Scalable multicast hybrid broadband-crossbar wavelength selective switch: proposal and analysis.

In this Letter, we present a new hybrid broadband-crossbar switching network that can switch multiple wavelengths on demand and can also multicast. This switch fabric is an improvement over our previous design in both switch footprint and power consumption, as it reduces the number of switching elements by approximately 50%. We compare the switch loss and crosstalk with that of a multiwavelength selective crossbar switch. We also comment on fabrication tolerance of second-order ring resonators based on experimental results of 64 second-order ring resonators, and more than 250 heaters.

2 λ switch.

We demonstrate an elastic multi-wavelength selective switch with up to two wavelength switching capability per crosspoint. We fabricated the switch in a silicon photonics foundry and demonstrated a 17 nm tuning range for ring resonators, with a mean path loss of 2.43 dB. This is a 70% reduction in path loss as compared to previous generations, and we demonstrate a high-speed pulse-amplitude-modulation-4 transmission at 111 Gbps through different paths of the switch.

Multi-wavelength selective crossbar switch.

Here we demonstrate an 8x4 multi-wavelength selective ring resonator based crossbar switch matrix implemented in a 220-nm silicon photonics foundry for interconnecting electronic packet switches in scalable data centers. This switch design can dynamically assign up to two wavelength channels for any port-port connection, providing almost full connectivity with significant reduction in latency, cost and complexity. The switch unit cell insertion loss was measured at 0.8 dB, with an out-of-band rejection of 32 dB at 400 GHz channel separation. All the ring resonator heaters were thermally tuned, with heaters controlled by a custom 64-channel DAC driver. Detailed measurements on the whole switch showed standard deviation of 2 dB in losses across different paths, standard deviation of 0.33 nm in resonant wavelength and standard deviation of 0.01 nm/mW in ring heater tuning efficiency. Data transmission experiments at 40 Gbps showed negligible penalty due to crosstalk paths through the switch.

Sparse aperiodic arrays for optical beam forming and LIDAR.

We analyze optical phased arrays with aperiodic pitch and element-to-element spacing greater than one wavelength at channel counts exceeding hundreds of elements. We optimize the spacing between waveguides for highest side-mode suppression providing grating lobe free steering in full visible space while preserving the narrow beamwidth. Optimum waveguide placement strategies are derived and design guidelines for sparse (> 1.5 λ and > 3 λ average element spacing) optical phased arrays are given. Scaling to larger array areas by means of tiling is considered.

Forward bias operation of silicon photonic Mach Zehnder modulators for RF applications.

In this paper, we demonstrate that forward bias (+0.9V) of a high-speed silicon (Si) optical Mach-Zehnder modulator (MZM) increases the radio-frequency (RF) link gain by 30 dB when compared to reverse bias operation (-8V). RF applications require tunable, narrowband electro-optic conversion with high gain to mitigate noise of the optical receiver and realize high RF spur-free dynamic range. Compared to reverse bias, the forward bias gain rolls off more rapidly but offers higher RF link gain improvement of more than 13.2 dB at 20 GHz. Furthermore, forward bias is shown to result in comparable spurious-free dynamic range (SFDR: 104.5 dB.Hz2/3). We demonstrate through an analytical dc transfer curve the existence of simultaneous high gain and OIP3 and verify the theoretical results with measurement under forward bias at a bias point of around +0.9 V.

On-chip wavelength locking for photonic switches.

We present an on-chip wavelength reference with a partial drop ring resonator and germanium photodetector. This approach can be used in ring-resonator-based wavelength-selective switches where absolute wavelength alignment is required. We use the temperature dependence of heater resistance as a temperature sensor. Additionally, we discuss locking speed, statistical variation of heater resistances, and tuning speed of the switches.