Evaluation of Serum Proteome Sample Preparation Methods to Support Clinical Proteomics Applications.

Serum contains several proteins that are associated with disease-related processes. Mass spectrometry (MS)-based proteomics approaches greatly facilitate serum protein biomarker development. However, the serum proteome complexity presents a technical challenge for the accurate, sensitive, and reproducible quantification of proteins by MS. Thus, efficient sample preparation methods are of critical importance for serum proteome analyses. In this study, we evaluated the technical performance of two serum proteome sample preparation methods using sera from patients with high-grade serous ovarian cancer and patients with benign nongynecological conditions with a goal of providing insight into their compatibility with clinical proteomics workflows. One method entailed the use of immobilized trypsin (SMART Digest Trypsin) with RapiGest SF, an acid-labile surfactant designed to enhance the in-solution enzymatic digestion of proteins. The other method incorporated a commercially available sample preparation kit, iST-BCT, which contains standardized reagents. Significantly higher protein sequence coverage, albeit with lower digestion efficiency, was obtained with the immobilized trypsin + RapiGest SF workflow, whereas the iST-BCT workflow was quicker and had marginally better reproducibility. Protein relative abundance analysis revealed that the serum proteomes clustered primarily by the sample processing workflow and secondarily by disease state. We conducted a time course study to determine whether differences in the relative abundance of diagnostic high-grade serous ovarian cancer serum protein biomarker candidates were biased according to the duration of enzymatic digestion. Our results highlight the importance of optimizing enzymatic digestion kinetics according to the peptide targets of interest while considering the sensitivity of the downstream analytical method utilized in clinical proteomics workflows designed to measure biomarkers.

R-Loop Accumulation in Spliceosome Mutant Leukemias Confers Sensitivity to PARP1 Inhibition by Triggering Transcription-Replication Conflicts.

RNA splicing factor (SF) gene mutations are commonly observed in patients with myeloid malignancies. Here we showed that SRSF2- and U2AF1-mutant leukemias are preferentially sensitive to PARP inhibitors (PARPi), despite being proficient in homologous recombination repair. Instead, SF-mutant leukemias exhibited R-loop accumulation that elicited an R-loop-associated PARP1 response, rendering cells dependent on PARP1 activity for survival. Consequently, PARPi induced DNA damage and cell death in SF-mutant leukemias in an R-loop-dependent manner. PARPi further increased aberrant R-loop levels, causing higher transcription-replication collisions and triggering ATR activation in SF-mutant leukemias. Ultimately, PARPi-induced DNA damage and cell death in SF-mutant leukemias could be enhanced by ATR inhibition. Finally, the level of PARP1 activity at R-loops correlated with PARPi sensitivity, suggesting that R-loop-associated PARP1 activity could be predictive of PARPi sensitivity in patients harboring SF gene mutations. This study highlights the potential of targeting different R-loop response pathways caused by spliceosome gene mutations as a therapeutic strategy for treating cancer. SIGNIFICANCE: Spliceosome-mutant leukemias accumulate R-loops and require PARP1 to resolve transcription-replication conflicts and genomic instability, providing rationale to repurpose FDA-approved PARP inhibitors for patients carrying spliceosome gene mutations.

Simplified Mass Spectrometric Analysis of Ceramides using a Common Collision Energy.

Ceramides (CER) are biologically active sphingolipid precursors that are mechanistically linked to several pathogenic states including cancer, insulin resistance, and neurodegeneration. CER are commonly quantified through mass spectrometry-based methods founded upon a product ion scan (PIS) in positive mode to produce a characteristic m/z 264 ion. The ionization efficiency (IE) of CER species decreases with an increase in CER mass, thus quantitation of CER typically involves application of mass-dependent response factors (RF) for each CER species. In this work, we observed that the RF were systematically dependent on the number of fatty acid acyl carbons and the collision energy (CE) used to generate the m/z 264 ion. Using these complimentary trends, we determined an "isosbestic" CE where the RF for all CER species were equivalent, allowing for CER quantitation without postcollection correction factors. A comparison of this common CE/common RF method to the multiple RF method demonstrated good agreement between the two methods. Use of the common CE/common RF method will reduce data processing and reduce the use of multiple CER species standards.