Strategy and Technical Progress of Recycling of Spent Vanadium-Titanium-Based Selective Catalytic Reduction Catalysts.

Selective catalytic reduction denitration technology, abbreviated as SCR, is essential for the removal of nitrogen oxide from the flue gas of coal-fired power stations and has been widely used. Due to the strong demand for energy and the requirements for environmental protection, a large amount of SCR catalyst waste is produced. The spent SCR catalyst contains high-grade valuable metals, and proper disposal or treatment of the SCR catalyst can protect the environment and realize resource recycling. This review focuses on the two main routes of regeneration and recycling of spent vanadium-titanium SCR catalysts that are currently most widely commercially used and summarizes in detail the technologies of recycling, high-efficiency recycling, and recycling of valuable components of spent vanadium-titanium SCR catalysts. This review also discusses in depth the future development direction of recycling spent vanadium-titanium SCR catalysts. It provides a reference for promoting recycling, which is crucial for resource recovery and green and low-carbon development.

A combined and sustainable approach and a novel mechanism for recovering Bi, Au and Ag from high-chloride leachate of waste printed circuit board smelting ash.

High-chloride leachate is a solution rich in precious metals that is produced in chloride hydrometallurgy. It has high levels of both rare and precious metals and hazardous chloride ions, and resource recovery from this solution and its safe disposal have become key objectives in the field of hydrometallurgy. In this study, a sustainable process involving "ultrasound-assisted precipitation-Pb powder cementation" was proposed for the stepwise separation and high-value utilization of Bi, Au and Ag obtained from high-chloride leachate. Targeted separation and conversion of Bi were achieved by precipitation-re-acid hydrolysis-ultrasonication-assisted coprecipitation-centrifugal purification. Under the optimal process conditions, the removal rate of Bi reached 99.52%, while the loss rates of Au and Ag were only 4.63% and 8.72%, respectively. Single-factor experiments of Au and Ag cementation by Pb powder showed that the recovery rates of precious metals could be improved by increasing the temperature, raising the solution pH, and applying mechanical force and ultrasonication. A possible reaction mechanism for Au and Ag cementation with Pb powder was proposed based on macroscopic kinetic analysis and microscopic mineral characterization. This work provides technical support and a theoretical basis for the separation and enrichment of rare and precious metals in chloride hydrometallurgy.

Study on controllable preparation of high performance andradite based glass-ceramics by harmful iron-rich waste slag.

Due to containing abundant FeOx and trace heavy metals (Pb, As, Cr, Cd, etc.), the disposal of lead/zinc smelting slag (LSS-ZSS) with ultra-high historical reserves has attracted increased attention. Using LSS-ZSS to prepare glass-ceramics is a good method to solve the problem of LSS-ZSS accumulation and realize heavy metal solidification, whereas there are some technical challenges that are difficult to deal with. A large amount of FeOx component in LSS-ZSS would not only lead to melt overflow, but also cause early crystallization of basic glass. In this work, through the directional modification of LSS-ZSS and the subsequent crystallization kinetics regulation, we successfully prepare high performance glass-ceramics with andradite and hematite as the main crystal phases. In addition, by means of SEM, PXRD, FTIR spectra and XPS, the morphology/phase transformation, fine structure and valence variations of iron components in LSS-ZSS at different temperature zones are systematically studied. The maximum shrinkage rate of resultant basic glasses is 27 %, and the maximum flexural strength and compressive strength of glass-ceramics are 128 MPa and 890 MPa, respectively. This work would not only benefit to solve the problem of resource utilization of harmful LSS-ZSS, but also provide a possible reference for the utilization of iron-rich waste slag in magnetic properties related fields.

KRAS inhibition activates an actionable CD24 'don't eat me' signal in pancreas cancer.

KRAS G12C inhibitor (G12Ci) has produced encouraging, albeit modest and transient, clinical benefit in pancreatic ductal adenocarcinoma (PDAC). Identifying and targeting resistance mechanisms to G12Ci treatment is therefore crucial. To better understand the tumor biology of the KRAS G12C allele and possible bypass mechanisms, we developed a novel autochthonous KRAS G12C -driven PDAC model. Compared to the classical KRAS G12D PDAC model, the G12C model exhibit slower tumor growth, yet similar histopathological and molecular features. Aligned with clinical experience, G12Ci treatment of KRAS G12C tumors produced modest impact despite stimulating a 'hot' tumor immune microenvironment. Immunoprofiling revealed that CD24, a 'do-not-eat-me' signal, is significantly upregulated on cancer cells upon G12Ci treatment. Blocking CD24 enhanced macrophage phagocytosis of cancer cells and significantly sensitized tumors to G12Ci treatment. Similar findings were observed in KRAS G12D -driven PDAC. Our study reveals common and distinct oncogenic KRAS allele-specific biology and identifies a clinically actionable adaptive mechanism that may improve the efficacy of oncogenic KRAS inhibitor therapy in PDAC. Significance: Lack of faithful preclinical models limits the exploration of resistance mechanisms to KRAS G12C inhibitor in PDAC. We generated an autochthonous KRAS G12C -driven PDAC model, which revealed allele-specific biology of the KRAS G12C during PDAC development. We identified CD24 as an actionable adaptive mechanisms in cancer cells induced upon KRAS G12C inhibition and blocking CD24 sensitizes PDAC to KRAS inhibitors in preclinical models.

A new mechanism and kinetic analysis for the efficient conversion of inorganic bromide in waste printed circuit board smelting ash via traditional sulfated roasting.

The waste printed circuit board smelting ash (WPCB-SA) produced in the waste printed circuit board smelting process is a hazardous material that not only contains valuable metals, but also contains a large amount of toxic and harmful inorganic bromides. The utilization of metals has received considerable attention in previous studies, but the recovery of hazardous bromides requires further study. In this article, a new idea of converting inorganic bromine in WPCB-SA by traditional sulfated roasting is proposed. Debromination kinetics under simulated experimental conditions are discussed, and kinetic equations are established. The kinetic results show that during low-temperature sulfated roasting, the conversion of Br in CuBr and PbBr2 conforms to the chemical reaction diffusion model and diffusion control the product layer model, respectively. A possible reaction mechanism is also proposed. Our research shows that the conversion of Br in CuBr is divided into three processes: covalent bond decomposition, hydrogen ion form acid, copper ion form salt, and HBr oxidation conversion, whereas the conversion of Br in PbBr2 is divided into two processes: sulfuric acid ionization, lead ion form salt and HBr oxidation conversion. This work provides the theoretical basis for the improvement and application of inorganic bromide recovery technology in WPCB-SA.

An integrated and sustainable hydrometallurgical process for enrichment of precious metals and selective separation of copper, zinc, and lead from a roasted sand.

This study developed an efficient and sustainable hydrometallurgical process for the enrichment of gold and silver and the stepwise separation of copper, zinc, and lead from sulfated roasted sand of waste printed circuit board smelting ash. Selective separation of copper and zinc was achieved by water leaching, and silver dispersion was reduced by controlling the amount of NaCl added during the leaching process. The results of the water leaching showed that the copper and zinc leaching rates were 99.85% and 99.47%, respectively, whereas the loss rate of silver was 2.1% with optimal leaching parameters. The high-chloride-complex method was used to study the efficient conversion and separation of lead from the leached residue, and the leaching kinetics and conversion mechanism of lead were discussed. The results showed that under the optimal conditions, the leaching rate of lead was 99.79%. Leaching kinetics analysis showed that lead leaching in the high - chlorine system was controlled by a chemical reaction; the apparent activation energy was 53.63 kJ/mol. After the leaching of copper, zinc, and lead, 1.66% Ag and 213 g/t Au were enriched in the leached residue; and the precious metal enrichment goal was reached. The chlorinated leachate showed good recycling performance, and a lead leaching rate of 97.93% was obtained after three circulations. After cooling, crystallization, and purification, lead chloride with a purity of 99.89% and high economic and industrial value was obtained from the lead-rich leachate. This process has favorable and sustainable industrial application prospects.

Single Tungsten Atom-Modified Cotton Fabrics for Visible-Light-Driven Photocatalytic Degradation and Antibacterial Activity.

Various single-atom materials exhibit distinguished performances in catalysis and biology. To boost their applications, single-atom-based strategies are highly demanded to exhibit repeatable functions on advanced wearable substrates. However, single-atom approaches are rarely reported to anchor on wearable materials, i.e., widely applied cotton fabrics. Here, we developed a simple method of loading uniformly dispersed single tungsten atoms on cotton via ordinary direct-dye processing to exhibit superior sustainable functions. The single sites of tungsten atom centers are constructed by binding oxygen-coordinated single tungsten atom on the cotton fabric surface via -COOH groups. Consequently, the band gap of single sites decreases significantly to 2.75 from 3.03 eV. Therefore, the single-site-modified cotton exhibits excellent visible-light-driven (>420 nm) photocatalytic degradation efficiency of organic dyes, which exceeds other reported cotton-based materials by nearly two orders of magnitude. Furthermore, the single-site-modified cotton also exhibits great antibacterial performance due to reactive oxygen species. Moreover, the cotton with anchored single sites possesses great washing-resistance ability during 20 laundry cycles under soap-washing conditions. After recycling, the single sites on cotton have no obvious changes in the microstructure, which demonstrates the success of our sustainable strategy of single sites anchored on cotton. The single-site technique can be extended to many other elemental atoms on various wearable devices, providing a playground for functional material communities.

Author Correction: CDK2-mediated site-specific phosphorylation of EZH2 drives and maintains triple-negative breast cancer.

An amendment to this paper has been published and can be accessed via a link at the top of the paper.

CDK2-mediated site-specific phosphorylation of EZH2 drives and maintains triple-negative breast cancer.

Triple-negative breast cancer (TNBC), which lacks estrogen receptor α (ERα), progesterone receptor, and human epidermal growth factor receptor 2 (HER2) expression, is closely related to basal-like breast cancer. Previously, we and others report that cyclin E/cyclin-dependent kinase 2 (CDK2) phosphorylates enhancer of zeste homolog 2 (EZH2) at T416 (pT416-EZH2). Here, we show that transgenic expression of phospho-mimicking EZH2 mutant EZH2T416D in mammary glands leads to tumors with TNBC phenotype. Coexpression of EZH2T416D in mammary epithelia of HER2/Neu transgenic mice reprograms HER2-driven luminal tumors into basal-like tumors. Pharmacological inhibition of CDK2 or EZH2 allows re-expression of ERα and converts TNBC to luminal ERα-positive, rendering TNBC cells targetable by tamoxifen. Furthermore, the combination of either CDK2 or EZH2 inhibitor with tamoxifen effectively suppresses tumor growth and markedly improves the survival of the mice bearing TNBC tumors, suggesting that the mechanism-based combination therapy may be an alternative approach to treat TNBC.

Challenges in legislation, recycling system and technical system of waste electrical and electronic equipment in China.

Waste electrical and electronic equipment (WEEE) has been one of the fastest growing waste streams worldwide. Effective and efficient management and treatment of WEEE has become a global problem. As one of the world's largest electronic products manufacturing and consumption countries, China plays a key role in the material life cycle of electrical and electronic equipment. Over the past 20 years, China has made a great effort to improve WEEE recycling. Centered on the legal, recycling and technical systems, this paper reviews the progresses of WEEE recycling in China. An integrated recycling system is proposed to realize WEEE high recycling rate for future WEEE recycling.

Rare earth elements recycling from waste phosphor by dual hydrochloric acid dissolution.

This paper is a comparative study of recycling rare earth elements from waste phosphor, which focuses on the leaching rate and the technical principle. The traditional and dual dissolution by hydrochloric acid (DHA) methods were compared. The method of dual dissolution by hydrochloric acid has been developed. The Red rare earth phosphor (Y0.95Eu0.05)2O3 in waste phosphor is dissolved during the first step of acid leaching, while the Green phosphor (Ce0.67Tb0.33MgAl11O19) and the Blue phosphor (Ba0.9Eu0.1MgAl10O17) mixed with caustic soda are obtained by alkali sintering. The excess caustic soda and NaAlO2 are removed by washing. The insoluble matter is leached by the hydrochloric acid, followed by solvent extraction and precipitation (the DHA method). In comparison, the total leaching rate of the rare earth elements was 94.6% by DHA, which is much higher than 42.08% achieved by the traditional method. The leaching rate of Y, Eu, Ce and Tb reached 94.6%, 99.05%, 71.45%, and 76.22%, respectively. DHA can decrease the consumption of chemicals and energy. The suggested DHA method is feasible for industrial applications.

WITHDRAWN: A critical review of recycling rare-earths from waste phosphor.

This article has been withdrawn at the request of the author(s) and/or editor. The Publisher apologizes for any inconvenience this may cause. The full Elsevier Policy on Article Withdrawal can be found at http://www.elsevier.com/locate/withdrawalpolicy.