Gamma irradiation effect on photocatalytic properties of Cu and Sr ions codoped PbS.

Gamma-irradiation effects on photocatalytic action of PbS nanocrystallites codoped with Cu and Sr ions were performed for organic dye degradation. The physical and chemical characterizations of these nanocrystallites were examined employing X-ray diffraction, Raman, and field emission electron microscopic analysis. The optical bandgaps of gamma-irradiated PbS with co-dopants have shifted from 1.95 eV (pristine PbS) to 2.45 eV in the visible spectrum. Under direct sunlight, the photocatalytic action of these compounds against methylene blue (MB) was investigated. Observations indicated that gamma-irradiated Pb(0.98)Cu0.01Sr0.01S nanocrystallite sample exhibits a higher photocatalytic degradation activity of 74.02% in 160 min and stability of 69.4% after three cycles, suggesting that gamma irradiation could potentially influence organic MB degradation. This is due to combined action of high-energy gamma irradiation (at an optimzed dose), which causes sulphur vacancies, and defects created by dopant ions, which alter the crystal structure by inducing strain in the crystal lattice, hence altering the crystallinity of PbS.

Conversion and reducing agent effect on zero valent iron into Fe3O4 for photocatalytic degradation under UV light irradiation.

Conversion and reducing agent (NaBH4) effect on zero valent iron into Fe3O4 nanoparticles with diverse molar ratios of reducing agent was produced through chemical reduction technique. The structural, optical, vibrational analyses were executed via XRD, UV-Vis, Raman, and FT-IR analysis. The crystallite size obtained were 35 nm, 27 nm, and 18 nm for Fe:NaBH4 (1:1), Fe:NaBH4 (1:2) and Fe:NaBH4 (1:3). The morphology of the Fe:NaBH4 (1:1) was not in good orientation with higher dimensions. As explored in Fe:NaBH4 (1:2) and (1:3) samples, there is a proper growth of nanoneedles and nanosheets formation. This was due to the addition of reducing agent which greatly helped in enhancement of morphology. The prepared photocatalysts were tested to reduce Malachite Green (MG) under UV illumination. The pure dye solution obtained 57% efficiency after irradiation. Fe:NaBH4 (1:3) photocatalyst achieved 97% efficiency on reducing pollutants. The rate constant values calculated was 0.007, 0.013, 0.02 and 0.03 min-1 for pure, Fe: NaBH4 (1:1), Fe: NaBH4 (1:2) and Fe: NaBH4 (1:3) assisted MG samples. The as prepared photocatalyst is more potential one on removal of toxic pollutants from wastewater which is due to the better enhancement of nanoneedles and nanosheets oriented by the effect of reducing agent. The advantage of Fe3O4 nanoparticles for wastewater is that the removal of these nanoparticles can be ease with magnetic separation methods. On considering the advantage of removing of photocatalyst and efficiency, this prepared product is suitable one for wastewater remediation process in future days.

γ-Ray-Induced Photocatalytic Activity of Bi-Doped PbS toward Organic Dye Removal under Sunlight.

Photocatalysts based on semiconducting chalcogenides due to their adaptable physio-chemical characteristics are attracting attention. In this work, Bi-doped PbS (henceforth PbS:Bi) was prepared using a straightforward chemical precipitation approach, and the influence of γ-irradiation on PbS's photocatalytic ability was investigated. Synthesized samples were confirmed structurally and chemically. Pb(1-x)BixS (x = 0, 0.005, 0.01, 0.02) samples that were exposed to gamma rays showed fine-tuning of the optical bandgap for better photocatalytic action beneath visible light. The photocatalytic degradation rate of the irradiated Pb0.995Bi0.005S sample was found to be 1.16 times above that of pure PbS. This is due to the occupancy of Bi3+ ions at surface lattice sites as a result of their lower concentration in PbS, which effectively increases interface electron transport and the annealing impact of gamma irradiation. Scavenger tests show that holes are active species responsible for deterioration of the methylene blue. The irradiated PbS:Bi demonstrated high stability after being used repeatedly for photocatalytic degradation.

Effect of grinding time on bismuth oxyhalides optical and morphological properties influence on photocatalytic removal of organic dye.

Herein, we reported the synthesis of BiOX (X = Cl, Br) with different grinding time like 15 min and 30 min to analyze the evolution of physiochemical properties and the morphological evolution. The structural, optical, vibrational properties were examined by standard characterization studies. The formation of bismuth oxyhalides were confirmed by XRD and Raman studies. The crystallite size was decreased as in 30 min grinded sample whereas there is an influence of crystal structure. BiOCl (15 and 30 min) samples expelled the nanoflake like structure with the flakes arranged to form a nanoflower morphology. On comparing BiOCl (15 min), there is high orientation of nanoflakes on BiOCl (30 min) sample. As explored in BiOBr (15 and 30 min) samples, the development of nanoplates were found. The growth of nanoplates was enhanced in the better way in BiOBr (30 min) than BiOBr (15 min). The grinding time has explored a great influence on morphology. The photocatalyst test for prepared photocatalysts was performed to reduce the RhB dye. The photocatalysts showed 74%, 97%, 98% and 99.8% for BiOCl (15 min), BiOCl (30 min), BiOBr (15 min) and BiOBr (30 min). The rate constant value obtained was 0.008, 0.011, 0.021, 0.033 and 0.068 min-1. BiOBr (30 min) sample achieved higher rate constant value. The hierarchical nanostructures and narrow bandgap has made the samples to be a potential candidate to reduce the toxic pollutants with complete efficiency.