Ba5{V,Nb}12Sb19+x, novel variants of the Ba5Ti12Sb19+x-type: crystal structure and physical properties.

The novel compounds Ba5{V,Nb}12Sb19+x, initially found in diffusion zone experiments between Ba-filled skutterudite Ba0.3Co4Sb12 and group V transition metals (V,Nb,Ta), were synthesized via solid state reaction and were characterized by means of X-ray (single crystal and powder) diffraction, electron probe microanalysis (EPMA), and physical (transport and mechanical) properties measurements. Ba5V12Sb19.41 (a = 1.21230(1) nm, space group P4[combining overline]3m; RF(2) = 0.0189) and Ba5Nb12Sb19.14 (a = 1.24979(2) nm, space group P4[combining overline]3m; RF(2) = 0.0219) are the first representatives of the Ba5Ti12Sb19+x-type, however, in contrast to the aristotype, the structure of Ba5V12Sb19.41 shows additional atom disorder. Temperature dependent ADPs and specific heat of Ba5V12Sb19.41 confirmed the rattling behaviour of Ba1,2 and Sb7 atoms within the framework built by V and Sb atoms. Electrical resistivity of both compounds show an upturn at low temperature, and a change from p- to n-type conductivity above 300 K in Ba4.9Nb12Sb19.4. As expected from the complex crystal structure and the presence of defects and disorder, the thermal conductivity is suppressed and lattice thermal conductivity of ∼0.43 W m(-1) K(-1) is near values typical for amorphous systems. Vicker's hardness of (3.8 ± 0.1) GPa (vanadium compound) and (3.5 ± 0.2) GPa (niobium compound) are comparable to Sb-based filled skutterudites. However, the Young's moduli measured by nanoindentation for these compounds EI(Ba4.9V12Sb19.0) = (85 ± 2) GPa and EI(Ba4.9Nb12Sb19.4) = (79 ± 5) GPa are significantly smaller than those of skutterudites, which range from about 130 to 145 GPa.

The half Heusler system Ti1+xFe1.33-xSb-TiCoSb with Sb/Sn substitution: phase relations, crystal structures and thermoelectric properties.

Investigations of phase relations in the ternary system Ti-Fe-Sb show that the single-phase region of the Heusler phase is significantly shifted from stoichiometric TiFeSb (reported previously in the literature) to the Fe-rich composition TiFe1.33Sb. This compound also exhibits Fe/Ti substitution according to Ti1+xFe1.33-xSb (-0.17 ≤ x ≤ 0.25 at 800 °C). Its stability, crystal symmetry and site preference were established by using X-ray powder techniques and were backed by DFT calculations. The ab initio modeling revealed TiFe1.375Sb to be the most stable composition and established the mechanisms behind Fe/Ti substitution for the region Ti1+xFe1.33-xSb, and of the Fe/Co substitution within the isopleth TiFe1.33Sb-TiCoSb. The calculated residual resistivity of Ti1+xFe1.33-xSb, as well as of the isopleths TiFe1.33Sb-TiCoSb, TiFe0.665Co0.5Sb-TiCoSb0.75Sn0.25 and TiFe0.33Co0.75Sb-TiCoSb0.75Sn0.25, are in a good correlation with the experimental data. From magnetic measurements and 57Fe Mössbauer spectrometry, a paramagnetic behavior down to 4.2 K was observed for TiFe1.33Sb, with a paramagnetic Curie-Weiss temperature of -8 K and an effective moment of 1.11µB per Fe. Thermoelectric (TE) properties were obtained for the four isopleths Ti1+xFe1.33-xSb, TiFe1.33Sb-TiCoSb, TiFe0.665Co0.5Sb-TiCoSb0.75Sn0.25 and TiFe0.29Co0.78Sb-TiCoSb0.75Sn0.25 by measurements of electrical resistivity (ρ), Seebeck coefficient (S) and thermal conductivity (λ) at temperatures from 300 K to 823 K allowing the calculation of the dimensionless figure of merit (ZT). Although p-type Ti1+xFe1.33-xSb indicates a semi-conducting behavior for the Fe rich composition (x = -0.133), the conductivity changes to a metallic type with increasing Ti content. The highest ZT = 0.3 at 800 K was found for the composition TiFe1.33Sb. The TE performance also increases with Fe/Co substitution and reaches ZT = 0.42 for TiCo0.5Fe0.665Sb. No further increase of the TE performance was observed for the Sb/Sn substituted compounds within the sections TiFe0.665Co0.5Sb-TiCoSb0.75Sn0.25 and TiFe0.33Co0.75Sb-TiCoSb0.75Sn0.25. However, ZT-values could be enhanced by about 12% via the optimization of the preparation route (ball-mill conditions and heat treatments).

Mechanical properties of non-centrosymmetric CePt3Si and CePt3B.

Elastic moduli, hardness (both at room temperature) and thermal expansion (4.2-670 K) have been experimentally determined for polycrystalline CePt3Si and its prototype compound CePt3B as well as for single-crystalline CePt3Si. Resonant ultrasound spectroscopy was used to determine elastic properties (Young's modulus E and Poisson's ratio ν) via the eigenfrequencies of the sample and the knowledge of sample mass and dimensions. Bulk and shear moduli were calculated from E and ν, and the respective Debye temperatures were derived. In addition, ab initio DFT calculations were carried out for both compounds. A comparison of parameters evaluated from DFT with those of experiments revealed, in general, satisfactory agreement. Positive and negative thermal expansion values obtained from CePt3Si single crystal data are fairly well explained in terms of the crystalline electric field model, using CEF parameters derived recently from inelastic neutron scattering. DFT calculations, in addition, demonstrate that the atomic vibrations keep almost unaffected by the antisymmetric spin-orbit coupling present in systems with crystal structures having no inversion symmetry. This is opposite to electronic properties, where the antisymmetric spin-orbit interaction has shown to distinctly influence features like the superconducting condensate of CePt3Si.

Ba-filled Ni-Sb-Sn based skutterudites with anomalously high lattice thermal conductivity.

Novel filled skutterudites BayNi4Sb12-xSnx (ymax = 0.93) have been prepared by arc melting followed by annealing at 250, 350 and 450 °C up to 30 days in vacuum-sealed quartz vials. Extension of the homogeneity region, solidus temperatures and structural investigations were performed for the skutterudite phase in the ternary Ni-Sn-Sb and in the quaternary Ba-Ni-Sb-Sn systems. Phase equilibria in the Ni-Sn-Sb system at 450 °C were established by means of Electron Probe Microanalysis (EPMA) and X-ray Powder Diffraction (XPD). With rather small cages Ni4(Sb,Sn)12, the Ba-Ni-Sn-Sb skutterudite system is perfectly suited to study the influence of filler atoms on the phonon thermal conductivity. Single-phase samples with the composition Ni4Sb8.2Sn3.8, Ba0.42Ni4Sb8.2Sn3.8 and Ba0.92Ni4Sb6.7Sn5.3 were used to measure their physical properties, i.e. temperature dependent electrical resistivity, Seebeck coefficient and thermal conductivity. The resistivity data demonstrate a crossover from metallic to semiconducting behaviour. The corresponding gap width was extracted from the maxima in the Seebeck coefficient data as a function of temperature. Single crystal X-ray structure analyses at 100, 200 and 300 K revealed the thermal expansion coefficients as well as Einstein and Debye temperatures for Ba0.73Ni4Sb8.1Sn3.9 and Ba0.95Ni4Sb6.1Sn5.9. These data were in accordance with the Debye temperatures obtained from the specific heat (4.4 K < T < 140 K) and Mössbauer spectroscopy (10 K < T < 290 K). Rather small atom displacement parameters for the Ba filler atoms indicate a severe reduction in the "rattling behaviour" consistent with the high levels of lattice thermal conductivity. The elastic moduli, collected from Resonant Ultrasonic Spectroscopy ranged from 100 GPa for Ni4Sb8.2Sn3.8 to 116 GPa for Ba0.92Ni4Sb6.7Sn5.3. The thermal expansion coefficients were 11.8 × 10(-6) K(-1) for Ni4Sb8.2Sn3.8 and 13.8 × 10(-6) K(-1) for Ba0.92Ni4Sb6.7Sn5.3. The room temperature Vickers hardness values vary within the range from 2.6 GPa to 4.7 GPa. Severe plastic deformation via high-pressure torsion was used to introduce nanostructuring; however, the physical properties before and after HPT showed no significant effect on the materials thermoelectric behaviour.