A comparison of adsorption of organic micropollutants onto activated carbon following chemically enhanced primary treatment with microsieving, direct membrane filtration and tertiary treatment of municipal wastewater.

The adsorption of organic micropollutants onto powdered activated carbon (PAC) was investigated in laboratory scale based on samples from four wastewater process streams (matrices); three from a pilot-scale plant with different degrees of physicochemical treatment of municipal wastewater and one from a full-scale activated sludge plant with post-precipitation. The pilot-scale treatment consisted of chemically enhanced primary treatment with microsieving followed by direct membrane filtration as microfiltration or ultrafiltration. The results showed highest adsorption of micropollutants in the tertiary (biologically and chemically) treated wastewater and lowest adsorption in the microsieve filtrate. Adsorption of micropollutants in the direct membrane microfiltration (200 nm) permeate was generally similar to that in the direct membrane ultrafiltration (3 nm) permeate. The higher adsorption of micropollutants in the tertiary treated wastewater could be related to a lower concentration of dissolved organic carbon (DOC) and lower affinity of DOC for PAC at low dosage (<15 mg PAC/L) in this matrix. At a PAC dose of 10 mg/L, sulfamethoxazole was removed by 33% in the tertiary treated wastewater and 7% in the direct membrane microfiltration permeate. In addition to the PAC experiments, a pilot scale sand filter and a proceeding GAC filter was operated on tertiary treated wastewater from the full-scale treatment plant. Similar removal trends in the PAC and GAC experiments were observed when studying a weighted average micropollutant removal in the GAC filter and a similar dose of activated carbon for both PAC and GAC. Positively charged micropollutants were removed to a higher extent than negatively charged ones by both PAC and GAC.

Chemically enhanced primary treatment, microsieving, direct membrane filtration and GAC filtration of municipal wastewater: a pilot-scale study.

Chemically enhanced primary treatment (CEPT) followed by microsieving and direct membrane filtration (DMF) as ultrafiltration, was evaluated on pilot scale at a municipal wastewater treatment plant. In addition, a granular activated carbon (GAC) filter downstream of DMF was evaluated for the removal of organic micropollutants. Up to 80% of the total organic carbon (TOC) and 96% of the total phosphorus were removed by CEPT with microsieving. The additional contribution of subsequent DMF was minor, and only five days of downstream GAC filtration was possible due to fouling of the membrane. Of the 21 organic micropollutants analysed, all were removed (≥ 98%) by the GAC filter until 440 bed volumes, while CEPT with microsieving and DMF removed only a few compounds. Measurements of the oxygen uptake rate indicated that the required aeration for supplementary biological treatment downstream of CEPT with microsieving, both with and without subsequent DMF, was 20-25% of that in the influent wastewater. This study demonstrated the potential of using compact physicochemical processes to treat municipal wastewater, including the removal of organic micropollutants.

Recent developments in biohythane production from household food wastes: A review.

Biohythane is a hydrogen-methane blend with hydrogen concentration between 10 and 30% v/v. It can be produced from different organic substrates by two sequential anaerobic stages: a dark fermentation step followed by a second an anaerobic digestion step, for hydrogen and methane production, respectively. The advantages of this blend compared to either hydrogen or methane, as separate biofuels, are first presented in this work. The two-stage anaerobic process and the main operative parameters are then discussed. Attention is focused on the production of biohythane from household food wastes, one of the most abundant organic substrate available for anaerobic digestion: the main milestones and the future trends are exposed. In particular, the possibility to co-digest food wastes and sewage sludge to improve the process yield is discussed. Finally, the paper illustrates the developments of biohythane application in the automotive sector as well as its reduced environmental burden.

Mesophilic and thermophilic anaerobic digestion of the liquid fraction of pressed biowaste for high energy yields recovery.

Deep separate collection of the organic fraction of municipal solid waste generates streams with relatively low content of inert material and high biodegradability. This material can be conveniently treated to recovery both energy and material by means of simplified technologies like screw-press and extruder: in this study, the liquid fraction generated from pressed biowaste from kerbside and door-to-door collection was anaerobically digested in both mesophilic and thermophilic conditions while for the solid fraction composting is suggested. Continuous operation results obtained both in mesophilic and thermophilic conditions indicated that the anaerobic digestion of pressed biowaste was viable at all operating conditions tested, with the greatest specific gas production of 0.92m(3)/kgVSfed at an organic loading rate of 4.7kgVS/m(3)d in thermophilic conditions. Based on calculations the authors found that the expected energy recovery is highly positive. The contents of heavy metals and pathogens of fed substrate and effluent digestates were analyzed, and results showed low levels (below End-of-Waste 2014 criteria limits) for both the parameters thus indicating the good quality of digestate and its possible use for agronomic purposes. Therefore, both energy and material were effectively recovered.