RESUMO
The spin polarization of Pt in Pt/NiFe2O4 and Pt/Fe bilayers is studied by interface-sensitive x-ray resonant magnetic reflectivity to investigate static magnetic proximity effects. The asymmetry ratio of the reflectivity is measured at the Pt L3 absorption edge using circular polarized x-rays for opposite directions of the magnetization at room temperature. The results of the 2% asymmetry ratio for Pt/Fe bilayers are independent of the Pt thickness between 1.8 and 20 nm. By comparison with ab initio calculations, the maximum magnetic moment per spin polarized Pt atom at the interface is determined to be (0.6±0.1) µB for Pt/Fe. For Pt/NiFe2O4 the asymmetry ratio drops below the sensitivity limit of 0.02 µB per Pt atom. Therefore, we conclude, that the longitudinal spin Seebeck effect recently observed in Pt/NiFe2O4 is not influenced by a proximity induced anomalous Nernst effect.
RESUMO
In this work the structural and morphological changes of Ce1-xPrxO2-δ (x = 0.20, 0.35 and 0.75) films grown on Si(111) due to post deposition annealing are investigated by low energy electron diffraction combined with a spot profile analysis. The surface of the oxide films exhibit mosaics with large terraces separated by monoatomic steps. It is shown that the Ce/Pr ratio and post deposition annealing temperature can be used to tune the mosaic spread, terrace size and step height of the grains. The morphological changes are accompanied by a phase transition from a fluorite type lattice to a bixbyite structure. Furthermore, at high PDA temperatures a silicate formation via a polycrystalline intermediate state is observed.
RESUMO
The structural changes of a (111) oriented CeO2 film grown on a Si(111) substrate covered with a hex-Pr2O3(0001) interface layer due to post deposition annealing are investigated. X-ray photoelectron spectroscopy measurements revealing the near surface stoichiometry show that the film reduces continuously upon extended heat treatment. The film is not homogeneously reduced since several coexisting crystalline ceria phases are stabilized due to subsequent annealing at different temperatures as revealed by high resolution low energy electron diffraction and X-ray diffraction. The electron diffraction measurements show that after annealing at 660 °C the ι-phase (Ce7O12) is formed at the surface which exhibits a (â7 × â7)R19.1° structure. Furthermore, a (â27 × â27)R30° surface structure with a stoichiometry close to Ce2O3 is stabilized after annealing at 860 °C which cannot be attributed to any bulk phase of ceria stable at room temperature. In addition, it is shown that the fully reduced ceria (Ce2O3) film exhibits a bixbyite structure. Polycrystalline silicate (CeSi(x)O(y)) and crystalline silicide (CeSi1.67) are formed at 850 °C and detected at the surface after annealing above 900 °C.
RESUMO
A cold radio frequency oxygen plasma treatment is demonstrated as a successful route to prepare clean, well-ordered, and stoichiometric PrO(2) layers on silicon. High structural quality of these layers is shown by x-ray diffraction. So far unobserved spectral characteristics in Pr 3d x-ray photoelectron (XP) spectra of PrO(2) are presented as a fingerprint for praseodymia in its highest oxidized state. They provide insight in the electronic ground state and the special role of praseodymia among the rare earth oxides. They also reveal that former XP studies suffered from a significant reduction at the surface.
RESUMO
Ultra thin heteroepitaxial PrO(2) films on Si(111) were annealed under UHV conditions and investigated by x-ray diffraction (XRD), x-ray reflectometry (XRR) and spot profile analysis low energy electron diffraction (SPALEED) with regard to structural stability and phase transitions due to the high oxygen mobility of the oxide. This gives information about the manageability of the material and its application as a model catalyst system in surface science. While the samples are stable in UHV at room temperature, annealing at 300 °C exhibits a terminated phase transition from PrO(2) and PrO(2-Δ) to cub-Pr(2)O(3) with an increase in the silicate at the interface and a decrease in the crystalline praseodymia layer mainly due to atomic diffusion of silicon into the oxide film. Strain effects during the phase transition also cause mosaic formation at the surface. Further annealing up to 600 °C shows only little change in the film structure. This will finally lead to a model of the film structure during the annealing process.
RESUMO
Motivated by the complex diffraction pattern observed for bundled rare-earth silicide nanowires on the Si(0 0 1) surface, we investigate the influence of the width and the spacing distribution of the nanowires on the diffraction pattern. The diffraction pattern of the bundled rare-earth silicide nanowires is analyzed by the binary surface technique applying a kinematic approach to diffraction. Assuming a categorical distribution for the (individual) nanowire size and a Poisson distribution for the size of the spacing between adjacent nanowire-bundles, we are able to determine the parameters of these distributions and derive an expression for the distribution of the nanowire-bundle size. Additionally, the comparison of our simulations to the experimental diffraction pattern reveal that a (1 × 1)-periodicity on top of the nanowires has to be assumed for a good match.
RESUMO
Iron oxide monolayers are grown on Ag(0 0 1) via reactive molecular beam epitaxy (metal deposition in oxygen atmosphere). The monolayer shows FeO stoichiometry as concluded from x-ray photoemission spectra. Both low energy electron diffraction as well as scanning tunneling microscopy demonstrate that the FeO layer has a quasi-hexagonal (1 1 1) structure although deposited on a surface with square symmetry. Compared to bulk values, the FeO(1 1 1) monolayer is unidirectionally expanded by 3.4% in [Formula: see text] directions while bulk values are maintained in [Formula: see text] directions. In [Formula: see text] directions, this lattice mismatch between FeO(1 1 1) monolayer and Ag(0 0 1) causes a commensurate undulation of the FeO monolayer where 18 atomic rows of the FeO(1 1 1) monolayer match 17 atomic rows of the Ag(0 0 1) substrate. In [Formula: see text] directions, however, the FeO(1 1 1) monolayer has an incommensurate structure.
RESUMO
Thin heteroepitaxial praseodymia films with fluorite structure on Si(111) were annealed under ultra-high vacuum conditions at temperatures in the region of 100 up to 300 °C. Afterward investigations by x-ray diffraction, grazing incidence x-ray diffraction and x-ray reflectometry were performed to obtain information about structural changes of the film during the annealing process. For this reason, praseodymia Bragg peaks were carefully analyzed within the kinematic diffraction theory. This analysis demonstrates the coexistence of different praseodymia phases depending on the conditions of preparation. Here, annealing of the samples up to 150 °C leads to a homogeneous film with a PrO(1.833) phase and with negligible strain since both the lateral and vertical lattice parameters nearly match the corresponding bulk praseodymia phase. Further annealing leads to oxygen loss accompanied by significantly increased lattice parameters. Since the lateral lattice parameter is pinned at the interface, the vertical lattice constant has to increase considerably due to the tetragonal distortion of the film. This causes the decomposition of the film into two oxide species with significantly different oxygen contents. Annealing at 300 °C reduces the film almost completely to PrO(1.5) which has the minimum content of oxygen.