RESUMO
Perovskite oxides of the general formula ABO3-δ, with A and B being metal cations, present themselves in various crystal structures that originate from a distorted ideal cubic perovskite. Understanding how composition, temperature, atmosphere and reduction extent of these non-stoichiometric redox materials induce structural changes on an atomic, as well as macroscopic, level is crucial to transfer newly developed materials to industrial scale applications in the redox-based energy conversion sector. Herein, Ca1-xSrxMnO3-δ (x ∈ [0,0.2]) and its micro- and macroscopic structural changes at elevated temperatures and varying oxygen partial pressure are analyzed by means of in situ high temperature XRD, DSC and dilatometry. Results are expanded by room temperature XRD of compositions with higher Sr-content up to x = 0.4. By adjusting the Sr-content, the formed crystal structure can be governed and thermal expansion can be impacted beneficially in the context of future applications utilizing monolithic structures. Phase transitions from orthorhombic to cubic were found to shift from 900 °C to 830 °C under air and to even lower temperatures under 1% O2 atmosphere. Small amounts of Sr-content (5-10%) stabilize the macroscopic structural integrity by improving the reversibility of the cyclic thermal expansion and contraction in a 1% O2 atmosphere. However, at Sr-contents of 20% an increased irreversible residual expansion within each thermal cycle becomes apparent and shows that such improvements do not follow a linear dependency with Sr-content, but most benefits in this context can be found at Sr-contents below 20%. The results demonstrate the sensitivity of such materials micro- and macroscopic characteristics to composition. In the context of utilization of monolithic structures, fabricated entirely from Ca1-xSrxMnO3-δ, in thermochemical or thermoelectric applications, the results have considerable significance as minor A-site Sr-substitution can substantially improve macroscopic stability of monolithic structures over multiple thermal cycles. Besides the often solely regarded thermodynamic characteristic, this work demonstrates the importance to consider the impact of composition on structural behavior in materials design processes including perovskites for thermochemical applications.
RESUMO
Oxide ceramic coatings in the system Y2O3-Al2O3-ZrO2 were fabricated in laboratory scale by using a MOCVD unit. A hot wall reactor was used along with different precursor feeding systems. Most experiments were carried out by using powder flash evaporation including a screw feeder for precursor powder delivery. For comparison, further samples were fabricated by using band flash evaporation and continuous evaporation from a crucible. Oxygen was used in all cases as reactant gas. Aluminium-tris-2,4-pentanedione (Al(acac)3), yttrium-tris-2,2,6,6-tetramethyl-3,5-heptanedione (Y(thd)3) and zirconium-tetrakis-2,2,6,6-tetramethyl-3,5-heptanedione (Zr(thd)4) were applied as metal-organic precursors because of their similar vaporization behaviour under the given conditions. The coating stoichiometry was varied from pure alumina to complex ternary compositions in the system Y2O3-Al2O3-ZrO2. Both kinds of ternary coatings fabricated by using flash evaporation methods show a nanolamellar microstructure in the as deposited state. Heat treating experiments at 1200 degrees C for up to 5 days enhance the lamellar character of the coating deposited by using powder flash evaporation. The lamellar microstructure is due to alternating YSZ enriched layers and YAG enriched layers in this state. However, the coating fabricated by using band flash evaporation shows a dense interpenetrating network of YSZ and YAG after heat treating instead of a lamellar microstructure observed in the as deposited state.