Comparison of Detection Limits of Fourth- and Fifth-Generation Combination HIV Antigen-Antibody, p24 Antigen, and Viral Load Assays on Diverse HIV Isolates.

Detection of acute HIV infection is critical for HIV public health and diagnostics. Clinical fourth-generation antigen (Ag)/antibody (Ab) combination (combo) and p24 Ag immunoassays have enhanced detection of acute infection compared to Ab-alone assays but require ongoing evaluation with currently circulating diverse subtypes. Genetically and geographically diverse HIV clinical isolates were used to assess clinical HIV diagnostic, blood screening, and next-generation assays. Three-hundred-member panels of 20 serially diluted well-characterized antibody-negative HIV isolates for which the researchers were blind to the results (blind panels) were distributed to manufacturers and end-user labs to assess the relative analytic sensitivity of currently approved and preapproved clinical HIV fourth-generation Ag/Ab combo or p24 Ag-alone immunoassays for the detection of diverse subtypes. The limits of detection (LODs) of virus were estimated for different subtypes relative to confirmed viral loads. Analysis of immunoassay sensitivity was benchmarked against confirmed viral load measurements on the blind panel. On the basis of the proportion of positive results on 300 observations, all Ag/Ab combo and standard sensitivity p24 Ag assays performed similarly and within half-log LODs, illustrating the similar breadth of reactivity and diagnostic utility. Ultrasensitive p24 Ag assays achieved dramatically increased sensitivities, while the rapid combo assays performed poorly. The similar performance of the different commercially available fourth-generation assays on diverse subtypes supports their use in broad geographic settings with locally circulating HIV clades and recombinant strains. Next-generation preclinical ultrasensitive p24 Ag assays achieved dramatically improved sensitivity, while rapid fourth-generation assays performed poorly for p24 Ag detection.

Clinical performance of the Multispot HIV-1/HIV-2 rapid test to correctly differentiate HIV-2 from HIV-1 infection in screening algorithms using third and fourth generation assays and to identify cross reactivity with the HIV-1 Western Blot.

BACKGROUND: An accurate and rapid serologic method to differentiate HIV-2 from HIV-1 infection is required since the confirmatory HIV-1 Western Blot (WB) may demonstrate cross-reactivity with HIV-2 antibodies. OBJECTIVES: To evaluate the performance of the Bio-Rad Multispot HIV-1/HIV-2 rapid assay as a supplemental test to correctly identify HIV-2 infection and identify HIV-1 WB cross-reactivity with HIV-2 in clinical samples tested at an academic medical center. STUDY DESIGN: Between August 2008 and July 2012, clinical samples were screened for HIV using either 3rd- or 4th-generation HIV-1/2 antibody or combination antibody and HIV-1 p24 antigen assays, respectively. All repeatedly reactive samples were reflexed for Multispot rapid testing. Multispot HIV-2 and HIV-1 and HIV-2-reactive samples were further tested using an HIV-2 immunoblot assay and HIV-1 or HIV-2 RNA assays when possible. The HIV-1 WB was performed routinely for additional confirmation and to assess for HIV-2 antibody cross-reactivity. RESULTS: Of 46,061 samples screened, 890 (89.6%) of 993 repeatedly reactive samples were also Multispot-reactive: 882 for HIV-1; three for only HIV-2; and five for both HIV-1 and HIV-2. All three HIV-2-only Multispot-positives along with a single dually reactive HIV-1/2 Multispot-positive were also HIV-2 immunoblot-positive; the latter was HIV-1 RNA negative and HIV-2 RNA positive. CONCLUSIONS: The Multispot rapid test performed well as a supplemental test for HIV-1/2 diagnostic testing. Four new HIV-2 infections (0.45%) were identified from among 890 Multispot-reactive tests. The use of HIV-1 WB alone to confirm HIV-1/2 screening assays may underestimate the true prevalence of HIV-2 infection in the United States.

Performance of an alternative HIV diagnostic algorithm using the ARCHITECT HIV Ag/Ab Combo assay and potential utility of sample-to-cutoff ratio to discriminate primary from established infection.

BACKGROUND: The ARCHITECT HIV Ag/Ab Combo assay has a wide dynamic range for determining the sample-to-cutoff ratio (S/CO) values compared to other diagnostic HIV antibody assays. OBJECTIVES: Determine the performance of an HIV testing algorithm that uses the ARCHITECT combo assay in the clinical setting and explore the utility of the signal-to-cutoff (S/CO) ratio to predict acute HIV-1 infection status. STUDY DESIGN: A retrospective analysis of clinical samples from a hospital and referral population screened for HIV-1 infection between May 2011 and March 2013. Repeatedly reactive samples were tested using the Multispot HIV-1/HIV-2 rapid test and depending on that result, confirmatory orthogonal testing used the Western blot (WB) for HIV-1, Immunoblot for HIV-2 and nucleic acid amplification testing (NAAT) for HIV RNA. RESULTS: A total of 21,317 test results were evaluated of which 509 were ARCHITECT repeatedly reactive; of these, 422 were Multispot-reactive only for HIV-1 (413 WB-positive; 9 indeterminate), 4 were Multispot-reactive for both HIV-1 and HIV-2 (one HIV-2 immunoblot-positive with 17 HIV-2 RNA copies/mL) and 83 were Multispot-non-reactive of which 15 were HIV-1 RNA positive and represented acute HIV-1 infection. There was an association among the ARCHITECT S/CO (median; IQR) values for antibody-negative (0.14; 0.11-0.16), acute infection (33; 2.1-76) and established HIV-1 infection (794; 494-1,029) (Kruskal-Wallis, p<0.0001). CONCLUSIONS: The ARCHITECT combo assay with Multispot confirmation and reserved use of HIV-1 WB, HIV-2 Immunoblot and HIV NAAT for Multispot dual HIV-1/2 infection, and NAAT alone for Multispot-negative specimens, had a suitable test performance for detecting acute and established HIV infection.