Quantification and Detection of Ground Garlic Adulteration Using Fourier-Transform Near-Infrared Reflectance Spectra.

This study demonstrates the rapid and cost-effective possibility of quantifying adulterant amounts (corn flour or corn starch) in ground and dried garlic samples. Prepared mixtures with different concentrations of selected adulterant were effectively characterized using Fourier-transform near-infrared reflectance spectra (FT-NIR), and multivariate calibration models were developed using two methods: principal component regression (PCR) and partial least squares regression (PLSR). They were constructed for optimally preprocessed FT-NIR spectra, and PLSR models generally performed better regarding model fit and predictions than PCR. The optimal PLSR model, built to estimate the amount of corn flour present in the ground and dried garlic samples, was constructed for the first derivative spectra obtained after Savitzky-Golay smoothing (fifteen sampling points and polynomial of the second degree). It demonstrated root mean squared errors for calibration and validation samples equal to 1.8841 and 1.8844 (i.e., 1.88% concerning the calibration range), respectively, and coefficients of determination equal to 0.9955 and 0.9858. The optimal PLSR model constructed for spectra after inverse scattering correction to assess the amount of corn starch had root mean squared errors for calibration and validation samples equal to 1.7679 and 1.7812 (i.e., 1.77% and 1.78% concerning the calibration range), respectively, and coefficients of determination equal to 0.9961 and 0.9873. It was also possible to discriminate samples adulterated with corn flour or corn starch using partial least squares discriminant analysis (PLS-DA). The optimal PLS-DA model had a very high correct classification rate (99.66%), sensitivity (99.96%), and specificity (99.36%), calculated for external validation samples. Uncertainties of these figures of merit, estimated using the Monte Carlo validation approach, were relatively small. One-class classification partial least squares models, developed to detect the adulterant type, presented very optimistic sensitivity for validation samples (above 99%) but low specificity (64% and 45.33% for models recognizing corn flour or corn starch adulterants, respectively). Through experimental investigation, chemometric data analysis, and modeling, we have verified that the FT-NIR technique exhibits the required sensitivity to quantify adulteration in dried ground garlic, whether it involves corn flour or corn starch.

Surface Functionalization of Poly(l-lactide-co-glycolide) Membranes with RGD-Grafted Poly(2-oxazoline) for Periodontal Tissue Engineering.

Bone tissue defects resulting from periodontal disease are often treated using guided tissue regeneration (GTR). The barrier membranes utilized here should prevent soft tissue infiltration into the bony defect and simultaneously support bone regeneration. In this study, we designed a degradable poly(l-lactide-co-glycolide) (PLGA) membrane that was surface-modified with cell adhesive arginine-glycine-aspartic acid (RGD) motifs. For a novel method of membrane manufacture, the RGD motifs were coupled with the non-ionic amphiphilic polymer poly(2-oxazoline) (POx). The RGD-containing membranes were then prepared by solvent casting of PLGA, POx coupled with RGD (POx_RGD), and poly(ethylene glycol) (PEG) solution in methylene chloride (DCM), followed by DCM evaporation and PEG leaching. Successful coupling of RGD to POx was confirmed spectroscopically by Raman, Fourier transform infrared in attenuated reflection mode (FTIR-ATR), and X-ray photoelectron (XPS) spectroscopy, while successful immobilization of POx_RGD on the membrane surface was confirmed by XPS and FTIR-ATR. The resulting membranes had an asymmetric microstructure, as shown by scanning electron microscopy (SEM), where the glass-cured surface was more porous and had a higher surface area then the air-cured surface. The higher porosity should support bone tissue regeneration, while the air-cured side is more suited to preventing soft tissue infiltration. The behavior of osteoblast-like cells on PLGA membranes modified with POx_RGD was compared to cell behavior on PLGA foil, non-modified PLGA membranes, or PLGA membranes modified only with POx. For this, MG-63 cells were cultured for 4, 24, and 96 h on the membranes and analyzed by metabolic activity tests, live/dead staining, and fluorescent staining of actin fibers. The results showed bone cell adhesion, proliferation, and viability to be the highest on membranes modified with POx_RGD, making them possible candidates for GTR applications in periodontology and in bone tissue engineering.