rings for Hg dendrochemistry. Thus, there is a need for a systematic review on current knowledge of tree rings as archives of atmospheric Hg. In this review, the predominant pathways of Hg uptake to tree rings are discussed, including the initial Hg uptake from the surrounding environment, fixation, and subsequent translocation. Foliar uptake of Hg was found to be the most important uptake route for Hg in tree rings, the root and bark route being negligible. Our summary of the suitability of different tree species indicates that radial translocation is the biggest limiting factor for Hg dendrochemistry, shifting and blurring historical Hg trends. Based on the review findings, Picea (spruce) and Larix (larch) are the most promising genera for Hg dendrochemistry. Additionally, the use of tree-ring Hg archives in combination with other co-located archives, namely lake sediments, peat, and ice, is suggested as it enhances the viability of observed tree-ring historical Hg trends. Finally, we propose future directions and recommendations for research using tree-ring Hg, including sampling protocols, experimental designs, and tree selection.

Dispersion of airborne mercury species emitted from the cement plant.

The cement industry is the second largest source of anthropogenic mercury (Hg) emissions in Europe, accounting for 11% of global anthropogenic Hg emissions. The main objective of this study was to examine the influence of Hg emissions from the Salonit Anhovo cement plant on Hg levels measured in the ambient air at Vodarna, 1 km downwind from the flue gas chimney. The findings reveal that the plant raw mill operational status plays an important role in Hg concentrations in the flue gas emitted from the plant. Emitted total gaseous mercury was, on average, higher (49.4 µg/m3) when raw mills were in the direct mode (both raw mills-off) and lower (23.4 µg/m3) in the combined mode (both raw mills-on). The average Hg concentrations in Vodarna were 3.14 ng/m3 for gaseous elemental mercury, 53.7 pg/m3 for gaseous oxidised mercury, and 41.9 pg/m3 for particulate bound mercury for the whole measurement period. Atmospheric Hg speciation in Vodarna, coupled with plant emissions and wind data, has revealed that the total gaseous mercury emitted from the cement plant is clearly related to all Hg species measured in Vodarna. Wind blowing from the northeastern quadrant (mostly NE, ENE) is responsible for the elevated Hg levels in Vodarna, where gaseous oxidised mercury levels are highly linked to the cement plant emissions. However, elevated levels of Hg species in the absence of northeastern winds indicate potential inputs from other unknown local sources as well as inputs from regional and global transport mechanisms.

Liquid scintillation counter calibration approach for 90Sr detection and testing performance of TK100 resin.

90Sr detection efficiency determination was applied for liquid scintillation counting (LSC) by computing a model for the relation between detection efficiency and the time passed since radiochemical separation. This allowed more flexibility in analysis times after separation as the model accounts for 90Y in-growth. Establishment of secular equilibrium was therefore not required for LSC measurements. In addition, this approach increases counting efficiency compared to classical ones as both 90Sr and 90Y spectrums are used. This in turn has a positive impact on minimum detectable activity. The method was validated using proficiency test samples for both Cerenkov radiation measurement and scintillation cocktail measurement. Commonly used extraction material Sr-resin was compared to alternative, TK100 resin. Inductively-coupled plasma mass spectrometry measurements for recovery determination showed limitations for TK100 usage due to incomplete Sr retention on the resin. Limitations were further confirmed by LSC activity measurements.