Compound-Specific Sulfur Isotope Analysis of Petroleum Gases.

We describe a simple, sensitive, and robust method for sulfur isotope ratio (34S/32S) analysis of ppm-level organic sulfur compounds (OSCs) in the presence of percent-level H2S. The method uses a gas chromatograph (GC) coupled with a multicollector inductively coupled plasma mass spectrometer (MC-ICPMS). The GC, equipped with a gas inlet and a valve that transfers the H2S to a thermal conductivity detector (TCD), enables a precise heart cut and prevents the saturation of the MC-ICPMS. The sensitivity and accuracy of the method are better than 0.3‰ for OSCs at a concentration of 25 pmol or 1.4 ppm, and better than 0.5‰ for concentrations ≥0.7 ppm of OSCs. An order of magnitude increase in sensitivity, with no effect on accuracy, can be achieved if the loop volume (0.5 mL) is changed to 5 mL. High concentrations of methane (95% v/v) and/or H2S (20% v/v) had no effect (within 0.5‰) on the precision and accuracy of the gas sample containing 2 ppm of OSCs after heart cut. The applicability and robustness of this method are demonstrated on a gas sample (10% v/v H2S) that was produced by pyrolysis of sulfur-rich kerogen. The results show good precision and reveal sulfur isotope variability between individual OSCs that may represent key processes during formation and degradation of OSCs.

Sulfur isotope homogeneity of oceanic DMSP and DMS.

Oceanic emissions of volatile dimethyl sulfide (DMS) represent the largest natural source of biogenic sulfur to the global atmosphere, where it mediates aerosol dynamics. To constrain the contribution of oceanic DMS to aerosols we established the sulfur isotope ratios ((34)S/(32)S ratio, δ(34)S) of DMS and its precursor, dimethylsulfoniopropionate (DMSP), in a range of marine environments. In view of the low oceanic concentrations of DMS/P, we applied a unique method for the analysis of δ(34)S at the picomole level in individual compounds. Surface water DMSP collected from six different ocean provinces revealed a remarkable consistency in δ(34)S values ranging between +18.9 and +20.3‰. Sulfur isotope composition of DMS analyzed in freshly collected seawater was similar to δ(34)S of DMSP, showing that the in situ fractionation between these species is small (<+1‰). Based on volatilization experiments, emission of DMS to the atmosphere results in a relatively small fractionation (-0.5 ± 0.2‰) compared with the seawater DMS pool. Because δ(34)S values of oceanic DMS closely reflect that of DMSP, we conclude that the homogenous δ(34)S of DMSP at the ocean surface represents the δ(34)S of DMS emitted to the atmosphere, within +1‰. The δ(34)S of oceanic DMS flux to the atmosphere is thus relatively constant and distinct from anthropogenic sources of atmospheric sulfate, thereby enabling estimation of the DMS contribution to aerosols.

A sensitive method for the sulfur isotope analysis of dimethyl sulfide and dimethylsulfoniopropionate in seawater.

RATIONALE: Dimethyl sulfide (DMS) is the major volatile sulfur species emitted to the atmosphere from the oceans. The sulfur isotope ratio ((34)S/(32)S) of DMS may offer a way to calculate the contribution of marine DMS to global sulfur cycling. The S-isotopic analysis of DMS is difficult due to its low concentrations in natural seawater and high chemical reactivity. Here we present a sensitive, precise and accurate method for determining the S-isotopic composition of natural DMS and its precursor, dimethylsulfoniopropionate (DMSP), in seawater. METHODS: The method was based on a purge of DMS from aqueous solutions or natural seawater to a cryogenic trap and subsequent separation of DMS by gas chromatography. The separated DMS was then transferred from the gas chromatograph to a multicollector inductively coupled plasma mass spectrometer (GC/MC-ICPMS system) for measurement of (34)S/(32)S ratios. Correction for mass bias was accomplished using standard-sample bracketing with peaks of SF6 as a reference gas. RESULTS: Results obtained from synthetic DMS and DMSP dissolved in artificial seawater show >98% recovery of DMS and very good precision (0.1 to 0.3‰), accuracy and linearity (0.2‰) for the 26-179 picomoles (pmol) of DMS or DMSP injected. The system was tested with natural seawater from Eilat (Red Sea, Israel) and similar precision and accuracy for both DMS and DMSP were obtained. The δ(34)S values of DMS and DMSP from Eilat seawater were 19.2 ± 0.2‰ and 19.7 ± 0.2‰, respectively. CONCLUSIONS: The coupling of a purge-and-trap system with a GC/MC-ICPMS system was shown to be a sensitive, accurate and robust approach for the S-isotope analysis of nanomolar (nM) concentrations of DMS and DMSP from aqueous solutions and natural seawater.

Sulfur isotopes ratio of atmospheric carbonyl sulfide constrains its sources.

Carbonyl sulfide (COS) is the major long-lived sulfur bearing gas in the atmosphere, and is used to estimate the rates of regional and global (both past and current) photosynthesis. Sulfur isotope measurements (34S/32S ratio, δ34S) of COS may offer a way for improved determinations of atmospheric COS sources. However, measuring the COS δ34S at the atmospheric concentrations of ~0.5 ppb is challenging. Here we present high-accuracy δ34S measurements of atmospheric COS done by gas chromatograph (GC) connected to a multicollector inductively coupled plasma mass spectrometer (MC-ICPMS), after pre-concentrating from 2-liters of air. We showed that the precision of COS δ34S measurement for gas standards is ≤0.2‰, and that N2 and CO2 in the gas standard mixture had no effect on the measured δ34S. Natural air samples were collected in Israel and in the Canary Islands. The COS δ34S values in both locations were found to be 13.2 ± 0.6‰, and are believed to represent the background tropospheric value. This δ34S value is markedly different from the previously reported value of 4.9‰. We estimate the expected isotopic signature of COS sources and sinks, and use the δ34S value of atmospheric COS we measured to estimate that ~48% of it originates from the ocean.

Variability in sulfur isotope composition suggests unique dimethylsulfoniopropionate cycling and microalgae metabolism in Antarctic sea ice.

Sea ice microbial communities produce large amounts of the sulfur metabolite dimethylsulfoniopropionate (DMSP), a precursor of the climate cooling gas dimethylsulfide. Despite their importance to the polar sulfur cycle, drivers and metabolic pathways of sea ice DMSP are uncertain. Here we report the first measurements of sea ice DMSP sulfur isotopic composition (34S/32S ratio, δ34S). δ34S values in ice cores from the Ross Sea and Weddell Sea reveal considerable variability across seasons and between ice horizons (from +10.6 to +23.6‰). We discuss how the most extreme δ34S values observed could be related to unique DMSP cycling in the seasonally extreme physiochemical conditions of isolated brine inclusions in winter-spring. Using cell cultures, we show that part of the DMSP δ34S variability could be explained by distinct DMSP metabolism in sea ice microalgae. These findings advance our understanding of the sea ice sulfur cycle and metabolic adaptations of microbes in extreme environments.