Vulnerability to shear stress caused by altered peri-endothelial matrix is a key feature of Moyamoya disease.

Moyamoya disease (MMD) is characterized by progressive bilateral stenotic changes in the terminal portion of the internal carotid arteries. Although RNF213 was identified as a susceptibility gene for MMD, the exact pathogenesis remains unknown. Immunohistochemical analysis of autopsy specimens from a patient with MMD revealed marked accumulation of hyaluronan and chondroitin sulfate (CS) in the thickened intima of occlusive lesions of MMD. Hyaluronan synthase 2 was strongly expressed in endothelial progenitor cells in the thickened intima. Furthermore, MMD lesions showed minimal staining for CS and hyaluronan in the endothelium, in contrast to control endothelium showing positive staining for both. Glycosaminoglycans of endothelial cells derived from MMD and control induced pluripotent stem cells demonstrated a decreased amount of CS, especially sulfated CS, in MMD. A computational fluid dynamics model showed highest wall shear stress values in the terminal portion of the internal carotid artery, which is the predisposing region in MMD. Because the peri-endothelial extracellular matrix plays an important role in protection, cell adhesion and migration, an altered peri-endothelial matrix in MMD may contribute to endothelial vulnerability to wall shear stress. Invading endothelial progenitor cells repairing endothelial injury would produce excessive hyaluronan and CS in the intima, and cause vascular stenosis.

Two Diverse Hemodynamic Forces, a Mechanical Stretch and a High Wall Shear Stress, Determine Intracranial Aneurysm Formation.

Intracranial aneurysm (IA) usually induced at a bifurcation site of intracranial arteries causes a lethal subarachnoid hemorrhage. Currently, IA is considered as a macrophage-mediated inflammatory disease triggered by a high wall shear stress (WSS) on endothelial cells. However, considered the fact that a high WSS can be observed at every bifurcation site, some other factors are required to develop IAs. We therefore aimed to clarify mechanisms underlying the initiation of IAs using a rat model. We found the transient outward bulging and excessive mechanical stretch at a prospective site of IA formation. Fibroblasts at the adventitia of IA walls were activated and produced (C-C motif) ligand 2 (CCL2) as well in endothelial cells loaded on high WSS at the earliest stage. Consistently, the mechanical stretch induced production of CCL2 in primary culture of fibroblasts and promoted migration of macrophages in a Transwell system. Our results suggest that distinct hemodynamic forces, mechanical stretch on fibroblasts and high WSS on endothelial cells, regulate macrophage-mediated IA formation.

In vitro measurement of platelet adhesion to intact endothelial cells under low shear conditions.

BACKGROUND: Prediction of thrombus formation at intact arterial walls under low shear flow conditions is clinically important particularly for better prognoses of embolisation in cerebral aneurysms. Although a new mathematical model for this purpose is necessary, little quantitative information has been known about platelet adhesion to intact endothelial cells. OBJECTIVE: The objective of this study is to measure the number of platelets adhering to intact endothelial cells with a focus upon the influence of the shear rate. METHODS: Endothelial cells disseminated in µ-slides were exposed to swine whole blood at different shear rates. Adenosine diphosphate (ADP) was used as an agonist. Adherent platelets were counted by means of scanning electron microscopy. RESULTS: At an ADP concentration of 1 µM, 20.8 ± 3.1 platelets per 900 µm2 were observed after 30-minute perfusion at a shear rate of 0.8 s-1 whereas only 3.0 ± 1.4 per 900 µm2 at 16.8 s-1. CONCLUSIONS: The number of adherent platelets is determined by a balance between the shear and the degree of stimulation by the agonist. At an ADP concentration of 1 µM, a limit to the shear rate at which platelets can adhere to intact endothelial cells is considered to be slightly higher than 16.8 s-1.