Fouling, performance and cost analysis of membrane-based water desalination technologies: A critical review.

While water is a key resource required to sustain life, freshwater sources and aquifers are being depleted at an alarming rate. As a mitigation strategy, saline water desalination is commonly used to supplement the available water resources beyond direct water supply. This is achieved through effective advanced water purification processes enabled to handle complex matrix of saline wastewater. Membrane technology has been extensively evaluated for water desalination. This includes the use of reverse osmosis (RO) (the most mature membrane technology for desalination), pervaporation (PV), electrodialysis (ED), membrane distillation (MD), and membrane crystallization (MCr). Though nanofiltration (NF) is not mainly applied for desalination purposes, it is included in the reviewed processes because of its ability to reach 90% salt rejection efficiency for water softening. However, its comparison with other technologies is not provided since NF cannot be used for removal of NaCl during desalination. Remarkably, membrane processes remain critically affected by several challenges including membrane fouling. Moreover, capital expenditure (CAPEX) and operating expenditure (OPEX) are the key factors influencing the establishment of water desalination processes. Therefore, this paper provides a concise and yet comprehensive review of the membrane processes used to desalt saline water. Furthermore, the successes and failures of each process are critically reviewed. Finally, the CAPEX and OPEX of these water desalination processes are reviewed and compared. Based on the findings of this review, MD is relatively comparable to RO in terms of process performance achieving 99% salt rejections. Also, high salt rejections are reported on ED and PV. The operation and maintenance (O&M) costs remain lower in ED. Notably, the small-scale MD OPEX falls below that of RO. However, the large-scale O&M in MD is rarely reported due to its slow industrial growth, thus making RO the most preferred in the current water desalination markets.

Synthesis and characterization of a molecularly imprinted polymer for the isolation of the 16 US-EPA priority polycyclic aromatic hydrocarbons (PAHs) in solution.

A smart sorbent consisting of benzo[k]fluoranthene-imprinted and indeno[1 2 3-cd]pyrene-imprinted polymers mixed at 1:1 (w/w) was successfully screened from several cavity-tuning experiments and used in the isolation of polycyclic aromatic hydrocarbons from spiked solution. The polymer mixture showed high cross selectivity and affinity towards all the 16 US-EPA priority polycyclic aromatic hydrocarbons. The average extraction efficiency from a cyclohexane solution was 65 ± 13.3% (n = 16, SD). Batch adsorption and kinetic studies confirmed that the binding of polycyclic aromatic hydrocarbons onto the polymer particles resulted in formation of a monolayer and that the binding process was the rate limiting step. The imprinted polymer performance studies confirmed that the synthesized polymer had an imprinting efficiency of 103.9 ± 3.91% (n = 3, SD). A comparison of the theoretical number of cavities and the experimental binding capacity showed that the overall extent of occupation of the imprinted cavities in the presence of excess polycyclic aromatic hydrocarbons was 128 ± 6.45% (n = 3, SD). The loss of selectivity was estimated at 2.9% with every elution cycle indicating that the polymer can be re-used several times with limited loss of selectivity and sensitivity. The polymer combination has shown to be an effective adsorbent that can be used to isolate all the 16 US-EPA priority polycyclic aromatic hydrocarbons in solution.

Zeolitic imidazolate frameworks as effective crystalline supports for aspergillus-based laccase immobilization for the biocatalytic degradation of carbamazepine.

In this study, zeolitic imidazolate frameworks (ZIF) were employed as effective porous supports for laccase enzyme attachment and further explored synergistic adsorption and biocatalytic degradation of carbamazepine (CBZ) in aqueous solutions. Characterization results from FTIR and NMR analysis confirmed successful incorporation of the laccase enzyme onto ZIF particles. Further analyses from SEM and TEM revealed rhombic dodecahedral morphologies of ZIF crystals with crusts of the enzyme observed on the particles' surface. The carbamazepine degradation results showed that immobilization of the laccase improved its stability and resistance at various pH's, in comparison to the free enzyme. The immobilized laccase also exhibited relatively higher activities across the studied temperature range compared to the free form. Kinetic studies revealed a negligible decline in velocity, Vmax after immobilization, evaluated to be 0.873 and 0.692 mg L-1 h-1 for the free and immobilized laccase, respectively. The immobilized laccase demonstrated improved stabilities towards organic solvents, which qualifies the composite's application in real wastewater samples. In which case, the laccase-ZIF composite proved effective in CBZ decontamination with an efficiency of ∼92%. Furthermore, the immobilized laccase exhibited appreciable storage stabilities (∼70% residual activity) for up to 15 days before any significant loss in activity.

Nanoparticle-Enhanced PVDF Flat-Sheet Membranes for Seawater Desalination in Direct Contact Membrane Distillation.

In this study, hydrophobic functionalized carbon nanotubes (fCNTs) and silica nanoparticles (fSiO2NPs) were incorporated into polyvinylidene fluoride (PVDF) flat-sheet membranes to improve their performance in membrane distillation (MD). The performance of the as-synthesized membranes was evaluated against commercial reference polytetrafluoroethylene (PTFE) flat-sheet membranes. The water contact angle (WCA) and liquid entry pressure (LEP) of the PVDF membrane were compromised after incorporation of hydrophilic pore forming polyvinylpyrrolidone (PVP). These parameters were key in ensuring high salt rejections in MD processes. Upon incorporation of fCNTS and fSiO2NPs, WCA and LEP improved to 103.61° and 590 kPa, respectively. Moreover, the NP additives enhanced membrane surface roughness. Thus, an increase in membrane roughness improved WCA and resistance to membrane wetting. High salt rejection (>99%) and stable fluxes (39.77 kg m-2 h-1) were recorded throughout a 3 h process evaluation where 3.5 wt% NaCl solution was used as feed. These findings were recorded at feed temperature of 60 ℃. Evidently, this study substantiated the necessity of high feed temperatures towards high rates of water recovery.

First biomonitoring of microplastic pollution in the Vaal river using Carp fish (Cyprinus carpio) "as a bio-indicator".

Fish inhabiting freshwater environments are susceptible to the ingestion of microplastics (MPs). Knowledge regarding MPs in freshwater fish in South Africa is very limited. In this study, the uptake of MPs by common carp (Cyprinus carpio) in the Vaal River in South Africa was assessed. MPs were detected in all of the twenty-six fish examined, 682 particles of MPs were recovered from the gastrointestinal tracts of the fish with an average of 26.23 ± 12.57 particles/fish, and an average abundance of 41.18 ± 52.81 particles/kg. The examination of the physical properties of MPs revealed a predominance on fibers (69%), small-sized particles of less than 0.5 mm (48%), as well as prevelance of coloured MPs (94%), mostly green, blue, and black. Using Raman Spectroscopy, the following plastic polymers were identified: high density polyethylene (HDPE), low density polyethylene (LDPE), polypropylene (PP), polyethylene terephthalate (PET), and polytetrafluoroethylene (PTFE). To the best of our knowledge, this study, is the first to report MPs uptake by freshwater biota in the Vaal River using common carp as a target organism. It provided evidence of MP contamination in the Vaal.

Multivariate optimization of a two-way technique for extraction of pharmaceuticals in surface water using a combination of membrane assisted solvent extraction and a molecularly imprinted polymer.

This work demonstrates development and evaluation of a two-way technique based on the combination of membrane assisted solvent extraction and a molecularly imprinted polymer (MASE-MIP) for selective and efficient extraction of five selected pharmaceuticals belonging to five different therapeutic classes. The pharmaceuticals were extracted from surface water samples followed by liquid chromatography-quadrupole time-of-flight mass spectrometry (LC-qTOF/MS) determination. A central composite design was applied to optimize the influence of the sample salt content, the stirring rate, the stirring time and the amount of MIP on the extraction of an anticonvulsant (carbamazepine), a cardiac stimulant (etilefrine), a muscle relaxant (methocarbamol), an antiretroviral (nevirapine) and an antidepressant (venlafaxine) from surface water. Optimization of the analytical method was performed by spiking water with a mixture of all five pharmaceuticals at 500 ng mL-1. Optimum extraction conditions for a sample volume of 18 mL were found to be 5 g of salt content, a stirring rate of 400 rpm, an extraction time of 60 min and 50 mg of MIP. The MASE-MIP-LC-qTOF/MS method gave detection and quantification limits ranging from 0.09 to 0.20 ng mL-1 and 0.31-0.69 ng mL-1, respectively. The spiked river water samples yielded recoveries ranging from 38 to 91% for the selected model compounds belonging to the five classes of pharmaceuticals. Upon the application of the developed analytical method in water analysis, all selected pharmaceuticals were detected in South African river water with nevirapine and venlafaxine being more prominent attaining the maximum concentrations of 1.64 and 2.48 ng mL-1, respectively.

Technical design and optimisation of polymer inclusion membranes (PIMs) for sample pre-treatment and passive sampling - A review.

This review reports on the increasing interest in technical designs, calibration, and application of PIM-based devices in sample pre-treatment and passive sampling in environmental water monitoring from 2010 to 2021. With regards to passive sampling, devices are calibrated in a laboratory setup using either a dip-in or flow-through approach before environmental application. In sample preparation, the device set-ups can be offline, online or in a continuous flow separation device connected to a flow injection analysis system. The PIMs have also demonstrated potential in both these offline and online separations; however, there is still a draw-back of low diffusion coefficients obtained in these PIM set-ups. Electro-driven membrane (EME) extraction has demonstrated better performance as well as improved analyte flux. Critical in electro-driven membrane extraction is applying correct voltage that may not compromise the PIM performance due to leaching of components to the aqueous solutions. Further, besides different PIM configurations and designs being developed, PIM based extractions are central to PIM components (base polymer, carrier and plasticizer). As such, recent studies have also focused on improving PIM stability by investigating use of various PIM components, incorporating nano additives into the PIM composition, and investigating novel green PIM synthetic routes. All these aspects are covered in this review. Further, some recent studies that have demonstrated the ability to eliminate effects of flow patterns and membrane biofouling in PIM based applications are also included.

Evaluating the role for renal biopsy in T1 and T2 renal masses: A single-centre study.

INTRODUCTION: Once used primarily in the identification of renal metastasis and lymphomas, various urological bodies are now adopting an expanded role for the renal biopsy. We sought to evaluate the role of the renal biopsy in a Canadian context, focusing on associated adverse events, radiographic burden, and diagnostic accuracy. METHODS: This retrospective review incorporated all patients undergoing ultrasound (US)/computed tomography (CT)-guided biopsies for T1 and T2 renal masses. There were no age or lesion size limitations. The primary outcome of interest was the correlation between initial biopsy and final surgical pathology. A binomial logistic regression analysis was conducted to determine any confounding factors. Secondary outcomes included the accuracy of tumour cell typing, grading, the safety profile, and radiographic burden associated with these patients. RESULTS: A total of 148 patients satisfied inclusion criteria for this study. Mean age and lesions size at detection were 60.9 years (±12.4) and 3.6 cm (±2.0), respectively. Most renal masses were identified with US (52.7%) or CT (44.6%). Three patients (2.0%) experienced adverse events of note. Eighty-six patients (58.1%) proceeded to radical/partial nephrectomy. Our biopsies held a diagnostic accuracy of 90.7% (sensitivity 96.2%, specificity 87.5%, positive predictive value 98.7%, negative predictive value 70.0%, kappa 0.752, p<0.0005). Binomial logistic regression revealed that age, lesion size, number of radiographic tests, time to biopsy, and modality of biopsy (US/CT) had no influence on the diagnostic accuracy of biopsies. CONCLUSIONS: Renal biopsies are safe, feasible, and diagnostic. Their role should be expanded in the routine evaluation of T1 and T2 renal masses.

Sleep disturbances and their association with mental health among women exposed to intimate partner violence.

BACKGROUND: Intimate partner violence puts the victim at risk for substantial medical and psychiatric morbidity. As with other stress- and trauma-related experiences, intimate partner violence is associated with sleep disturbance, particularly insomnia and nightmares. This association, however, has not been well characterized in terms of general prevalence or its further relationship with depression, suicidality, and posttraumatic stress disorder (PTSD). METHODS: The present study used validated instruments to characterize insomnia and nightmares among 121 women exposed to intimate partner violence. Participants with and without depression were compared on demographic, abuse, and sleep characteristics as were those with and without suicidality. Logistic regression models were constructed to test sleep variables as independent predictors of depression controlling for demographic factors, abuse severity, and PTSD severity. RESULTS: Clinically significant insomnia and nightmares were observed in 46% and 32% of participants, respectively. Depressed women had more severe PTSD and were more likely to have insomnia and to have nightmares than nondepressed women. In models controlling for PTSD severity, the presence of insomnia was associated with an approximately eightfold greater risk of being depressed; nightmares were associated with a twofold increase in risk. CONCLUSIONS: Sleep disturbances were prevalent among women experiencing intimate partner violence, with both insomnia and nightmares predicting the presence of depression even after controlling for PTSD severity. In addition to the need to address common mental health issues such as depression, given that sleep problems are modifiable and potentially less stigmatizing than mental health problems, assessing and addressing insomnia and nightmares in survivors of interpersonal violence warrants strong clinical consideration and further investigation.

Predicting dissemination of a disaster mental health "Train-the-Trainer" program.

OBJECTIVE:   Disaster mental health (DMH) is vital to comprehensive disaster preparedness for communities. A train-the-trainer (TTT) model is frequently used in public health to disseminate knowledge and skills to communities, although few studies have examined its success. We report on the development and implementation of a DMH TTT program and examine variables that predict dissemination. METHODS:   This secondary analysis examines 140 community-based mental health providers' participation in a TTT DMH program in 2005-2006. Instructors' dissemination of the training was followed for 12 months. Bivariate and multivariate analyses were conducted to predict dissemination of the training program. RESULTS:   Sixty percent of the trainees in the DMH TTT program conducted training programs in the 12-month period following being trained. The likelihood of conducting training programs was predicted by a self-report measure of perceptions of transfer of training. The number of individuals subsequently trained (559) was predicted by prior DMH training and sex. No other variables predicted dissemination of DMH training. CONCLUSIONS:   The TTT model was moderately successful in disseminating DMH training. Intervention at the organizational and individual level, as well as training modifications, may increase cost-effective dissemination of DMH training.