RESUMO
Pseudo-halide (PH) anion engineering has emerged as a surface passivation strategy of interest for perovskite-based optoelectronics; but until now, PH anions have led to insufficient defect passivation and thus to undesired deep impurity states. The size of the chemical space of PH anions (>106 molecules) has so far limited attempts to explore the full family of candidate molecules. We created a machine learning workflow to speed up the discovery process using full-density functional theory calculations for training the model. The physics-informed machine learning model allowed us to pinpoint promising molecules with a head group that prevents lattice distortion and anti-site defect formation, and a tail group optimized for strong attachment to the surface. We identified 15 potential bifunctional PH anions with the ability to passivate both donors and acceptors, and through experimentation, discovered that sodium thioglycolate was the most effective passivant. This strategy resulted in a power-conversion efficiency of 24.56% with a high open-circuit voltage of 1.19 volts (24.04% National Renewable Energy Lab-certified quasi-steady-state) in inverted perovskite solar cells. Encapsulated devices maintained 96% of their initial power-conversion energy during 900 hours of one-sun operation at the maximum power point.
RESUMO
Liquids confined down to the atomic scale can show radically new properties. However, only indirect and ensemble measurements operate in such extreme confinement, calling for novel optical approaches that enable direct imaging at the molecular level. Here we harness fluorescence originating from single-photon emitters at the surface of hexagonal boron nitride for molecular imaging and sensing in nanometrically confined liquids. The emission originates from the chemisorption of organic solvent molecules onto native surface defects, revealing single-molecule dynamics at the interface through the spatially correlated activation of neighbouring defects. Emitter spectra further offer a direct readout of the local dielectric properties, unveiling increasing dielectric order under nanometre-scale confinement. Liquid-activated native hexagonal boron nitride defects bridge the gap between solid-state nanophotonics and nanofluidics, opening new avenues for nanoscale sensing and optofluidics.
RESUMO
Heavy-metal-free III-V colloidal quantum dots (CQDs) are promising materials for solution-processed short-wave infrared (SWIR) photodetectors. Recent progress in the synthesis of indium antimonide (InSb) CQDs with sizes smaller than the Bohr exciton radius enables quantum-size effect tuning of the band gap. However, it has been challenging to achieve uniform InSb CQDs with band gaps below 0.9â eV, as well as to control the surface chemistry of these large-diameter CQDs. This has, to date, limited the development of InSb CQD photodetectors that are sensitive to ≥ ${\ge }$ 1400â nm light. Here we adopt solvent engineering to facilitate a diffusion-limited growth regime, leading to uniform CQDs with a band gap of 0.89â eV. We then develop a CQD surface reconstruction strategy that employs a dicarboxylic acid to selectively remove the native In/Sb oxides, and enables a carboxylate-halide co-passivation with the subsequent halide ligand exchange. We find that this strategy reduces trap density by half compared to controls, and enables electronic coupling among CQDs. Photodetectors made using the tailored CQDs achieve an external quantum efficiency of 25 % at 1400â nm, the highest among III-V CQD photodetectors in this spectral region.
RESUMO
Nonlinear optical methods, such as vibrational sum frequency generation (vSFG) and second harmonic generation (SHG), are powerful techniques to study elusive structures at charged buried interfaces. However, for the separation and determination of the Stern and diffuse layer spectra at these charged interfaces, complex vSFG spectra and, hence, the absolute phase need to be retrieved. The maximum entropy method is a useful tool for the retrieval of complex spectra from the intensity spectra; however, one caveat is that an understanding of the error phase is required. Here, for the first time, we provide a physically motivated understanding of the error phase. Determining the error phase from simulated spectra of oscillators with a spectral overlap, we show that for broadband vSFG spectra, such as for the silica/water interface, the diffuse and Stern layers' spectral overlap within the O-H stretching window results in a correlation between the error phase and the phase shift between the responses of these layers. This correlation makes the error phase sensitive to changes in Debye length from varying the ionic strength among other variations at the interface. Furthermore, the change in the magnitude of the error phase can be related to the absolute SHG phase, permitting the use of an error phase model that can utilize the SHG phase to predict the error phase and, hence, the complex vSFG spectra. Finally, we highlight limitations of this model for vSFG spectra with a poor overlap between the diffuse and Stern layer spectra (silica/HOD in D2O system).
RESUMO
The electric double layer governs the processes of all charged surfaces in aqueous solutions; however, elucidating the structure of the water molecules is challenging for even the most advanced spectroscopic techniques. Here, we present the individual Stern layer and diffuse layer OH stretching spectra at the silica/water interface in the presence of NaCl over a wide pH range using a combination of vibrational sum frequency generation spectroscopy, heterodyned second harmonic generation, and streaming potential measurements. We find that the Stern layer water molecules and diffuse layer water molecules respond differently to pH changes: unlike the diffuse layer, whose water molecules remain net-oriented in one direction, water molecules in the Stern layer flip their net orientation as the solution pH is reduced from basic to acidic. We obtain an experimental estimate of the non-Gouy-Chapman (Stern) potential contribution to the total potential drop across the insulator/electrolyte interface and discuss it in the context of dipolar, quadrupolar, and higher order potential contributions that vary with the observed changes in the net orientation of water in the Stern layer. Our findings show that a purely Gouy-Chapman (Stern) view is insufficient to accurately describe the electrical double layer of aqueous interfaces.
Assuntos
Eletrólitos , Água , Eletricidade , Eletrólitos/química , Dióxido de Silício , Propriedades de Superfície , Água/químicaRESUMO
Treating the oil sands tailings ponds is a major challenge because of the vast amounts of tailings and the need for a reliable treatment technique for releasing water and generating the highly consolidated material required for land reclamation. Treatment with chemicals such as lime (calcium (hydr)oxide) is a promising technology for tailings dewatering and consolidation, particularly at higher pH. Given that kaolinite and silica minerals are the main constituents of many oil sands, we have investigated the influence of lime and NaOH addition on the silica/aqueous kaolinite interface over the pH range 7.4-12.4 using vibrational sum frequency generation spectroscopy (SFG). With lime addition, at pH 12.0 and above we observe a complete disappearance of the vibrational features of the interfacial water molecules for planar silica in contact with an aqueous dispersion of kaolinite particles. A concurrent increase in the amount of adsorbed kaolinite on the silica surface at pH 12.0 and above is observed, shown in the increased intensity of the kaolinite SFG peak at 3694 cm-1. This suggests that the absence of water features in the SFG spectra is associated with conditions that facilitate dewatering. With NaOH addition, however, the interfacial water SF intensity is still significant even under highly alkaline conditions despite the increase in adsorbed kaolinite at high pH. To better understand the SFG observations and get a deeper insight into the chemistry of the silica/aqueous kaolinite interface, we measure the ζ-potential on the planar silica/aqueous interface and kaolinite aqueous dispersions under the same pH conditions with NaOH and lime addition.
RESUMO
The acetonitrile-water mixture is one of the most commonly used solvents in hydrophilic interaction chromatography, which contains silica as the solid phase. As such, the silica/acetonitrile-water interface plays a large role in the separation of compounds. Varying the pH is one way to influence retention times, particularly of ionizable solutes, yet the influence of high pH is often unpredictable. To determine how the structure of this interface changes with pH, we utilized the surface specific technique sum frequency generation (SFG). Previous SFG studies at neutral pH have suggested the existence of acetonitrile bilayers at the aqueous silica interface even at low acetonitrile mole fractions. Here we find that the SFG signal from 2900 to 3040 cm-1 at the silica/acetonitrile-water interface increased as we adjusted the aqueous pH from near neutral to high values. This increase in signal was attributed to a greater amount of aligned water which is consistent with an increase in silica surface charge at high pH. In contrast, complementary measurements of the silica/acetonitrile-deuterium oxide interface revealed that the acetonitrile methyl mode nearly vanished as the aqueous pH was increased. This loss of methyl mode signal is indicative of a decrease in the number density of acetonitrile molecules at the interface, as orientation analysis indicates no significant change in the net orientation of the outer leaflet of the acetonitrile bilayer over the pH range studied.
RESUMO
Colloidal quantum dot (CQD) photodetectors (PDs) can detect wavelengths longer than the 1100 nm limit of silicon because of their highly tunable bandgaps. CQD PDs are acutely affected by the ligands that separate adjacent dots in a CQD-solid. Optimizing the exchange solution ligand concentration in the processing steps is crucial to achieving high photodetector performance. However, the complex mix of chemistry and optoelectronics involved in CQD PDs means that the effects of the exchange solution ligand concentration on device physics are poorly understood. Here we report direct correspondence between simulated and experimental transient photocurrent responses in CQD PDs. For both deficient and excess conditions, our model demonstrated the experimental changes to the transient photocurrent aligned with changes in trap state density. Combining transient photoluminescence, absorption, and photocurrent with this simulation model, we revealed that different mechanisms are responsible for the increased trap density induced by excess and deficient active layer ligand concentrations.
RESUMO
In the III-V family of colloidal quantum dot (CQD) semiconductors, InSb promises access to a wider range of infrared wavelengths compared to many light-sensing material candidates. However, achieving the necessary size, size-dispersity, and optical properties has been challenging. Here the synthetic challenges associated with InSb CQDs are investigated and it is found that uncontrolled reduction of the antimony precursor hampers the controlled growth of CQDs. To overcome this, a synthetic strategy that combines nonpyrophoric precursors with zinc halide additives is developed. The experimental and computational studies show that zinc halide additives decelerate the reduction of the antimony precursor, facilitating the growth of more uniformly sized CQDs. It is also found that the halide choice provides additional control over the strength of this effect. The resultant CQDs exhibit well-defined excitonic transitions in spectral range of 1.26-0.98 eV, along with strong photoluminescence. By implementing a postsynthesis ligand exchange, colloidally stable inks enabling the fabrication of high-quality CQD films are achieved. The first demonstration of InSb CQD photodetectors is presented reaching 75% external quantum efficiency (QE) at 1200 nm, to the knowledge the highest short-wave infrared (SWIR) QE reported among heavy-metal-free infrared CQD-based devices.
RESUMO
Isolating the hydrogen-bonding structure of water immediately at the surface is challenging, even with surface-specific techniques like sum-frequency generation (SFG), because of the presence of aligned water further away in the diffuse layer. Here, we combine zeta potential and SFG intensity measurements with the maximum entropy method referenced to reported phase-sensitive SFG and second-harmonic generation results to deconvolute the SFG spectral contributions of the surface waters from those in the diffuse layer. Deconvolution reveals that at very low ionic strength, the surface water structure is similar to that of a neutral silica surface near the point-of-zero-charge with waters in different hydrogen-bonding environments oriented in opposite directions. This similarity suggests that the known metastability of silica colloids against aggregation under both conditions could arise from this distinct surface water structure. Upon the addition of salt, significant restructuring of water is observed, leading to a net decrease in order at the surface.
RESUMO
The hydrophobicwater interface plays a key role in biological interactions. However, both the hydrophobicwater interfacial molecular structure and the origin of the negative zeta potential of hydrophobic droplets in water are heavily contested. We report polarimetric vibrational sum-frequency scattering of the OD and C-H stretch modes of 200-nanometer hexadecane oil droplets dispersed in water. An unusually broad spectral distribution (2550 to 2750 per centimeter) of interfacial water molecules that were not hydrogen bonded to other water molecules was observed, as well as a blue shift in the vibrational frequency of the interfacial hexadecane C-H stretch modes. Oil and water frequency shifts correlated with the negative electrostatic charge. Molecular dynamics simulations demonstrated that the unexpected strong charge-transfer interactions arose from interfacial CHâââO hydrogen bonds.