An optical-frequency synthesizer using integrated photonics.

Optical-frequency synthesizers, which generate frequency-stable light from a single microwave-frequency reference, are revolutionizing ultrafast science and metrology, but their size, power requirement and cost need to be reduced if they are to be more widely used. Integrated-photonics microchips can be used in high-coherence applications, such as data transmission 1 , highly optimized physical sensors 2 and harnessing quantum states 3 , to lower cost and increase efficiency and portability. Here we describe a method for synthesizing the absolute frequency of a lightwave signal, using integrated photonics to create a phase-coherent microwave-to-optical link. We use a heterogeneously integrated III-V/silicon tunable laser, which is guided by nonlinear frequency combs fabricated on separate silicon chips and pumped by off-chip lasers. The laser frequency output of our optical-frequency synthesizer can be programmed by a microwave clock across 4 terahertz near 1,550 nanometres (the telecommunications C-band) with 1 hertz resolution. Our measurements verify that the output of the synthesizer is exceptionally stable across this region (synthesis error of 7.7 × 10-15 or below). Any application of an optical-frequency source could benefit from the high-precision optical synthesis presented here. Leveraging high-volume semiconductor processing built around advanced materials could allow such low-cost, low-power and compact integrated-photonics devices to be widely used.

Supercontinuum generation in an on-chip silica waveguide.

Supercontinuum generation is demonstrated in an on-chip silica spiral waveguide by launching 180 fs pulses from an optical parametric oscillator at the center wavelength of 1330 nm. With a coupled pulse energy of 2.17 nJ, the broadest spectrum in the fundamental TM mode extends from 936 to 1888 nm (162 THz) at -50 dB from peak. There is a good agreement between the measured spectrum and a simulation using a generalized nonlinear Schrödinger equation.

Self-aligned active quantum nanostructures in photonic crystals via selective wet-chemical etching.

We propose a method of forming quantum-size emitters within a pre-defined photonic crystal in a self-aligned fashion through controlled removal of quantum well layers via selective wet-chemical etching. To demonstrate the effectiveness of our method, we take the example of a two-dimensional photonic crystal slab containing multiple quantum wells at its center. We successfully fabricate vertically stacked quantum nanostructures (or quantum dots) well aligned with respect to the photonic crystal backbone. Micro-photoluminescence measurements performed at 78 K reveal that the radiative transition energy blue-shifts when the lateral dimension reaches less than 100 nm, which is compared with a simple model based on the 'particle-in-a-box' picture. The proposed method may find a broad range of applications in photonics and quantum optics, where the coupling between an emitter and an optical mode needs to be maximized.

Dirac solitons in optical microresonators.

Mode-coupling-induced dispersion has been used to engineer microresonators for soliton generation at the edge of the visible band. Here, we show that the optical soliton formed in this way is analogous to optical Bragg solitons and, more generally, to the Dirac soliton in quantum field theory. This optical Dirac soliton is studied theoretically, and a closed-form solution is derived in the corresponding conservative system. Both analytical and numerical solutions show unusual properties, such as polarization twisting and asymmetrical optical spectra. The closed-form solution is also used to study the repetition rate shift in the soliton. An observation of the asymmetrical spectrum is analysed using theory. The properties of Dirac optical solitons in microresonators are important at a fundamental level and provide a road map for soliton microcomb generation in the visible band.

Microspinning: Local Surface Mixing via Rotation of Magnetic Microparticles for Efficient Small-Volume Bioassays.

The need for high-throughput screening has led to the miniaturization of the reaction volume of the chamber in bioassays. As the reactor gets smaller, surface tension dominates the gravitational or inertial force, and mixing efficiency decreases in small-scale reactions. Because passive mixing by simple diffusion in tens of microliter-scale volumes takes a long time, active mixing is needed. Here, we report an efficient micromixing method using magnetically rotating microparticles with patterned magnetization induced by magnetic nanoparticle chains. Because the microparticles have magnetization patterning due to fabrication with magnetic nanoparticle chains, the microparticles can rotate along the external rotating magnetic field, causing micromixing. We validated the reaction efficiency by comparing this micromixing method with other mixing methods such as simple diffusion and the use of a rocking shaker at various working volumes. This method has the potential to be widely utilized in suspension assay technology as an efficient mixing strategy.

One-Step Generation of a Drug-Releasing Hydrogel Microarray-On-A-Chip for Large-Scale Sequential Drug Combination Screening.

Large-scale screening of sequential drug combinations, wherein the dynamic rewiring of intracellular pathways leads to promising therapeutic effects and improvements in quality of life, is essential for personalized medicine to ensure realistic cost and time requirements and less sample consumption. However, the large-scale screening requires expensive and complicated liquid handling systems for automation and therefore lowers the accessibility to clinicians or biologists, limiting the full potential of sequential drug combinations in clinical applications and academic investigations. Here, a miniaturized platform for high-throughput combinatorial drug screening that is "pipetting-free" and scalable for the screening of sequential drug combinations is presented. The platform uses parallel and bottom-up formation of a heterogeneous drug-releasing hydrogel microarray by self-assembly of drug-laden hydrogel microparticles. This approach eliminates the need for liquid handling systems and time-consuming operation in high-throughput large-scale screening. In addition, the serial replacement of the drug-releasing microarray-on-a-chip facilitates different drug exchange in each and every microwell in a simple and highly parallel manner, supporting scalable implementation of multistep combinatorial screening. The proposed strategy can be applied to various forms of combinatorial drug screening with limited amounts of samples and resources, which will broaden the use of the large-scale screening for precision medicine.

ELIPatch, a thumbnail-size patch with immunospot array for multiplexed protein detection from human skin surface.

Proteins secreted by skin have great potential as biomarkers for interpreting skin conditions. However, inconvenience in handling and bulky size of existing methods are existing limitations. Here, we describe a thumb-nail sized patch with the array of microdisks which captures multiple proteins from the skin surface. Microdisks with antibody on the surface enable multiplexed immunoassay. By self-assembly, microdisks are placed into 2-dimensional arrays on adhesive tape. The proposed Enzyme-Linked Immunospot array on a Patch shows sufficient sensitivity for IL-1α, IL1RA, IL-17A, IFN-g, and TNF-α, while IL-6 and IL-1ß are non-detectable in some cases. As demonstrations, we quantified cytokines from different skin regions and volunteers in a high-spatial-resolution.

Hierarchical shape-by-shape assembly of microparticles for micrometer-scale viral delivery of two different genes.

Understanding tissue engineering using a bottom-up approach has been hindered by technical limitations because no platform can demonstrate the controlled formation of a heterogeneous population of cells in microscale. Here, we demonstrate hierarchical shape-by-shape assembly of virus-laden particles into larger ones to transfect two different genes on the seeded cells. We show that smaller daughter particles with different sizes and shapes can be assembled into the matching indentations of larger parent particles with different sizes and shapes. Then, we transfected a population of cells with two different gene-transfecting viruses, each of which was laden on the parent or daughter particles.

Liquid-capped encoded microcapsules for multiplex assays.

Although droplet microfludics is a promising technology for handling a number of liquids of a single type of analyte, it has limitations in handling thousands of different types of analytes for multiplex assay. Here, we present a novel "liquid-capped encoded microcapsule", which is applicable to various liquid format assays. Various liquid drops can be graphically encoded and arrayed without repeated dispensing processes, evaporation, and the risk of cross-contamination. Millions of nanoliter-scale liquids are encapsulated within encoded microcapsules and self-assembled in microwells in a single dispensing process. The graphical code on the microcapsule enables identification of randomly assembled microcapsules in each microwell. We conducted various liquid phase assays including enzyme inhibitor screening, virus transduction, and drug-induced apoptosis tests. The results showed that our liquid handling technology can be utilized widely for various solution phase assays.

Correction: Liquid-capped encoded microcapsules for multiplex assays.

Correction for 'Liquid-capped encoded microcapsules for multiplex assays' by Younghoon Song et al., Lab Chip, 2017, DOI: .

Towards visible soliton microcomb generation.

Frequency combs have applications that extend from the ultra-violet into the mid-infrared bands. Microcombs, a miniature and often semiconductor-chip-based device, can potentially access most of these applications, but are currently more limited in spectral reach. Here, we demonstrate mode-locked silica microcombs with emission near the edge of the visible spectrum. By using both geometrical and mode-hybridization dispersion control, devices are engineered for soliton generation while also maintaining optical Q factors as high as 80 million. Electronics-bandwidth-compatible (20 GHz) soliton mode locking is achieved with low pumping powers (parametric oscillation threshold powers as low as 5.4 mW). These are the shortest wavelength soliton microcombs demonstrated to date and could be used in miniature optical clocks. The results should also extend to visible and potentially ultra-violet bands.