Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 4 de 4
Filtrar
Mais filtros

Base de dados
Tipo de documento
País de afiliação
Intervalo de ano de publicação
1.
Sichuan Da Xue Xue Bao Yi Xue Ban ; 51(5): 611-617, 2020 Sep.
Artigo em Zh | MEDLINE | ID: mdl-32975073

RESUMO

OBJECTIVE: To study the effect and mechanism of modified constraint-induced movement therapy (mCIMT) on motor function recovery in cerebral ischemia-reperfusion rats. METHODS: The rats were randomly divided into the control group and the mCIMT group, with 12 rats in each group. The left middle cerebral artery occlusion (MCAO) model was established by the Longa suture method. In the mCIMT group, the rats started continuous training for 14 d on the 7 th day after modeling. The unaffected limb was tied to the chest with elastic bandages, and the affected limb was trained in the compulsory runner equipment. In the control group, rats moved freely in the cage. The body mass of rats was recorded within 20 d after modeling, and behavior was assessed by the foot-fault test. Some of the rats were euthanized 18 d after modeling, and high performance liquid chromatography (HPLC) was used to detect monoamine neurotransmitters (5-hydroxytryptamine (5-HT), 5-hydroxyindoleacetic acid (5-HIVV), homovanillic acid (HVA) ), and amino acid neurotransmitters (glutamic acid (Glu), asparaginic acid (ASP), glutamine (Gln), glycine (Gly), taurine (Tau), gamma aminobutyric acid (GABA) ) in the motor cortex and striatum, respectively. Enzyme-linked immunosorbent assay (ELISA) was used to detect the expression levels of total P70 ribosomal protein S6 kinase (p70s6k) and p70s6k phosphorylated protein (p-p70s6k) in motor cortex and striatum, respectively. RESULTS: Compared with the control group, the body mass of rats in the mCIMT group was comparable (P >0.05) within 21 d after modeling, foot-fault rate of the mCIMT group was significantly lower at 17 d after modeling (P<0.05). At 18 d after modeling, compared with the control group, the level of 5-HIVV in the motor cortex increased significantly (P<0.05), and the relative content of amino acid neurotransmitters (the ratio of Glu) in the motor cortex including Gln, Gly, Tau and GABA to Glu increased significantly (P<0.05 or P<0.01) except for decreased ASP/Glu (P<0.05). Moreover, compared with the control group, the expression of p-p70s6k in the motor cortex of the mCIMT was significantly decreased (P<0.05). There were no significant differences in monoamine neurotransmitters and amino acid neurotransmitters in the striatum between two groups (P>0.05). CONCLUSION: mCIMT improved the motor function of MCAO rats, and the mechanism might be related to the increase of amino acid neurotransmitters and 5-HIVV and decrease of p-p70s6k expression in the motor cortex.


Assuntos
Isquemia Encefálica , Córtex Cerebral , Terapia por Exercício , Córtex Motor , Traumatismo por Reperfusão , Animais , Isquemia Encefálica/terapia , Córtex Cerebral/metabolismo , Movimento , Neurotransmissores , Ratos , Ratos Sprague-Dawley , Reperfusão
2.
Guang Pu Xue Yu Guang Pu Fen Xi ; 34(11): 2961-7, 2014 Nov.
Artigo em Inglês | MEDLINE | ID: mdl-25752039

RESUMO

There are many hydrogen bonds in coal, which affect the chemical structure and properties of coal. FTIR has been applied to the characterization study of the hydrogen bonds of Dongpang coals, which were under drop weight impact. There exists five kinds of hydrogen bonds in the coal: free OH groups, OH...π, OH...OH, cyclic OH tetramers and OH...N. Absorption strength of intermolecular hydrogen bonds markedly declined after impact. Free OH groups mechanical-power chemical reacted in drop weight impact testing. The infrared spectrum were curve-resolved into their component bands. The absorption strength of various hydrogen bonds decreased with the increase of impact energy, but the trend was slowing. By statistical relationship between then, we find then complying with power function relationship. By comparing the exponents of fitted equations, we concluded that failure sensitivity sequence of hydrogen bonds to the impact: free OH groups > cyclic OH tetramers > OH...N > OH...π > OH...OH.

3.
Sci Rep ; 14(1): 20597, 2024 Sep 04.
Artigo em Inglês | MEDLINE | ID: mdl-39232031

RESUMO

The objective of this study is to investigate the dynamic mechanical properties of coal and rock under deep water conditions. The research employs an enhanced Split Hopkinson Pressure Bar (SHPB) testing system. Five sets of dynamic impact experiments were conducted on coal samples under varying loading conditions to analyse the changes in dynamic strength, energy dissipation, fractal dimension and other characteristics of coal samples under different water content states were analyzed. The experimental results demonstrate that: (1) Under specific strain rate conditions, the dynamic strength of saturated coal samples is lower than that of natural coal samples. As the strain rate gradually increases, the bonding force generated by free water and the Stefan effect jointly act, and the peak strength of saturated coal samples under high strain rate loading conditions is higher than that of natural coal samples. (2) Under certain strain rate conditions, the absorption energy of saturated coal samples is approximately 10% to30% lower than that of natural coal samples, and deformation hysteresis phenomenon occurs in natural coal samples, thereby improving the dynamic strength of natural coal samples relative to saturated coal samples; (3) The fractal dimension of saturated coal samples with a specific strain rate under three-dimensional dynamic static combination loading is higher than that of natural coal samples, and the percentage of small particle coal samples with debris is higher than that of natural coal samples; Finally, based on the HJC model, some coal samples were selected to simulate the coal rock failure characteristics during the triaxial loading process using ANSYS/LS-DYNA, and their stress-strain curves and failure morphology diagrams were obtained. The discrepancy between the numerical simulation and the experimental results was less than 10%, thereby further elucidating and corroborating the coal failure process and dynamic mechanical characteristics.

4.
ACS Omega ; 7(25): 21845-21859, 2022 Jun 28.
Artigo em Inglês | MEDLINE | ID: mdl-35785322

RESUMO

Exploring the flame propagation law in the process of gas explosion under different bifurcation angles is of great significance to the design of coal mine roadway and the prevention of gas explosion accidents. To study the variation of flame propagation law with bifurcation angle, an in-house experimental system based on a small scale three-way bifurcated pipe was developed to perform gas explosion experiments using mixtures of premixed methane-air with a methane concentration of 9.5%. Numerical simulations were conducted to study the propagation of the explosion flame. The results show that, (i) during the flame propagation process, the flame morphology evolves in the following manner: hemispherical, concave entrainment-deformation-flattening; (ii) in the case of gas explosion of three-way bifurcated pipes, there are significant differences in damage at different positions, and the damage at the pipe connection is the most serious. (iii) Although the parameters of the explosion flame in the bifurcated pipe exhibit similar trends across four different bifurcation angles, the values of the flame parameters obtained by the experiments and numerical simulations were not completely consistent. (iv) When the bifurcation angle is between the 45 and 75° bifurcation range, the area of the turbulent vortex formed by the air flow increases as the angle of the pipe widens. The research results analyze the propagation law of gas deflagration flame in the bifurcated pipeline, providing reference for the propagation mechanism of gas deflagration in underground bifurcated roadway and the formulation of prevention measures, which is conducive to preventing the propagation of gas explosion, reducing the intensity, and reducing the loss caused by gas explosion. However, large-scale tests are needed to determine the applicability of small-scale tests and calculations in this paper to full-scale mine conditions.

SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA